Answered: A 10-ohm resistor is connected in…

A 10-ohm resistor is connected in series with a 0.10 H inductor and a 100-μF capacitor across a 100-V dc source. Determine the natural frequency of oscillators of the current.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Explain why it is important that the stimulus signals in a testbench be synchronized to the inactive…

A: The stimulus signals in a testbench to be synchronized to the inactive edge of the clock of the…

Q: Let - - 1≤x≤2 _{ (x − 1) + (x − 1)² + 2(x - 1)³ S(x) = = 15+3(x-2)(x - 2)²-(x-2)³ 2≤x≤3 S is a cubic…

A: The Given is cubic spline function f Sx=x-1+bx-12+2x-131≤x≤25+3x-2-x-22-x-232≤x≤3

Q: write and explain the main component used in overhead transmission lines.

A: Overhead transmission lines are used to feed the bulk amount of electricity energy from generating…

Q: condary voltage and the output and power factor of each transformer. Test data Open circuit:…

A: SOLUTION- Load : 750 A, 0.8 pf lag IL=750∠-36.86°A A. V=200 V I = 200400=0.5 PA=15KW =…

Q: 1. Which of these is incorrect for an operational amplifier? a) It has a high voltage gain b) It is…

A: The solution is provided in the following section.

Q: mounting and positioning of switch board khn h?

A: Electricity is safely distributed throughout commercial and industrial buildings using switchboards.…

Q: The Maxwell-Boltzmann distnbutlOn function  

A: Solution- Given, fE=e-E-Ef/KTDcE = AE-Ec1/2 a) Carrier distribution taken as f(E) in conduction…

Q: Determine the equivalent frequency domain impedance, Z for the circuit shown in Figure Q2(a). Ζ Μ ΖΩ…

Q: Find the number of resistance sections and the resistance of each section of a starter for a 3.7 kW,…

Q: Has anyone taken and or has any pointers on taking the industrial electricity NOCTI # 2050.

A: As per the NOCTI Job ready credential blueprint version:01, following points can be followed.…

Q: Write 8051 program to receive bytes of data serially and put them in P1, Set the baud rate as 9600,…

Q: Design a clamper to perform the function indicated Vi 20 V -20 V + Ideal diodes Design 0 Vo +16 V -…

Q: 10. a) A1: c) A3: + 12V 아 11. a) A1: c) V2: c) RT: 최다 + 12V A1 A3 A1 R1=32 ww M R2=3Q V1 10 302 b)…

A: Note current flowing in series circuit remain same but voltage varies based on a circuit element…

Q: A 250 V d.c. shunt motor has a shunt field resistance of 200 S2 ohm and an armature resistance of…

Q: The maximum amplitude for a 1 kHz sinusoidal input for a DM system that prevents stope overload that…

A: Given, Modulated frequency, fm=1 kHz DM system that prevents stope overload that has been sampled, n…

Q: Write specifications details of all types of wiring/ cables

A: Electrical wiring A method of connecting different accessories for electrical energy distribution…

Q: In a 8 bit microprocessor, estimate the number of distinct opcodes present.

A: The detailed calculation along with the explanation is provided in the following section.

Q: 7. Two single-phase transformers work in parallel on a load of 750 A at 0.8 p.f. lagging. Determine…

Q: write down the slection of wiring accessories used in electrical installation

Q: A capacitor in an LC oscillator has a maximum potential difference of 15V and a maximum energy of…

Q: Two charges Q₁ = 2 µC and Q₂ = −3 μC are 4 m apart, as shown in the figure below. Point P is a…

Q: 5. Find x[n] for each DTFT given below: (a) Xa(w) = 1+e¯jw3 (b) Xa(w) = e-jw1.5, (c) Xa(w) = cos²…

Q: + 20 V – 20 V + τό 10 ΚΩ SV 1 ΚΩ • 2.2 ΚΩ 7V· + • 2.2 kΩ

A: please refer the attached images for the complete answer...

Q: enumerate at least 3 uses of coils/inductors.

A: The objective is to determine the use of coil and inductor.

Q: circuit. Use the nodal analysis to find the branch current i₁, and node voltages, v₁, and v₂ in the…

A: The required parameters can be calculated by applying kirchhoff's current law to the circuit.

