A 150 microfarad capacitor is connected to a 220 - volt, 60 - cycle source. Calculate (a) the capacitive reactance, (b) the current in the circuit, (c) the average power taken by the capacitor, and (d) the maximum power delivered to the capacitor. C. A 150 – microfarad capacitor isconnected to a 220 – volt, 60 – cycle|source. Calculate (a) the capacitivereactance, (b) the current in thecircuit, (c) the average power takenby the capacitor, and (d) themaximum power delivered to theсарacitor.

A 150 microfarad capacitor is connected to a 220 - volt, 60 - cycle source. Calculate (a) the capacitive reactance, (b) the current in the circuit, (c) the average power taken by the capacitor, and (d) the maximum power delivered to the capacitor.

A 150 microfarad capacitor is connected to a 220 - volt, 60 - cycle source. Calculate (a) the capacitive reactance, (b) the current in the circuit, (c) the average power taken by the capacitor, and (d) the maximum power delivered to the capacitor.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: C1 (ii). Three Identical capacitors are connected in star to 410 Volts, F = 50 Hz, 3 phase supply.…

A: Capacitor are connect in star Voltage 410V Line Current = 12A Reactance and capacitance?

Q: An air-core toroidal ring with a mean diameter of 4 cm is wound uniformly with 500 turns of a wire…

Q: 23. A 150- microfarad capacitor is connected to a 220 V, 60- cycle source. Calculate a. The…

Q: Three 24uF capacitors are connected in star across a 415V, 50HZ, three-phase supply. What value of…

A: CAPACITORS IN SERIES: Two or more elements are said to be in series if the current flowing them are…

Q: If the transient response of a given system settles within 5% in 9.6 Sec then the extra time…

A: Given A given system settles within 59% in 9.6 Sec then the extra time required to settle within 2%…

Q: The capacitive reactance associated with a capacitor is 120 ohms when the frequency of the ac supply…

A: For a capacitor of capacitance C F, the capacitive reactance can be expressed as

Q: Calculate t for capacitors in parallel and series for charging and discharging

A: We need to find the time constant of the capacitors in parallel and series for charging and…

Q: A 22 mHmH coil whose resistance is 0.80 Ω is connected to a capacitor C and a 480 Hz source voltage.…

Q: 4.1Calculate the energy capacity and the capacitance of a super capacitor consisting of X metal…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: If a Marx generator is required to perform a 170 kV lightning impulse test, and you have capacitors…

Q: Three identical capacitors of 15 micro farad are connected in delta across a 435 volts, 50Hz, 3-…

A: Given Data: C=15μFV=435Vf=50Hz

Q: A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the…

Q: . For the circuit shown, what is the reactance of the capacitor? (Ohms) 2. What is the real power…

Q: After the San Onofre Nuclear Generating Station (SONGS) closed in 2012, the Diablo Canyon Power…

A: Given The plant has 2 pressurized water nuclear reactors. Each reactor can produce P1 = P2 = 1100…

Q: Determine the value of self inductance of a 6 cm long air cored solenoid, if the coil has 240 turns…

Q: Perform the following operations, including phasor diagrams where appropriate.

A: In this question we will perform given operations......

Q: What is the effect of connecting a bigger capacitor in the circuit? Comment from the result obtained…

A: The objective is to determine the effect of adding larger capacitor in the circuit.

Q: What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such…

A: The capacitor is required to inject reactive power into the transmission system.

Q: Provides current flow path to the filament of the tube at the initial time. ---

A: In the X-ray, the cathode, which sends electrons into the vacuum, and the anode, which collects the…

Q: Which of the following capacitors could be used to replace a 188-microfarad, 250-volt starting…

A: Obtain the charge stored by 188μF, 250 V capacitor; Q=CV =188μF×250 =0.047 C Calculate…

Q: 3. Write about the “Factors Affecting Transient Stability”

A: If the different producing stations regain equilibrium following periodic system interruptions,a…

Q: The process of initial start-up for a utility-interactive photovoltaic system is known as _______?…

A: The process of initial start-up for a utility-interactive photovoltaic system is known as…

Q: What two characteristics of capacitors enable them to help eliminate voltage spikes and surges?

A: Voltage surge and voltage spike is defined as high increase in voltage in very short duration of…

Q: Three identical capacitors of 10 micro farad are connected in delta across a 410 volts, 50HZ,…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 9. When a 60-volt, 60-hertz supply is connected to a capacitor, the current reads 0.6 ampere. What…

Q: A series circuit consisting of a 0.0795-henry inductor and a 177-microFarad capacitor is connected…

A: Indctive reactance =(2×pi×frequency×inductance). Capacitor reactance…

Q: Outer radius ?2 = 50 ??, puncture of air in a concentric spherical electrode system resistance is ??…

A: Given: r2=50cm Ed=30KV/cm V=200KV

Q: 1. An inductor has an inductance of 0.65 henry and is connected to a 277 volt, 60 Hz line. How much…

Q: What is the effect of connecting a bigger capacitor in the circuit?

A: According to question, What is the effect of connecting a bigger capacitor in the circuit?

