A DC-DC boost converter has an input of 200 V with a load of 7.5 Ohm. Find the output voltage and current for Duty Ratio: D= 0.4
Q: A 34 balanced system, stem, ", -re sequence with line voltage 380 Vrms feed a delta connected load…
A:
Q: Matlab
A:
Q: Q choose the correct answer: 4_Adjustment resistance in rotor system will.-------when three phase…
A: Given Multiple choice questions based on alternator. Please find the below attachment for clear…
Q: current - 1=?, and the power factor - cosp =?. 4. An out of balance three phase star connected load…
A: In this question we need to find a RMS current through neutral .
Q: 'Construct a 4-to-16 line decoder with 3-to-8 like decoders with enable and external gates.
A: We need to design 4 to 16 decoder by using of 2 to 4 decoders
Q: A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…
A: Squirrel cage induction motor is good speed regulation and the harness of electromagnetism to…
Q: 1-Efficiency 2- Ripple factor 3- PIV
A: The rectifier defined as the power electronic circuit which is used to convert ac power to dc power.…
Q: Q5 Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…
A: When there is more than one source is available in the circuit, then we can use superposition…
Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…
A: Given circuit:-
Q: Three resistors of 108 ohms, each, are connected in delta. What is the equivalent resistance (in…
A:
Q: Design a synchronous down counter which will count from binary 15 to 0. Use J-K Flip Flop to design…
A: Design a synchronous down counter which will count from binary 15 to 0. Use J-K Flip Flop to design…
Q: A 480 V, 60 Hz, three-phase source is connected to a wye-connected load, in which each element has…
A: Given: Three phase source with specifications, VL=480 Vf=60 Hz Wye-connected load in which each…
Q: PROGRESS CHECK 1: Find the efficiency of DC compound motor (long shunt), 25H.P, 230V, shunt field…
A: Types of DC Motor Seperetely excited Motor Series DC Motor Shunt DC Motor Compound Motor Long…
Q: A piece of RG-59B/U Coaxial cable has a nominal capacitance of 0.4F/m, and 7.5 H inductance per…
A: It is given that: Nominal capacitance= C=0.4 F/mInductance per meter=L=7.5 H/mDiameter of inner…
Q: Three branches having impedances of 3 + j4N, 16 j12 S2, and-j4 St, respectively, are connected in…
A: Given: The impedance connected in parallel are Z1=3+j4 ΩZ2=16-j12 ΩZ3=-j4 Ω
Q: Solve the question by hand do not using computer, explain each step please Example 3.8: ELECTRICE…
A:
Q: 1. A real load of ZL = 100 is attached to 50 2 line, insert a matching circuit of two- section using…
A: Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: There are different states in a 4-bit Johnson counter 4 none of the mentioned 3
A: Johnson counter:- It is a modified ring counter in which the inverted output from the last flip flop…
Q: Provide at least 3 Examples of Control Systems Models or Representations and its corresponding…
A: Following control system models are mostly used- Differential equation model Transfer function…
Q: 9. The output of an edge-triggered D flip-flop is shown in relation to the clock signal in Figure…
A:
Q: 2. For the circuit shown below, calculate: a) The gain (G) of the amplifier associated with the 1.5…
A: For the above given operational amplifier circuit we need to derive gain and voltage VX.
Q: Find the Parallel Realization for Z² H(Z) (2-1) (2-0.5)
A: Find the parallel Realization for : Hz=z2z-1z-0.5 parallel form realization: Hz=H1z+H2z To get…
Q: i) Analyse and identify the types of the buses shown in the figure from the specification. 11/33 kV…
A: Given: Consider the following figure: To find: Analyze and identify the types of the buses shown in…
Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the ?second clock…
A: We need to find out output state of given counter
Q: A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…
A: Squirrel cage induction motor is good speed regulation and the harness of electromagnetism to…
Q: 14. Determine the Q waveform relative to the clock if the signals shown in Figure 7-83 are applied…
A:
Q: Example 3.8: ELECTRIC Consider the circuit in Fig. 16.12(a). Find the value of the voltage across…
A: For the above given question we need to calculate the value of capacitor voltage. With reference to…
Q: (8) A 600 ohm strain gage is connected into a bridge circuit with the other three resistors R1 = R2…
A:
Q: 1. Obtain the thevenin equivalent circuit at terminal a-b 8 ohms j2 ohms 8 ohms -j3 ohms 20<0 V…
A:
Q: X(s) + E(s) Figure 1 positive feedback control system G(s) H(s) Y(s)
A:
Q: Problem 2.. Determine the 3×3 bus admittance matrix Yous for the 3-bus circuit in the figure below.…
A: Solution- From the figure, First of all, All the impedances changes in admittance, Diagonal…
Q: Q31 27, and draw the impedance diagram. I, VVV in the phaser domain, and draw the phaser diagram.…
A: Series combination of impedances: Z=Z1+Z2+Z3
Q: Displacement current is taken to be negligible (compared to the conduction current) if .......... σ…
A: We know that , JcJd = σωε
Q: The main difference between a register and a counter is
A: ans:(d) register has no specific sequence of states
Q: 3. A 4-pole, single-phase, squirrel-cage induction motor operates from a 115 V, 50 Hz supply. The…
A:
Q: Q.3 The bode plot of the open-loop transfer function G(s) of a unity negative feedback system is…
A: The bode plot of the open-loop transfer function G(s) of a unity negative feedback system is…
Q: Using the laplace transformation table, evaluate the following, considering any other variable other…
A:
Q: the power factor and transmission efficiency to be the same in the two cases. B) Give a reasonable…
A: Given We need to enumerate few questions based on feeder and transmission design. Please find the…
Q: H.W : Find the Parallel Realization for. ; Z² H(Z) (2-1) (2-0.5)
A: For the above given question we need to perform the parallel realization of the given transfer…
Q: lectrical power (P) is given by P = E²/R, where is voltage and R is resistance. Approximate the…
A: Given that P=E2RE=200V R=200 ohm ∆EE=3%=0.03∆RR=4%=0.04
Q: * If X= (1100101)excess-3 X=(101)octal O X=(65)decimal O X=(110000)gray O X=(1000001) binay O none…
A:
Q: We have two small electric lamps on which it is written 8V, 1W. We have a 20V battery and negligible…
A: To solve above problem, we must know Ohm’s law and Kirchhoff’s law: Ohm's law state that in a…
Q: A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8% at…
A: Given data, A 3300/230 V, 50-kVA transformer percentage impedance = 4% and Cu loss = 1.8% at…
Q: Determine I in a circuit shown in figure 2.
