Answered: A 10mF capacitor has the current…

A 10mF capacitor has the current waveform as shown. Assuming that v(0) = 7V, sketch the voltage waveform v(t) i(t) (mA) A 15 10 2 8 (s) -5 -10

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 2PP: Assume that the current flow through the resistor, IR, is 15 A; the current flow through the...

See similar textbooks

Related questions

Q: Using the diode exponential model, determine the value of the resistance R such that the output volt...

A: Answer - Given - Vo = 3V IL = 0 Vr = 25 mV

Q: An impedance coil is connected in parallel with a capacitance C of 12.5 μF. The input voltage to the...

Q: findthe Efficiency 412 V2 I3 012C i3 e 414

A: Given: Consider the following circuit: To find: String efficiency?

Q: Using Star/Delta transformation, determine the value ofR for the network shown in Fig. 1(a), such th...

Q: Compute the current through the 222 resistor of the circuit in Figure Ql using superposition theorem...

Q: The following information is given in connection with a parallel connected load of three impedances:...

A: In parallel circuits, Voltage across the load is constant but current vary which depends on the type...

Q: consider the following diagram of impedances in per unit of a common base a) get the YBus admittance...

Q: Example: D3.7. In each of the following parts, find a numerical value for div D at the point specifi...

Q: Assume that each diode has a turn-on voltage 0.7V in the circuit shown in Figure Q1. By using the co...

A: In this question, We need to check which diode act as on and off. Assume forward bias diode voltag...

Q: .Connect the 10 chm resistor in parallel with A & B the remaining resistors connected in series, the...

A: The solution is given below

Q: Explain the working of a full wave bridge rectifier circuit. What are the disadvantages of center ta...

A: The main difference between full-wave rectifier and center tap full wave rectifier is the number of ...

Q: The secondary is connected to a load of 502. Calculate the primary and secondary side impedances, cu...

Q: antiparallel

A: Given that

Q: Assume the pair of transmission lines, 1 and 2, are repeated 10 times. (a.) If the individual line s...

A: calculate input impedances at line 1 2 3 and 4 by now we can observe a pattern and therby we can fin...

Q: 12 kN 12 k2 4 kN 12 kN 312 kM 12 kN 2 kN 12 kM 12 kN R7 1 kN 12 kN 12 kN 1kN 312 kN 3 12 kN 12 k2 12...

A: Series resistance are directly add to get the equivalent resistance. ex- R=R1+R2+R3 In parallel resi...

Q: A three phase transmission line is made up of aluminum conductor wires 80 km long. Find the dc and ...

A: Length of conductor is L=80 km = 80×103 m Diameter of conductor d = 480 miles Radius of conductor is...

Q: VEE =-12V, VCC = 12V, R1=9800 ohm, R2 = 3300 ohm, RC = 1800 ohm, RE = 970 ohm, B = 100 Calculate IB...

Q: Problem #1 Design a series RLC bandpass filter with a center frequency fo = 1 MHz and a quality fact...

Q: Find z transform of the signal x(n) which x[n]= (½)" sin(¾n)u[n]

Q: VEE -15V VC 5V Vt R2 D1 D2 R1 5000 1N4001 1N4001 3kQ Find Vt note: show Vour solutions for each prob...

Q: In the circuit of Figure 2 with RL = 1 kilohm, determine the maximum value of Rs which will allow th...

A: A series combination yields the most resistance, whereas a parallel combination has the lowest resis...

Q: Find the minterms of the following Boolean expressions by first plotting each function in a map: (c)...

Q: #2) What is He power generated by the source in the circuit and Vs Pes SK R6 6K. Rz 181 Vs R3 12K 4K...

Q: Solve I, Vo1, and V02 Vo I kQ 0.47 k2 Voz 02 Si Si 20 V

Q: A 1.5kΩ resistor has a voltage drop of 22.5V across it. Can a 1/4W resistor be used for this applica...

Q: t= 0 6Ω 24 V 12 2 4Ω -- 155

Q: How does increasing the temperature of component affect its noise power?

A: FIND: how does increasing the temperature of component affects its noise power

Q: Determine the truth table for a NOR-logic based full adder circuit.

A: Steps to find the Truth table and Logic Diagram Decide the number of input Generated output will b...

Q: For the cascaded binary symmetrie chanels shown below, find the maximum amount of information transm...

A: Pyx=0.90.10.20.8Pzy=0.70.30.25450.7455Now calculating Pzx as-Pzx=Pyx.Pzy =0.90.10.20.80.70....

Q: I4 RA R2 R3 I3 o Vout in V_ R1 V+

A: Given circuit shown R1=7 kΩ ,R2=12 kΩ,R3=6 kΩ, R4=10 kΩ

Q: Minimize the Boolean expression F=AB’C’+C’D+BD’+A’C using K -map and implement the logic circuit usi...

A: To minimise the Boolean expression using k-map and implementation of the logic circuit using NAND ga...

