A 15.0-V battery is connected to a 3.00-μF capacitor. Howmuch energy is stored in the capacitor?

In this question we will find energy stored in capacitor....

Answered: A 15.0-V battery is connected to a…

Engineering

Electrical Engineering

A 15.0-V battery is connected to a 3.00-µF capacitor. How much energy is stored in the capacitor?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 5PP: An inductor has a current flow of 3 amperes when connected to a 240-volt, 60-Hz power line. The...

See similar textbooks

Related questions

Q: Consider the figure given below. Derive an expression for E(s) where Ris) is the input signal, E(s)…

A: Given data,

Q: The first flip-flop of a ripple counter is clocked by the Q of the last flip-flop O external clock O…

A: Ripple counter is also know as asynchronous counter.

Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: 24V 318-4 Sensor K2 08 05-8 21 If you're only allowed to pick one, from which column would you…

A: Ans :( B) coulomn 2 Since two sensors are connected in series without any coordination... Which…

Q: 1. A 3-phase, star-connected alternator is rated at 15000 kVA, 11 kV. The armature resistance is…

Q: Find the output sequence Z for the given input if the output Z is 1 if the total number of I's…

A: Given Data, Input is 11110101001111

Q: Q4 for the following circuit find total current, la fe.V. V and Po He 404 40 ALT AR 030 130

Q: Determine the phasor currents I, and I2 in the circuit of Fig. 13.B

Q: A 3-phase, 8 pole, 400V, 50Hz, induction machine has the supply current I; = 35.3A angle…

A: Given: 3-phase induction machine has P=8f=50 HzVL=400 VIL=35.3 Aθ=-98.5°

Q: 6. You have a complicated wire structure with an area of 1 cm², and an average interior magnetic…

A: Given data, Area, A=1 cm2 Magnetic field, B=10-9 T

Q: 1. Obtain the thevenin equivalent circuit at terminal a-b 8 ohms j2 ohms 8 ohms -j3 ohms 20<0 V…

Q: I If a microprocessor can perform 4 million. instructions per second, how many nano seconds are…

Q: • Construct 4-to-16 line decoder with 3-40-8 a line decoders with enable and external gates.

A: We need to design the given decoder.

Q: . For the network in Fig. 14.86 and the applied source: a. Determine the source voltage vs. b. Find…

Q: 0: ohm per phase. Calculate the synchronizing power per mechanical degree displacement

A: A synchronous generator converts mechanical energy in to electrical energy. The effectiveness of…

Q: If the initial content of a 3- bit ripple down counter is 000. After the first clock trigger, the…

A: Ripple down counter:- It is cascaded combination of flip-flop, its count up to 2n states. It is also…

Q: Calculate the resistance of wire Given data - Length = 150 m Cross sectional area = 0.2 mm²…

A: given length , cross sectional area , resistivity of a wire and asked to find the resistance.

Q: A lossless transmission line has a characteristic impedance of Zo= 50 , a load impedance of ZR =…

A: In the above given question we need to calculate the value of reflection coefficient and input…

Q: The transistor parameters for the circuit in Figure 5 are ß= 180 and VA=∞ (a) Find Ico and VCEQ. (b)…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: For the circuit shown. Find R₁, R₂, R3 so that Z₁=2.5K₁2² 2₁2= Z₂₁1 = 1.25 K Z22= 3.125 K R₁ R₂ AM…

A: Given data : Z11=2.5kΩZ12=Z21=1.25kΩZ22=3.125kΩ

Q: / Construct 4-to-16 live decoder with 2-to-41 a line decoders with enable.

A: We need to design 4 to 16 decoder by using of 2 to 4 decoders .

