A 2.00-m-long cylindrical steel wire with a cross-sectional diameter of 4.00 mm is placed over a light frictionless pulley, with one end of the wire connected to a 5.00- kg object and the other end connected to a 3.00-kg object. By how much does the wire stretch while the objects are in motion

Q: If you hold your arm outstretched with palm upward, as shown, the force to keep your arm from…

A: a) Sum of moment about '0' is zero .   ΣMo=0   F sin 150.17-4x9.81x0.38=0…

Q: A 5.0-m long, 12-kg uniform ladder rests against a smooth vertical wall with the bottom of the…

A: First of all we will see the forces acting So, Forces in the x direction Fx=0 is equal to the force…

Q: The following setup of masses is hung (las) to a fixed ceiling as shown in the figure below. If M, =…

A: Here, a figure is given, showing a setup of masses hung from the ceiling. It is also given that M1…

Q: A 100 N picture hangs from a nail in the wall. The diameter of the nail is 3.00 mm. The shear stress…

A: Write the given values with the suitable variables. F=100Nd=3 mm=3×10-3 m Here, F is the force and d…

Q: 14. A 10.0-kg monkey climbs a uniform 2C ladder with weight 1.20 × 10² N and length L = ure P12.14.…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: 1. The rigid homogeneous concrete slab weighing 800 kN is supported by three (3) rods of identical…

A: The axial forces ineach member will bedistributed on the basisof their axial rigidity.Let axial…

Q: (a) Find the tension in the strap.  N (b) Find the components of the reaction force exerted by the…

A:

Q: A tow truck is pulling a car out of a ditch by means of a steel cable (Y = 2.0 x 1011 N/m2) that is…

A: Given that, Young's modulus of steel =2.0×1011 N/m2 Length of the wire  = 9.70 m Radius of the wire…

Q: Use the stiffness method to calculate the member forces in the structure shown in Figure P1.9. E = 2…

A:

Q: A steel wire 2.3 mm in diameter stretches by 0.030% when a mass is suspended from it. How large is…

A: The Young's modulus is given by  where, M is the mass, g is the gravity, A is the area, L is the…

Q: The boom in the figure is 2m long and weighs 100 N. If the 800N load is suspended 50cm from the end,…

A:

Q: For safety in climbing, a mountaineer uses a nylon rope that is 55 m long and 1.5 cm in diameter.…

A:

Q: Choose from the following choices the correct answer for the elastic modulus that describes the…

A: (i) A block of iron is sliding across a horizontal floor. The friction force between the block…

Q: A 0.600-mm diameter wire stretches 0.500% of its length when it is stretched with a tension of 20.0…

A:

Q: 2. A 50.0 kg uniform square sign, of edge length L=2.00m, is hung from a horizontal rod of length of…

A:

Q: A glass optical fiber in a communications system has a diameter of 9.0 μm. What maximum tension…

A:

Q: What is the tension force in the wire shown below if it stretches 0.35 cm when tightened if young's…

A:

Q: A particular human hair has a Young's modulus of 3.31 x 10° N/m2 and a diameter of 145 um. If a 236…

A:

Q: A steel cable 1.70 m in length and with cross-sectional radius 0.380 mm is used to suspend from the…

A: Length of cable (L) = 1.70 m cross sectional radisu (r) = 0.38 mm mass (m) = 20 kg angular speed =…

Q: A mine elevator is supported by a single steel cable 2.5 cm in diameter. The total mass of the…

A: The expression for the elastic module,

Q: Shown is a lightweight plank supported at its right end by a 7.0-mm-diameter rope with a tensile…

A: Given data: The diameter of the rope is: d = 7 mm The tensile strength of the rope is: T = 6.0×107…

Q: An 11.2-kg stone at the end of a steel (Young's modulus 2.0 x 1011 N/m²) wire is being whirled in a…

A:

Q: The elastic limit of an alloy is 5.0×108 N/m2. What is the minimum radius ?min of a 9.0 m long wire…

A: ...

Q: After a fall, a 99 kg rock climber finds himself dangling from the end of a rope that had been 15 m…

A:

Q: A mass is hung from identical wires made of iron, lead, nickel, steel, and brass. Which wire will…

A:

Q: After a fall, a 100 kg rock climber finds himself dangling from the end of a rope that had been 16 m…

A:

Q: An amusement park ride consists of airplane-shaped cars attached to steel rods. Each rod has a…

A:

Q: 11.46 * A uniform, 8.0-m, Figure P11.46 1150-kg beam is hinged to a wall and supported by a thin…

A: Given: The total length of the bar is L=8 m. The free length of the bar is L’=2 m. The mass of the…

Q: Two 20 kg blocks are connected by a 2.0-m-long, 5.0-mm-diameter rope.  Young's modulus for this rope…

A: Given data: Mass m1=m2=20 kg Length of the rope l=20m Diameter of the rope d=5.0mm Young's modulus…

Q: After a fall, a 99 kg rock climber finds himself dangling from the end of a rope that had been 14 m…

A:

Q: The left-hand end of a 2.50 kg rod with a 2.00 m length is attached to a vertical wall by a hinge. A…

A:

Q: Two plastic toys are hung from the ends of a uniform rod of mass 20.0 g and length 0.500 m to form a…

A: Mass of uniform rod (M) = 20 g Length of rod (L) = 0.50 m Mass of toy on left end (m) = 5 g mass of…

Q: A 70.0 cm, uniform, 40.0 N shelf is supported horizontally by two vertical wires attached to the…

A:

Q: A horse weights 5000 Newtons. The distance between the front and rear hooves is L1= 1.8 meters and…

A: The torque (τ) about the rotation axis is given by the product of the perpendicular force (F) that…

Q: A uniform barbell has length 1.5 m and mass 60 kg. Your left hand is placed 25 cm to the left of the…

A:

Q: After a fall, a 99 kg rock climber finds himself dangling from the end of a rope that had been 15 m…

A:

Q: A cable is 100 m long and has a cross sectional area of 1 mm^2. A 1000 N force is applied to stretch…

A: The expression for find stretched length of the cable is Y=FA∆LL0∆L=FL0YA

Q: accelerates at a rate of 4.2 m/s^2 when it realizes that it is hooked. You only used fishing line…

A: The tensile strength is the resistance of a material to break or undergo any deformation , here ,the…

Q: What does the stress in a composite beam depend on? O the modulus of elasticity of both materials…

A: The stress in a composite beam is given by   where I1 and I2 are the moments of inertia about the…

Q: A certain rod stretches 0.90 cm when outward forces with magnitude F are applied to each end. The…

A:

Q: Two plastic toys are hung from the ends of a uniform rod of mass 20.0 g and length 0.500 m to form a…

A:

Q: In a skyscraper, an elevator is suspended from three equal, parallel 300-m-long steel cables, each…

A: Young's modulus of steel = 2 * 1011 N/m2Length of each cable = 300 m Diameter of each cable = 1 cm…

Q: After a fall, a 110 kg rock climber finds himself dangling from the end of a rope that had been 14 m…

A:

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).