Q: 5. The power taken by a resistive coil made of copper wire is 1200W at 120V and 15 °C. Calculate the...

Q: 23.a. What type of squirrel-cage motor is ordinarily used with small air compressors equipped with a...

A: 23.a) Answer :B Design C motor.

Q: Solve for C(s)/R(s).

Q: 0.068 μF + + V; 1.2 k2 V. FIG. 9.79 Problems 11, 12, and 37. 12. For the network of Fig. 9.79: a. De...

Q: KW demand I5 UUI 4. Explain the different voltage control methods [10 A 3-phase line having an imped...

A: Phase modifier: This is also known as the synchronous condenser that runs without mechanical load an...

Q: R. R1 RL RA R2 V s -ww ww

Q: 2) Consider the circuit shown below, where v, and v, are the input and output voltages, respectively...

Q: . 2.00 p

Q: 4. A thin non-conducting rod of finite length / carries a total charge q, spread uniformly along it....

A: line of charges of length 'l' and charge 'q' Consider point A and B equidistant from mid point. Say ...

Q: Electrical Machine Lab. Single-Phase Induction Motor (Split Phase) A.C. M. Supply 1-9 UN Zi Za Fig.(...

A: Multiple Sub-parts: Solve the first three sub-parts in a multiple sub-part question, unless the stud...

Q: How to find a mathematical model, called a state-space representation, for a linear time invariant s...

A: State-space representation A mathematical model of a physical system as a set of input, output, and ...

Q: Capacitor Inductor Resistor Jap iç = C dt dir Vr = İRR VL = L dt %3D %3D 15F ३७H

Q: 3. Find the current i, in the circuit of Fig. 2.42. Let i, = 6 cos(200t + 15°) 0.1 v. 40 Ω ww i, 20 ...

A: In this question, Depended and independent energy sources are given with resistance, inductance and...

Q: 3Ω 12Ω. 9Ω :18Ω 6Α 12Ω 12Ω. 12Ω 4Ω

Q: The system is given by a block diagram: G3(s) R(s) Y(s) G1(s) G2(s) E(s) H2(s) H1(s) a) Simplify the...

A: The solution is given below

Q: Discuss the saturation of a permanent magnet generator

Q: A 6.6 kV, 6 MVA Y-connected, 3-phase alternator has an effective ac resistance of 0.436 ohms between...

Q: Determine the value of reactance that need

A: Types of open circuit fault- 1) Symmetrical fault- Three phase line to ground fault Three phase li...

Q: T1 12v 6v A 4.5v 3v To Diode circuit Ov common B D1 A C1 1000µF RL 1B4B42 3kQ Find the output voltag...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Concept explainers

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.

Question

100%

Capacitors

A 10mF capacitor has the current waveform as shown. Assuming that v(0) = 7V, sketch the
voltage waveform v(t)
i(t) (mA) A
15
10
2
8 (s)
-5
-10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
Figure 3 shows the waveform of the voltage across a 20 μF capacitor. Select the correct expression for the capacitor current, ic(t), for 0
The current through an inductor with inductance 1 mH is given by i(t) = 0.1 sin 106t. Find the voltage across this inductor.
A 0.25 μH inductor is used in an FM radio circuit that oscillates at 100 MHz. The current through the inductor reaches a peak value of 2.0 mA at t = 5.0 ns. What is the peak inductor voltage, and when, closest to t = 5.0 ns, does it occur?
if the voltage across a 0.00009-μF capacitor is 74sin(100t) V. What is the value of its current at t = 0.4?
1.) The circuit below is in steady state before the switch closes at t = 0. a)Determine the voltage across the capacitor for t > 0.
A 24-μF capacitor has a stored energy equal to 18sin2(11t). What is the current in the capacitor?
A series circuit has a capacitor of 1.5625x10^(-8)F a resistor of 2x10^4 ohms, and an inductor of 1H. If the initial charge on the capacitor is zero,. if a 12-volt battery is connected to the circuit and the circuit is closed at t=0, determine the charge on the capacitor at any time t
A capacitor is fully charged in a RC circuit with 16 V of voltage supply to the maximum electric charge of 1.2 x 10-3 C. If it took 0.24 s to charge to 2/3 of charge, what will be the maximum current, in the unit of A, when discharging the capacitor? Assume that the same resistor is used for charging and discharging
A capacitor is constructed from two conductive metal plates 30cm x 50cm which are spaced 6mm apart from each other, and uses dry air as its only dielectric material. Calculate the capacitance of the capacitor.
30.A 150 Hz, 25 mA AC current flows in a circuit containing a 20-microfarad capacitor. What is the voltage drop across the capacitor?
All capacitors were initially discharged.at t = 0, S1 is placed at position 1 and S2 is closed.At t = 15 ms, S1 is placed at position 2 and S2 is kept closed. At t = 25 ms, S1 is kept at position 2 and S2 is opened.after 25 ms, the voltage vT will Question options: increase until it reaches the battery voltage at steady state exponentially decay to zero stay constant be a sine wave