Q: Exercise: Find the closed-loop transfer function for the following block diagram:

Q: A DC-DC boost converter has an input of 200 V with a load of 7.5 Ohm. Find the output voltage and…

A: Given data, DC DC Boost converter, Input voltage (VDC) = 200v , Load resistance ( R ) = 7.5 ohm ,…

Q: Determine the resistance and conductance of 20m of copper wire 2mm in diameter. P= 1-72 x10 S

Q: Show that x(t) = C₁e- Ÿ + 2r + r = 1 for any

A: In this problem: We know that solution of ODE equation is sum of complimentary solution and…

Q: For all problems, solve for the following a. Vgs b. Id C. Zin d. Zout e. Av H 0.05 µF IMO m 16V 3.9…

A: We need to find out current ,. Voltage, input and output impedance and voltage gain for given…

Q: A lossless transmission line has a characteristic impedance of Zo= 100 £2, a load impedance of ZR =…

A: Z0=100ΩZR=70+j120Ωf=300 MHzZL=ZRZ0=70+j120Ω100ΩZL=0.7+j1.20Ωλ=cf=c300 MHz=0.999λ≈1mZmin at 0.25λZL…

Q: The group of bits 10110111 is serially shifted right (right-most bit first) into an 8-bit parallel…

Q: Input Terminal Input Terminal Output Terminal Output Terminal Output Terminal Output - Terminal…

Q: 5. The ODE d²y dy dx² dx + - 2y = 0 has a general solution y(x) = C₁еx + С₂e−2x Determine the…

Q: Q5 Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: When there is more than one source is available in the circuit, then we can use superposition…

Q: If the surface-leakage current is 2 nA for a reverse voltage of 25 V, what is the surface leakage…

A: Given: Surface-leakage current, I=2 nA,Reverse voltage, V=25 V

Q: 4) Consider the feedback system G(s) = K(s +1+j)(s+1-j). The root-locus is which of the…

A: 4) To choose the root locus for the given feedback system G(s) from the options

Q: Which instruction is used to transfer 16-bit data from 8086Mp to an I/O device that has port no.=…

A: Answer:-option 3) OUT AX,61H and remaining options are incorrect because of below explanation.

Q: Full adder circuit using Design a and external gates. a decoder

Q: 42 sin 8r V 252 www H IH ¹/2 7652

Q: The R.M.S. value of a half-wave rectified current is 10A, its value for full-wave rectification…

A: Answer: 14.14 Explanation: a. It is not a valid option. The value is same as twice the value of peak…

Q: Q2:- Find the transfer function (Vo/Vin) for the system shown in figure below. voo 2 H Vin Vo 102 5…

Q: 4. What are the advantages of FM? 15. What are the drawbacks of slope detector? 8. How FM wave can…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Construct 4-to-16 line decoder with 3-4-8 a line decoders with enable and external gates.

A: We need to design the 4 to 16 decoder by using of 2 to 4 decoders

Q: * The register is a type of latches O combinational circuit O CPU O sequential circuit O none of the…

A: The register is a type of

Q: Consider two amplifiers A, and A₂. The rise time for first stage is 0.3 ms and for the second stage…

A: Given data, To amplifiers A1 and A2 are cascaded. Rise time of first stage is tr1=0.3 ms Rise time…

Q: Home Work: in 91 Two resistors must be selected so that like cust one is four times the current in…

A: We need to find out resistance value for given condition

Q: a) For the Circuit shown calculate the value of C if the resonant frequency. is 5000 vad /sec

Q: The main difference between a register and a counter is

A: ans:(d) register has no specific sequence of states

Q: E6.24 Consider the system represented in state variable form x = Ax + Bu y = Cx + Du, where 0 1 0 […

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

Q: F = 2 ( 0 ₁ 1 ₂ 3 ₂ 4 ₂ 8,9,15) 2 16 to 1 Mux

Q: L Determine the resistance and conductance of 20m of copper wire 2mm in diameter. ४ = 1-72 x10. M.

Q: A DC-DC boost converter has an input of 200 V with a load of 7.5 Ohm. Find the output voltage and…

A: Given data, DC-DC boost converter has Vin=200 VR=7.5 Ωd=0.4

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 15.0-V battery is connected to a 3.00-μF capacitor. How
much energy is stored in the capacitor?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
This circuit is connected to a 1000-Hz line. The resistor has a voltage drop of 185 V. the inductor has a voltage drop of 740 V, and the capacitor has a voltage drop of 444 V. The circuit has an apparent power of 51.8 VA. ETITZVA51.8PFER185VIRRPEL740VILXLVARsLLEC444VICXCVARsCC
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
An inductor has a current flow of 3 amperes when connected to a 240-volt, 60-Hz power line. The inductor has a wire resistance of 15 . What is the Q of the inductor?
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?