A 100-turn square coil of side 20.0 cm rotates about a vertical axis at 5.9 ×10 rad/min as indicated in the figure. The horizontal component of the Earth's magnetic field at the coil's location is equal to 2.00 x 10 T. Calculate the maximum emf induced (in units of mV) in the coil by this field. 20.0 cm 120.0 cm

A 100-turn square coil of side 20.0 cm rotates about a vertical axis at 5.9 ×10 rad/min as indicated in the figure. The horizontal component of the Earth's magnetic field at the coil's location is equal to 2.00 x 10 T. Calculate the maximum emf induced (in units of mV) in the coil by this field. 20.0 cm 120.0 cm

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Faraday’s Law

Section: Chapter Questions

Problem 31.42P: 100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.50 103 rev/min as indicated...

See similar textbooks

Similar questions

A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
A thin conducting bar (60.0 cm long) aligned in the positive y direction is moving with velocity v=(1.25m/s)i in a region with a spatially uniform 0.400-T magnetic field directed at an angle of 36.0 above the xy plane. a. What is the magnitude of the emf induced along the length of the moving bar? b. Which end of the bar is positively charged?
A long solenoid with n= 10 turns per centimeter has a cross-sectional area of 5.0 cm2and carries a current of 0.25 A. A coil with five turns encircles the solenoid. When the current through the solenoid is turned off, it decreases to zero in 0.050 s. What is the average emf induced in the coil?
Two long, parallel wires cy equal currents in opposite directions. The radius of each wire is a, and the distance between the centers of the wires is d, Show that if the magnetic flux within the wires themselves can be ignored, the self-inductance of a length 1 of such a pair of wires is L 0 l in d1 a (Hint Calculate the magnetic flux through a rectangle of length 1 between the wires and then use L=N/I
100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.50 103 rev/min as indicated in Figure P31.42. The horizontal component of the Earths magnetic field at the coils location is equal to 2.00 105 T. (a) Calculate the maximum emf induced in the coil by this Held, (b) What is the orientation of the coil with respect to the magnetic field when the maximum emf occurs?
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
An automobile with a radio antenna 1.0 m long travels at 100.0 km/h in a location where theEarth’s horizontal magnetic field is 5.5105T . What is the maximum possible emf induced in the antenna due to this motion?
A time-dependent uniform magnetic field of magnitude B(t) is confined in a cylindrical region of radius R. A conducting rod of length 2D is placed in the region, as shown below. Show that the emf between the ends of the rod is given by dBdtDR2D2 . ( Hint: To find the between the ends, we need to integrate the electric field from one end to the other. To find the electric field, use Faraday’s law as “Ampere’s law for E”.)
A flat, square coil of 20 turns that has sides of length 15.0 cm is rotating in a magnetic field of strength 0.050 T. If tlie maximum emf produced in die coil is 30.0 mV, what is the angular velocity of the coil?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
A 10-H inductor carries a current of 20 A. How much ice at 0ºC could be melted by the energy stored in the magnetic field of the inductor? (Hint: Use the value Lf= 334 J/g for ice.)
To monitor the breathing of a hospital patient, a thin belt is girded around the patients chest as in Figure P20.21. The belt is a 200-turn coil. When the patient inhales, the area encircled by the coil increases by 39.0 cm2. The magnitude of Earths magnetic field is 50.0 T and makes an angle of 28.0 with the plane of the coil. Assuming a patient takes 1.80 s to inhale, find the magnitude of the average induced emf in the coil during that time. Figure P20.21