A: this problem can be solved by using nodal analysis. In the nodal analysis we use KCL and ohm's law…
Q: If the initial content of a 3-bit ripple down counter is 000. fter the first clock trigger, the…
A: Ripple counter is also know as asynchronous counter. Here output of the 1st FF will be clk input for…
Q: 1. Matching of a transmission line with a characteristic impedance (Zo) and a load impedance (Zn)…
A: Characteristics impedance in transmission line : The ratio of the voltage and current amplitudes of…
Q: For the system in figure below if the input signal is unit-step, find (a) the output (b) the time…
A:
Q: Calculate the e.m.f. generated in the stator winding
A: Synchronous generator work on the principle of faraday's laws of electromagnetic induction. The…
Q: The characteristic equation
A:
Q: Show that x(t) = C₁e- Ÿ + 2r + r = 1 for any
A: In this problem: We know that solution of ODE equation is sum of complimentary solution and…
Step by step
Solved in 2 steps with 1 images
- A buck converter is supplied from a 50V battery source. Given L=400uH, C=100uF, R=20 Ohm, f=20KHz and D=0.4. Calculate: (a) output voltage (b) maximum and minimum inductor current, (c) output voltage ripplewhat is the Analysis of AC series Circuits using MATLABDesign a POWER SUPPLY with 5V output voltage. Use Ic as a voltage regulator. Then solve for theoretical computations. Thanks!
- a)Use the DC equivalent model to find the four quiescent operating parameters. b)Develop the AC equivalent model to find Zin, Zout, and Av. Assume β = 100.1) For the BOOST converter, a DC 50 Volt DC voltage of B Volt is taken into an A ohm load. If inductance current is continuous and operating frequency is 10 Khzc : 100UF ;(30) a) Draw the circuit diagram b) Find the work rate c)Find the minimum required inductance value d) Find the Imin and Imax valuee) Find the power consumed by the loadPlease solve this problem in detail A step up DC converter is used to control power flow from a DC votage Vs = 100V to a battery voltage E = 200V. The power transferred to the battery is 20 kw. The current ripple of the inductor is negligible. The duty cycle and the effective load resistance as seen from the input are respectively equal to: Select one: a. None of these b. 0.5, 0.5 Ohms c. 0.33, 0.5 Ohms d. 0.5, 0.33 Ohms
- Q.1. A power suppply having 220 V AC input and two fixed outputs as 10 V DC and 20 V DC is requested from you. For this purpose, a transformer with 220 V AC input / 15 V AC output, some capacitors, some silicon diodes, and zener diodes are presented.a) Design your power supply and point out DC voltage outputs b) Explain the operation of the network and all the components used in the design .c) Calculate and plot input and output signals of the network.Hint: For design, remember clipper, clamper, rectifier,voltage multiplier and zener circuitsAnalyze the following circuits below and write the required equation as stated in each figure and using the required ac theoremsDesign a buck converter such that the output voltage varies between from 20V to 28V while the input voltage is 40V. The maximum load power is 200Wde. Assume the switching frequency is 15kHz. (a) Design the converter such that it will be in continuous current mode. (b) The capacitor realized output voltage ripple must not be more than 1% at worst case. (c) The inductance realizes CCM at worst case. (d) Select the appropriate switch and other elements
- Design a full-wave AC to DC converter circuit to supply 50 W power to a 100 Ω resistive load from a source of 200V.V - Design an ADC circuit using OPAMP (using weighted resistors)With reference to the attached circuit image: If the capacitor is now removed from the attached circuit and is placed in parallel with the secondary of the transformer. A) What is the impedance seen at the supply (HV side) B) What is the power dissipated by the tube