a) 200 -ton , nominal rating crawler-mounted crane with 180 ft of boom has a radius of 60 ft what is the lifting capacity? b) What is the travel time for a scraper moving at 21 mph over a distance of 0.587 mile?

Q: 24- Which of the following is a representation of a urbanSidewalk assembly? A) B) C) D) 4.00:1…

A: 24. Option D is correct,it represents the urban sidewalk assembly. Because A represents Urban…

Q: Why is it important to know the specific gravity of cement

A: Specific gravity is the ratio of weight of material and water having equal volumes.

Q: The simply supported beam consists of a W21 × 44 structural steel wide-flange shape [E = 29,000 ksi;…

A:

Q: 1. Using the method of superposition, find the deflection at a point midway between the supports of…

A:

Q: List four HMA mix design properties (sot aggregate properties) in Superpare mix design procedure?

A: Need to find the 4 Mix design properties in Superpave mix design procedures:

Q: Determine end reactions for Beam B-1 and Girder G-1. L1 B-1 I I G-1 H • L1= 24 ft • L2= 6 ft Live…

A: One end reaction for B - 1 = Load on beam / 2 Load on beam B - 1 = ( Total load * L2 * L1 ) + (…

Q: The line connecting PC to PT is equal to 123 m. If this line makes an angle of 11.2° with the back…

A:

Q: 72 72 36 36 -57 57 Dimensions in millimeters Answers: 1x = i (106) mm4 (106) mm 4

A:

Q: Determine the design strength for the bearing connection shown in the figure. Use A36 steel, 22mm…

A: ASD: ASD means Allowable Stress Design. In this method, the service loads are applied to the…

Q: Water flows in a triangular V-notch steel channel, with vertex angle of 75 degrees, at a velocity of…

A:

Q: BROBIBRE WITH Ris off road vehicle. To hold it in place the camper wraps a rope abound a treen+…

A: using eulers-Eythelwin equationT2=T1eμθgiven T1=53NT2=2550Nμ=0.20so,2550=53e0.20θe0.20θ=255053apply…

Q: use the three fundamental equations , to solve head losses numerical problems. A discharge of 750…

A: Q=750L/s D=400mm L=65m

Q: ANALYSIS OF DOUBLY REINFORCED CONCRETE BEAM. Compute the flexural strength of the beam. Given:…

A: INTRODUCTION: Doubly design of beam is generally done when there is requirement of more strength to…

Q: Draw the isometric figure of the given multiview projection.

A: Solution-The given diagram is shown below, To Determine,  Draw the isometric view,

Q: The total active thrust on a vertical wall 3 m high retaining a horizontal sand backfill (unit…

A:

Q: design of singly reinforced concrete beam design the reinforcement. fc' = 28 MPa fy = 414 MPa WD = 4…

A:

Q: 4) Vertical Curves Design the vertical curve for every 50 foot station if ... PVI is at11+02.43 PVI…

A: Given:- The incoming grade of curve = +6% The outgoing grade of curve = -2% The stationing of point…

Q: 77 mm 77 mm Answer: Ix= i 53 mm (106) mm4

A: To find out the moment of inertia of shaded region.    We will used parallel axis theorem.  Parallel…

Q: 1. What are the purposes of a transportation system in a region or a nation? 2. If you were asked to…

A: Note : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Knowing that the pulley has a radius of 75 mm, determine the components of the reactions at A. B 125…

A:

Q: Engineer B is director of engineering with a large government agency that uses many engineering…

A: Solution- The moral concerns raised in this circumstance are more directly related to troublesome…

Q: The following are the results of four drained direct shear tests on undisturbed normally con having…

A:

Q: Search for instances or reasons why material te is needed on the construction site. Be sure to si

A: To create a building, road, bridge, or pavement, raw materials such as cement, steel, concrete,…

Q: Determine the absolute maximum shear stress for each of the following plane stress states for which…

A: Determine the absolute maximum shear stress for each of the following plane stress states for which…

Q: Problem # 1: The two rods as shown in the figure are attached to each other and the aluminum rod is…