Q: What would be the maximum cost of a CFL such that the total cost (investment plus operating) would…

A: Given data, The power P is 60W, The time 1000 hour, The cost of incandescent bulb is 25 cents

Q: Consider a causal and stable continuous time filter that has a system function- Ha(s) (s+1)/(s+2)²…

A: Impulse Invariance Technique: In this technique, the sampling frequency time period provides the…

Q: explain why Transformers are necessary in all stages of power distribution systems. Three-phase…

A: Given: Transformer

Q: Which one of the following rectangular values is equivalent to the polar form 20 / 55⁰? 16.38 +j…

A: Given: Value in polar for, R∠θ=20∠55°

Q: 3. In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance…

A: The correct option along with the explanation is provided in the following section.

Q: 2.11 Given x(t) as drawn in the figure, sketch and label each of the following signals: ~ -1 (a)…

A: Note: As per the policy we can solve only 3 sub-parts, please re-upload the remaining part as a…

Q: Calculate the current in the 5 resistor for the circuit shown below by source conversion technique.…

A: When modifying complicated circuits, source transformation techniques are employed to convert…

Q: Suppose s(t) is an angle modulated signal with message signal m(t), peak frequency deviation Af =…

Q: For the two-port network below, calculate the value V₂, given 1₁ = 0.052 A and 12 = 0.005 A. 1₂ I₁…

A: Given, A two port network, I1=0.052 AI2=0.005 A

Q: 5. What should be the value of the input voltage applied to a non-inverting amplifier to produce an…

A: Given: In a non-inverting amplifier V0=5 VRf=5000 ΩRin=2000 Ω

Q: (a) List the octal and hexadecimal numbers from 1410 to 3210. Using A and B for the last two digits,…

A: It is given that: (14)10 to (32)10 (8)10 to (28)10

Q: Convert the signed-magnitude binary number N=01100 to a negative value having the same magnitude.

A: Conversion of a positive number to a negative number of same magnitude: One approach is to…

Q: Calculate the output voltage.

Q: 4.a) RT: 5. a) RT: 10587.45 10000000 R2-10μ0 micro 12V 6. a) RT: 마 * R2=0.02KD 20 200020020…

Q: Given: VCC = 20V RB = 390KΩ RC = 2.2KΩ RE = 1.2KΩ Beta = 80 rO = ∞ Calculate: a) re b) Zic) Z0d) AV…

A: The required parameters can be calculated by using the DC and AC analysis of the amplifier circuit.

Q: A toroid of rectangular cross section has height h-0.0137 m, inner radius ry 0.0231 m and outer…

A: Given data : A toroid of rectangular cross section has height h=0.0137m Inner radius r1=0.0231m…

Q: 8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical…

A: Given, A 3-phase induction motor has Slip, s=2%=0.02 Input power, Pin=1000 W

Q: Table 3: Summing Amplifier Measurements c component) ac component) (de component) Table 4: Summing…

A: The Superposition theorem states that, for any linear system, the voltage or current in any branch…

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A: Given data, The block diagram is

Q: 3. In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance…

A: The input resistance of an ideal op amp is infinite so input of the op amp is open terminal so no…

Q: An unbalance delta connected three phase load shown in the figure is supplied by a balanced three…

A: Note Resistance absorb active power only , it does not take any reactive power Capacitance and…

Q: describe how TDM works?

A: Antenna- An antenna is a structure made up of metal which captures or transmits radio…

Q: A typical discounted price of a AAA battery is $0.75. It is designed to provide 1.5 volts and 1.0…

A: The cost of the AAA battery is $0.75 for 1.5 Watt-hours of energy. For 1 kWh of energy, the cost…

Q: 7. A stepper motor with three phases and one pole pair. Calculate the resolution of the motor and…

A: Given a stepper motor with 3 phase and 1 pole pair, so Number of stator stacks, Ns=2×3=6 Number of…

Q: (a) Determine the equivalent frequency domain impedance, Z for the circuit shown in Figure Q2(a). Z…

Question

Answer the given problem

A 10-ohm resistor is connected in series with a 0.10 H inductor and a 100-μF capacitor across a 100-V dc
source. Determine the natural frequency of oscillators of the current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
Which of the following is not a requirement for an electric circuit? a. a source b. a path c. a load d. a signal light
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the capacitor, EC, is 104 V; and the circuit has a total impedance, Z, of 20 . The frequency of the AC voltage is 60 Hz. Find the missing values. ET ER78V EC104V IT IR IC Z20 R XC VA P VARSC PF C
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
Design a charge amplifier for a piezoelectric sensor that has a capacitance of 500 pF. It must pass frequencies from 0.05 to 100 Hz so that it can detect carotid pulses and it must not fall into saturation.