Q: any google sho8 optimal capacitor replacement, and summarize it in 2 or 3 pages . Notes : 1- the…

A: The matter may be thanks to optimally confirming the locations to place in (or replace, or remove)…

Q: An inductor has an inductive reactance of 250 Ω when connected to a 60-Hz line. What will be the…

Q: A series resistance-capacitance (RC) circuit is connected to a 230 Volt, 60 cycle source. If the…

Q: An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henry is connected in…

A: Given -: All the resistance, inductance & capacitance are connected in series hence the same…

Q: motor with 1mH of inductance and an unknown internal resistance is connected to a 100V RMS 10kHz…

Q: ortion issues in a mechatronic system, otherwise known as an Impedance Matching Circuit. Figure…

Q: Consider the Capacitance = 10uF, Vpeak of +13v during the positive half cycle and -7v during the…

A: Since you have asked a question with multiple sub-parts, we will solve the first three parts for…

Q: What is the effect of connecting a bigger capacitor in the circuit? Comment from the result obtained…

Q: For a star connection network, consuming power of 1.8kW and power factor 0.5, compute the inductance…

A: In a three phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: The capacitive reactance of a circuit is 60 ohms, when it is supplied with a 50 Hz supply. What will…

A: Given, Capacitive reactance, XC1=60 Ω Frequency, f1 = 50 Hz Capacitive reactance, XC2=? Frequency,…

Q: capacitor is connected to a 208-volt, 60-Hz power source. An ammeter indicates a current flow of…

A: The solution can be achieved as follows.

Q: The voltage generated by using an MHD system is dependent upon the speed of the conductive gas.…

A: This statement is true or false The voltage generated by using the MHD system is dependent upon the…

Q: A choke coil of resistance 8 ohm and inductance 0.15 H is connected in series with a capacitor of…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Three identical capacitors of 15 micro farad are connected in star across a 425 volts, 50HZ, 3-phase…

A: Three identical capacitors are linked in a star configuration with a supply voltage of 400 volts,…

Q: Example of electrical field capacitator in daily lives

A: The energy is stored in the electric field of the capacitor. The capacitor is mostly used in the…

Q: Write a technical report about the application of reactors and capacitors in power and distribution…

A: Inductor in power power distribution has many applications like storing energy and something the…

Q: An inductor has an inductive reactance of 250 ohms when connected to a 60-Hz line. What will be the…

A: The solution can be achieved as follows.

Q: Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running…

A: The following conditions must satisfy while replacing the running capacitors. A. Voltage of the new…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

C. A 150 – microfarad capacitor is
connected to a 220 – volt, 60 – cycle
|
source. Calculate (a) the capacitive
reactance, (b) the current in the
circuit, (c) the average power taken
by the capacitor, and (d) the
maximum power delivered to the
сарacitor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

-) The active and reactive power drawn by the mixer fed from a 230 Vrms, 50 Hz single phase AC network was measured as 600 W and 100 VAR, respectively. According to this information: a) Calculate the apparent power drawn from the network? b) Calculate the current drawn from the network? c) Calculate the cos(a).
Discuss the challenges and solutions related to power system stability and control, especially in the presence of renewable energy sources.
If the Reactance of the cylindrical rotor machine connected to an infinite bus bar is double that of the external reactance of 0.5.p.u. If the power angle is 35°, real power output is 0.8, compute the excitation voltage, and for the same power output, if the load angle is reduced by 10 degrees, find the external reactance to achieve this.
Power System Analysis Please solve the question quickly
1. Find the required single-phase excitation voltage at rated voltage and frequency, in Volts 2. Find the required single-phase excitation voltage when both terminal voltage and frequency are 80% of their rated values, in Volts
An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henryis connected in series with a variable capacitor. If a 117 volt 60 cps source isconnected to the circuit, what will be the capacitance of the capacitor and the current(a) when the circuit has a power factor of 0.866 leading and (b) when the voltagedrop across the coil is equal to the voltage drop across the capacitor?
I want a solution in less than 30 minutes Often, the network is referred as an infinite bus when a change in input mechanical power or in field excitation to the unit does not cause an appreciable change in a. system frequency or terminal voltage b. Total production cost c. system frequency and terminal voltage d. system frequency alone
A 15kVA, 440V, single-phase alternator draws a field current of 5A at rated load. With the same field current, the open circuit emf and short-circuit current are 100V and 80A respectively. The ohmic resistance of the armature between terminals is 0.12 ohm. The ratio of effective to ohmic resistance maybe taken as 1.1. Determine the voltage regulation (in %) when the load is purely resistive.
Discuss the challenges and solutions related to integrating renewable energy sources into a traditional power system.
Describe the primary components of a typical power system.
An industrial plant consisting primarily of induction motor loads absorbs 500 kW at 0.6 power factor lagging. (a) Compute the required kVA rating of a shunt capacitor to improve the power factor to 0.9 lagging. (b) Calculate the resulting power factor if a synchronous motor rated at 500 hp with 90 efficiency operating at rated load and at unity power factor is added to the plant instead of the capacitor. Assume constant voltage (1hp=0.746kW).
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to