A 10 ohms and a 20 ohms resistance are connected in parallel and a 5 ohms is connected in series with the two. If the supply voltage is 48V, find the current in the 10 ohms resistance.

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given, Ammeter reading, I=6.25 A Voltmeter reading, V=36.5 V

Q: A 50 KVA transformer has a core loss of 500W and full-load copper loss of 900 W. The load at which…

A:

Q: SUL A SW2 B 1 2 7486N 3 C Logic function: L1 Record the state in the appropriate space in the Table.…

A:

Q: 10. both inputs of a NAND LATCH are low, then the S input goes HIGH . shortly thereafter, the R…

A:

Q: Problem 10. For the double-beam oscilloscope dis- plays shown in Figure 10.20 determine (a) their…

A:

Q: A centre zero ammeter connected in the rotor circuit of a 6-pole 50 Hz induction motor makes 30…

A: Given- 6-pole 50 Hz induction motor, No. of poles p=6, frequency f=50 Hz, 30 oscillations in 1…

Q: oblem 10. For the double-beam oscilloscope dis- ys shown in Figure 10.20 determine (a) their quency,…

A:

Q: A coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…

A:

Q: Find the octal equivalent to 359.325d

A: This is basic problem of conversion in digital electronics.

Q: The line voltage + 7.9 A||||| RA 2.5 A www 48 Ω RB RC www The current through B is twice as much as…

A:

Q: In the mechanical network, the total number of nodes is equal to: a. number of displacements – 1 b.…

A:

Q: 1. Determine the total resistance and the current along 3 ohms in downward direction. 50V + 65 85…

A:

Q: + Vs 1A Figure 8.3 10 Q2 6 V 222 See Figure 8.3. What is the value of the voltage Vs?

A: Given circuit,

Q: 13 For the circuit arrangement specified in Q12 above determine the power and energy dissipated by…

A: We need to find out the energy and power for given load in given circuit

Q: A DC generator feeds a load consisting of 22 lamps, each lamp capacity 100 W,220 V, calculate the…

A: We will find out induced EMF for given generator .

Q: D Clock B. From a Positive Edge D Flip-flop. Draw the normal and complemented output PC

A:

Q: The power input to a 500 V, 50 Hz. 6-pole. 3-phase induction motor running at 975 RPM is 40 kW. The…

A: Solution !!

Q: How many exclusive-NOR's are needed to make a comparator for two six-bit words?

A: This is a problem of digital electronics from combinational circuits. The detailed explanation is…

Q: it is an Level triggered digital circuit whose basic function is memory and is capable of storing a…

A: In this question,  We are discussing about the level triggered digital circuit.  Triggering is used…

Q: What should be the limit of SWR? a. 0

A: SWR stands for standing wave ratio. The limits of SWR=?

Q: An important difference between the open- and closed-loop control systems is that the   Question 9…

A:

Q: In a semiconductor crystal, the atoms are held together by O a. covalent bonding b. interaction of…

A:

Q: Y(s) = What is the value of b? Blank 1 Add your answer 7s³ +2s² +3s −1 s² +3s +2 Blank 1 || a -9 s+2…

A:

Q: 2. Given the system below, determine K. in N/m and M. in kg so that the % Overshoot is 25% and the…

A:

Q: A 15 KVA, 2400: 240/120 V, 60 Hz, the two-winding transformer is to be reconnected as a 2400:2520 V…

A:

Q: 4. Determine I₁, I2 and 13 using current division. 50v+ 102 -W $82 6-02 n 52 W I₁ 30 122 ∙1₂ № 13…

A:

Q: Solve for Resistor Capacitor Time Constant

A:

Q: Question 2 a. Figure 1 shows a block diagram of a DC drive system. Diode rectifier AC supply Power…

A: DC drive system- DC drive system is a system which is used to control the speed of DC motor by which…

Q: Calculate the noise current for a diode W/a bias current of 5mA observed over 75Khz bandwidth. also…

A: According to the question, we need to calculate the noise current for a diode with a bias current of…

Q: The power input to a 500 V, 50 Hz. 6-pole. 3-phase induction motor running at 975 RPM is 40 kW. The…

A:

Q: 1. Sketch the unit step response of the system shown below: + VIE; = 1V + Determine the following:…

A:

Q: 1. Conversion of Complex Number Given the following electrical parameters expressed in complex…

A: Given that: The complex numbers are U=35-j377 ΩS=220 cis240o VT=10cos2r+j sin2r A Find rectangular…

Q: In AM modulation, if the modulating signal amplitude is of 3.08V and carrier amplitude is of 11.54V,…

A: We need to find out the modulation index

Q: 2. Determine I, and I, using current division. 80V (+ 1252 M 82 M Ix W 105 452 W 18225 If fy 200

A: Given circuit,

Q: This type of energy can be used to produce fuels such as hydrogen: None of all answers O OTEC Energy…

A: Given: Which type of energy can be used to produce fuels such as hydrogen?

Q: The terminal p.d. of a d.c. source is 22.5V when supplying a load current of 10 A. If the emf is 24V…

A: It is given that: Vb=22.5 VI=10AE=24 V

Q: Attenuation, distortion, and noise contribute to transmission impairment. What is the solution, or…

A: Attenuation Attenuation is the broad term for any reduction in a signal's intensity. Any signal,…

Q: When anode is negative as compared to cathode, diode is biased.

A: A diode can be biased into two ways Forward biased Reverse biased

Q: A transformer works at 6 KVA with a primary voltage of 82 V. If the load voltage is 235 V ,then the…

A: Given: A transformer works at, Rated apparent power, S=6 kVA. Primary voltage, V1=82 V. Secondary…

Q: The BJTs in the two circuits have ß-100 and [VBE| = 0.7 V. Determine the following (i) type of BJT,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 12. Aside from Flip Flops being used as a memory, it is also commonly on switches as?   13.For an…

A: 12) Flip flop can be used in various applications such as  1. Counter  2. Frequency divider  3.…

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: Given,At frequency 1.5 kHz,The open circuit impedance is,Zoc = 800∠-50° ΩandThe short circuit…

Q: Verify that the closed-loop transfer function T(s) = C(s)/R(s) in terms of parameters a and pressed…

A: Given that: The block diagram is shown below. A continuous time, linear, time-invariant feedback…

Q: The sparking at the brushes of a dc generator is due to winding distribution high constant…

A:

Q: A generating station has a connected load of 43 MW and a maximum demand of 20 MW; the units…

A: Given, A generating station has, Connected load = 43 MW. Maximum demand = 20 MW. Units generated per…

Q: Write the following quantities in scientific notation. (a) 15002 (b) 0.00332 (c) 0.000 025 A (d)…

A: Scientific Notation- If values of any quantity are large in values as values can go from negative…

Q: 2. Determine Vab- por? 50V+ US M ΛΟΙ + 00+ Valo 169 15.02 M Hví 8V

A:

Q: . PLEASE SOLVE AND SHOW YOUR DETAILED SOLUTION WITH FBD. The currents at the junction point in a…

A:

Q: Draw the DC Machine and label its parts Example. Armature Winding Stator Pole Shoe/ Face Field…

A: DC Machine An electrical device that transforms electrical energy into mechanical energy is a DC…

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,