A 100 Z0°V 120HZ generator and a 8020°V 6OHZ generator are connected in series with a 60V battery and a coil. The resistance and inductance of the coil are 3 ohms and 2.65 mH, respectively. Determine the rms current of the coil.

A 100 Z0°V 120HZ generator and a 8020°V 6OHZ generator are connected in series with a 60V battery and a coil. The resistance and inductance of the coil are 3 ohms and 2.65 mH, respectively. Determine the rms current of the coil.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Given V, = 20 sin(@t + 60°) and V, = 60 cos(@t – 10º) . What is the phase angle between the…

Q: An alternating voltage is given by v = 200 sin(628.4t – 0.41) volts. Find the following: a) The peak…

A: We compare the given voltage with standard sinusoidal voltage.

Q: Find the mean current and the RMS current from t=0.0s to t=4.0s if i= (1.0t+1.0/t) Round to the…

Q: An AC generator causes 50 Hz current in a circuit containing a 290 Ω resistor, 4.89 µF capacitor,…

Q: Harmonic Frequency 50 Hz 250 Hz 350 Hz 450 Hz Current Amplitude 5A 2.1 A 1.5 A 0.8 A The current…

A: Given,

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

Q: 1. Given a sinusoidal voltage: v = 300 cos(120´t + 30º). Find A) Period of the voltage in ms? B)…

Q: If V = 60V at α = 30° and t = 1.5 ms, determine the mathematical expression for the sinusodial…

Q: 1. Given a sinusoidal voltage: v = 300 cos(120nt + 30°). Find A) Period of the voltage in ms? B)…

A: From the Sinusoidal voltage information

Q: A capacitor of 3.18 microfarads is connected in parallel with a resistance of 2000 ohms. The…

A: A capacitor of 3.18 μF is connected in parallel with a resistance of 2000 ohms. The combination is…

Q: A current i(1) = 30 sin 100rt amperes is applied across an electric circuit. Determine RMS values…

A: Given data: The current is: i(t)=30 sin 100πt. The expression rms value is given as,

Q: An AC Voltage Generator provides 100 V at angular frequency of 500 rad/s to a series RLC, R = 3…

A: It is given that: V=100 Vω=500 radsecR=3 ΩC=50μFL=10 to 80 mHVCmax=1200 V

Q: Find the value of the elements in the circuit which absorbs a complex power of 5000Z45° volt –…

A: This question belongs to circuit theory . It is based on the concept of power in the circuit . With…

Q: Calculate the current drawn from the source with and without the capacitor connected. Determine the…

Q: 4. The AC generator in the circuit shown below supplies voltage with amplitude 5.0 V at frequency…

A: Given V=5 V f=336 Hz

Q: SOU 173 27

A: R.M.S(Root Mean Square) value is the characteristics of A/C signals. These are also called as the…

Q: The rms output voltage of an AC source is 150 V and the operating frequency is 90 Hz. Which of the…

A: from the question V=150v f=90 Hz Vpeak=sqrt(2)*Vrms

Q: The equation for an altemating current is given by i = 75 sin 314.16t. Find the peak value,…

Q: A 240V, 50Hz supply feeds a highly inductive load of 500Ω resistance through a thyristor bridge that…

Q: What will be the average power in the load for the circuit shown, when alpha = π/4 Assume SCR to be…

A: The Given α=π4 Assume SCR to be ideal. The supply Voltage is 330 sin 314t To calculate the RMS power…

Q: A harmonic analysis of the current drawn by a CFL yields the following data. Find the rms value of…

A: We have an data of CFL lamp with harmonics as shown in table and corresponding currents of that…

Q: In the following circuit, the supply voltage is defined as V(t) = 325 sin (314t – 30o) and L = 2.2H.…

A: Given: V(t) = 325 sin (314t – 30°)L = 2.2H

Q: A coil is in series with a 20 microFarad capacitor across a 230 V, 50 Hz supply. The current taken…

Q: A sinusoidal signal of 20V peak at 50 Hz is applied across a series combination of a resistor and…

Q: Q2. In the following circuit, the supply voltage is defined as: V0 = 325 sin( 314t – 30° ) and…

A: Given: Vt=325sin314t-30oL=2.2 H

Q: 10 30 50 Wa (1000 rad/s) In an alternating current circuit, the current amplitude versus the driving…

Q: What is the ripple factor of a sinusoidal signal having an rms of 56 V on an average of 50 V?…

A: Given data, A sinusoidal signal is having Vrms=56 VVavg=50 V

Q: = 500sin(300nt – 75°) te the peak voltage, phase angle,rms value, freq

Q: 5. A capacitor of 80 microfarad is connected to a 120 V, 75 Hz source. Determine (a) the capacitive…

Q: Write the sinusoidal expressions for voltages and currents having the following rms values at a…

A: In this question we will write standard expression for current and voltages with given data..