A:

Q: Q4 A single rolling load of 20 kN rolls along a girder of 25 m span. Draw the diagrams of maximum…

A:

Q: n Q kN/m

A:

Q: (57) A column carrying an axial load of 3000 kN has a base plate 0.75 m X 1 m and transmits its…

A:

Q: Determine the force in Member CE of the truss shown. Determine whether the member is in tension or…

A:

Q: A rolled steel joist is simply supported at its end and carries a uniformly distributed load which…

A: GIVEN: slope=.002 radian and deflection = 10mm and the steel joist is simply supported

Q: The beam shown is part of a braced frame system and has the resulting moment diagram shown. If the…

A: Solution-The given values are as follows,Mu=450kip-ftPu=100Length = 22ft  The Unbraced length = 22/2…

Q: Select sizes with LRFD expressions and check the selected sections with both the LRFD and the ASD…

A: Given: Dead load, Pd = 45 k and Live load, Pl = 25 k For A36 Steel, Fy = 36 ksi, and Fu =58 ksi

Q: The given frame is subjected to the applied loads P and Q. Note that members ABC and CDE are…

A: Free Body diagram: A free body diagram is a diagram of the body which represents the magnitude and…

Q: QUESTION 1 Which of the following statements is false? O a. Bent trees can cause slope of grain in…

A: Timber- It is a type of wood. Timber is used for building construction of houses, furniture, etc.…

Q: 70 22 D 42 36 33

A: The three views are shown in the next step

Q: Problem 6: Determine the contact pressure at point O under the column. 2m P=800kv My = 120kv.m…

A: Point O lies at centroid and point of symmetry. There will be no effect due to Mx and My.

Q: The steel bat All has a rectangular cross section (E1) Figure 3m -20 mm 30 mm 20 mm tof 1 Part A it…

A: The load acting at on the column AB through the beam BC is given by (wL/2) = (w x 5 /2…

Q: The strain components for a point in a body subjected to plane strain are &x=210 μe, &y=260μe and…

A: Given, Plane strain in x direction εx=210 με Plane strain in y direction εy=260 με γxy=-1009 μrad

Q: A soil profile is shown in the following figure. A new footing will be placed on the ground and the…

A:

Q: The simply supported beam consists of a W14 × 34 structural steel wide-flange shape [E = 29,000 ksi;…

A:

Q: Water flows freely from the reservoir shown through a 50-mm diameter pipe at the rate of 6.66…

A: To find the elevation of water surface in the reservoir

Q: 1000 lb ↓ 350 lb/ft ↑ R₁ 5 ft 8ft 1800 lb 200 lb/ft 8ft

A:

Q: DOUBLY REINFORCED CONCRETE BEAM.

A:

Q: Use local linear approximation to estimate In(1.08)

A: This is done by using the taylor series expansion of ln(1+x).  For linear approximation we can…

Q: The simply supported beam consists of a W14 x 34 structural steel wide-flange shape [E = 29,000 ksi;…

A:

Q: For a catchment in India, the mean monthly temperatures are given. Estimate the runoff and annual…

A: We have to use Khosla method

Q: Solve the problem by the moment-area method. The beam has constant flexural rigidity EI. A simple…

A:

Q: Question 5 (a) Estimate the depth of evaporation (in mm units) that can be expected to occur over a…

A: Solution Evaporation depth, E = Hn-Hg-Hs-HiρL(1+β) Where, Hn -Hg = available energy = 800 W/m2 = 800…

Q: The simply supported beam consists of a W14 x 34 structural steel wide-flange shape [E = 29,000 ksi;…

A:

Q: In the Hirakud hydroelectric power station, there are four Kaplan and two Francis turbines,…

A: please look into the handwritten solution provided below;

Pricing Construction Equipment

Pricing construction equipment means estimating the cost of operation of all the construction equipment used in a construction project. The pricing is done based on two factors – ownership cost and operating cost of the equipment. Thorough knowledge of the ownership and operating costs is necessary for proper project management and executing profitable construction.