9. When a 60-volt, 60-hertz supply is connected to a capacitor, the current reads 0.6 ampere. What is the capacitance of the capacitor?

Q: connected to a capacitor, the current reads 0.6 ampere. What

A:

Q: Which type of power supply is required to power up a LVDT? does not matter AC no power supply…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Considering that the power loss of a resistor is RI^2 and the information in the manual’s background…

A:

Q: kindly Briefly explain the opacity and translucency in insulators. thank you!

A: The insulators in which light can pass partially, or we can see partial through the insulators, they…

Q: Write a question appropriate for this course about the amount of charge stored in a large capacitor…

A:

Q: 6. What are the advantages and disadvantages of supercapacitors?

A: We have given the following problem What are the advantages and disadvantages of supercapacitors?

Q: A string of three insulators has a self capacitance of 10 times its pin-to-earth capacitance. Then…

A:

Q: 5. A string of 4 insulators has self-capacitance equal to 4 times the pin-to-earth capacitance.…

A: First we will find reletion between voltage across various units in terms of given capacitance ratio…

Q: A constant current of 2 micro - ampere charges a capacitor for 20 seconds, how much  charged is…

A: charge of capacitor Q = ∫0ti(t) dtGiven i(t) = 2 μA and time t = 20 seconds

Q: Explain (in your own words) what is meant by the terms, effective current and  effective voltage.…

A:

Q: What is embedded system?Also discuss the various applications of Embededded system.

A: we need to answer what is embedded system and also have to discuss the various applications of…

Q: a midday if the instantaneous irradiation is 800 W/m2? this power is focused in a small area of S cm…

A: Given,   Radiation =R =800 W/m2 dish (concentrator) diameter d1=10 m receiver area diameter d2 =5 cm…

Q: i. Draw the block diagram of a solar Photo-Voltaic system with the stand by diesel generator and…

A: i) The off-grid solar Photo-Voltaic system will use the battery to store the energy. If the battery…

Q: A 10-volt battery is applied across a certain parallel-plate capacitor. If the capacitor was able to…

A:

Q: Provides current flow path to the filament of the tube at the initial time. ---

A: In the X-ray, the cathode, which sends electrons into the vacuum, and the anode, which collects the…

Q: Calculate the value of the diffusion capacitance for a power transistor operating at a current of 10…

A: Given: πF=4 nS Ic= 10 A T=100o CHere, =100+273 K=373 K

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 6 A, 9 A, and 13…

A:

Q: When checked with an ohmmeter, how should a properly functioning capacitor respond

A: The explanation is as follows.

Q: The energy dissipated in a circuit is rated at 240 microJoules. If the supply voltage is given to be…

A:

Q: With reference to energy conversion process, write the difference between Solar Power Tower system…

A:

Q: 2. Identify the location and summarize the purpose of each of the following: а. Piezoelectric…

A: Here it is asked to identify the location and the purpose of each of the given elements. So weed to…

Q: If the value of the thermal voltage is 25.5 mV, then estimate the ambient temperature. Assume…

A: Thermal voltage is a very important parameter in semiconductor devices. It is a function of…

Q: For the circuit shown in the figure, ?0=100ϵ0=100 Volt, ?1=50ΩR1=50Ω, ?2=100ΩR2=100Ω, ?=2??C=2μF.…

A:

Q: Explain (in your own words) what is meant by the terms, effective current and effective voltage

A: In this question, Explain  what is meant by the terms, effective current and effective voltage.

Q: any google sho8 optimal capacitor replacement, and summarize it in 2 or 3 pages . Notes : 1- the…

A: The matter may be thanks to optimally confirming the locations to place in (or replace, or remove)…

Q: Determine the transition temperature and critical field at 4.2 K for a given specimen of a…

A: Given Hc(T1) =1.41×105 A/mHc(T2)=4.205×105 A/mT1=14.1 kT2=12.9 k

Q: A series resistance-capacitance (RC) circuit is connected to a 230 Volt, 60 cycle source. If the…

A:

Q: parallel plate capacitor of 5 plates, each of one square meter of area and placed at a distance of…

A: We need to find out stored energy

Q: 13.A 230-volt d-c source is suddenly applied to a series R-C circuit. (a) If the capacitor is…

A: In this question, we need to determine the voltage across the capacitor after t= 1.75tao and t=…

Q: Three lamps are connected in parallel to a 115 volt, 60 Hz voltage source. If the lamps have ratings…

A:

Q: 1.1 Characterise two cathode processes in gas discharges. 1.2 Give a detailed explanation of the…

A: Cathode fall region in high-level voltage low-level current gas discharge. Explicit expressions for…

Q: How to compute the atomic packing factor for the diamond cubic structure? detailed example with…

A: The equation for packing fraction is: Packing fraction =N atoms x V atom V unit cell N atoms is…

Q: discuss the refrigerator

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: ood day! Can anyone help me design a lattice - type balanced modulator (just a simple one) Thank you

A: The carrier is missing from the output waveform, yet it still retains all of the information…

Q: A coil rated 300 Watts, 230 Volts, 60 Hz has a resistance of 70 Ω. What is the inductance of the…

A: Wattage = 300 Watt, Voltage (V) = 230 Volts, Frequency F = 60Hz, R = 70 ohm,  To calculate…

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 1 A, 5 A, and 15…

A:

Q: A McLeod gauge has a capillary of 1 mm diameter and a bulb of 100 cubic centimeter. Calculate the…

A: Given:Volume  of bulb, VB=100 cm3=100×10-6=10-4 m3Capillary  diameter, d=1 mm=10-3 mmCapilary…

Q: calculate the voltage drop with a 210 ft thhn wire from a 380 watt rec alpha photovoltaic plate.

A: According to the question, we need to find the voltage drop across the 210 ft thin wire from the…

Q: A 150 microfarad capacitor is connected to a 220 - volt, 60 - cycle source. Calculate (a) the…

A: The solution can be achieved as follows.

Q: .) An incandescent lamp, rated at 100 watts, gives a certain amount of light when placed across the…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: A string of 4 insulators has self-capacitance equal to 4 times the pin-to-earth capacitance.…

A:

Q: Assuming that there is no initial charge on the capacitors, compute the value for Vc if the switch…

A: When switch is moved to position 1 the circuit is

Unijunction Transistor (UJT)

The Unijunction Transistor (UJT) is a three-terminal switching semiconductor device. It contains an n-shaped silicone object bar with a terminal attached to its two ends known as base one and base two. The third terminal is connected to a highly enclosed p-type material attached to the bar section of its length and is known as emitter. As there is only one corrective cross within the device, it is therefore called the 'Unijunction' transistor. The characteristics of the single junction transistor show the wrong resistance if it finds use in resting oscillator circuits for various applications.