Q: Volts 20 10 5 10 15 20 25 30 35 40 45 50 t (ms) -10 - -20 Given the above graph. Which general…

Q: 2. A coil has a resistance of 482 and an inductance of 1.5H connected in series. If the current…

Q: Find the rms current flowing in an AC capacitive circuit when a 4μF capacitor is connected across a…

A: To find rms current first find capacitive reactance. then find current in the given circuit.

Q: 54. Practical average value of a sinusoidal wave is taken only at three cycles. True False 55. In…

A: we need to solve whether given statements are true or false.

Q: For a source which has: • Vrms = 345 V • P= 8195 W • pf = 0.95 What is the rms current?

A: In this question we need to find RMS current .

Q: A0) is supplied by an RMS value of 22o-v, 60-Hz source

Q: 1. Derive the formula for the RMS value for the following a) tespe 文 RSITY SAIN

A: The solution is given below

Q: An alternating voltage is given by the equation v(t) = 50sin(20tt + 20°) Calculate the peak voltage,…

Q: Resistor R and a resistanceless coil L1 = 83.8 mH are connected in series to an AC source with…

A: The given circuit is the RL circuit: The current I can be calculated as: Irms=VrmsR2+XL2

Q: the average power of a load is 3.37 kW with a leading power factor of 0.835. the magnitude of the…

A: Apparent power = active power/ power factor. Apparent power = sqrt((active power2)+ (reactive…

Q: The expression T I = i°(t)dt T defines: Select one: 1. RMS value of the current 2. Average value of…

A: We will write Expression for each of the options given in the question and than we will answer the…

Q: 3. Replace the DC source by an ac source with an rms value of 12 V. Connect it across the same bulb.…

A: Vrms=12V f=60Hz Rlamp=12 ohms.

Q: Supply voltage has an average value of 20 V. Its RMS value is RMS value, Vrms = %3D

A: If the averages voltage 230V Then rms value? Assume this is sinusoidal waveform.

Q: Two units, connected in parallel, are energized by an a-c source. If the component currents are 15…

Q: Find the rms value of the periodic waveform of the figure below over one full cycle. Av (V) 1 cycle…

A: Average Value of a signal: It's that steady state equivalent of a time varying signal which would…

Q: Required: average and effective values of the given i(t) mA 10 Sinusoidal -5 5 10 15 1 (us)

Q: 1. Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage…

A: As per bartleby policy there are multiple questions so we have to solve only one question.

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

A 100 Z0°V 120HZ generator and a 80200V 60HZ generator are connected in series
with a 60V battery and a coil. The resistance and inductance of the coil are 3 ohms and
2.65 mH, respectively. Determine the rms current of the coil.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the rms phasor of a voltage is given by V=12060 volts, then the corresponding v(t) is given by (a) 1202cos(t+60) (b) 120cos(t+60) (c) 1202sin(t+60)
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
An alternating voltage given by v = 120 sin (240t + п / 4) V, is applied to a coil withnegligible resistance and inductance of 100 mH. Determine (a) the reactance of thecoil, and (b) the RMS current flowing through the circuit.
The rms output voltage of an AC source is 150 V and the operating frequency is 90 Hz. Which of the following equation gives the output voltage as a function of time? a. (150 ?) sin(283?)b. (150 ?) sin(565?)c. (212 ?) sin(283?)d. (212 ?) sin(565?)
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags behind A by pi/3 radians and the line current is 23.4 amp, determine the current in B.
A 40 kW induction motor, with a lagging power factor of 0.76, is supplied by a 120 V rms 60 Hz sinusoidal voltage source. Find the capacitance needed in parallel with the motor to raise the power factor to: (a) 0.9 lagging, and (b) 1.0.
An AC generator causes 50 Hz current in a circuit containing a 290 Ω resistor, 4.89 µF capacitor, 0.362 H inductor, and switch in series. At time t=0, the switch is closed at an instant when the voltage from the generator is 0 V. We measure the rms current as 41.1 mA. a) Write an expression for the instantaneous voltage (aka, the voltage as a function of time). v(t) = ______ b) Does the voltage lead or lag the current? Explain how you know. c) Draw a phasor diagram at an instant when the current is zero. Label the phase angle. d) Draw a phasor diagram at an instant when the current is maximum. Label the phase angle.
Two electric devices A and B are connected in parallel, and the rms current in A is 15 amp. If the current in B lags A by p/3 radians and the line current is 23.3 amp, determine the current in B.
The current in a pure capacitor circuit is i=0.17cos500t. If the rms value of the impressed emf is 80 volts. a) What are the equation for the voltage and power? b) What is the circuit frequency?
A coil with an iron core absorbs a current of 0.5 A when a sinusoidal voltage of 220 V rms is applied to its terminals. If the power absorbed was 30 W, deduce the equivalent circuit of the coil. Ans: RFe = 1,617.64 Ω and Xμ = 457.38 Ω. (I need the procedure)