A 22 20 4A 24V 0.3V1 B.

Q: PROBLEMS 339 FIGURE 8-75 R3 330 N R2 220 N R4 470 2 100 mA 680 N 20 V= figure for Superposition Theo...

A:

Q: An ideal inductor of 50 mH is connected in series with a 175 microfarad capacitor. The combination i...

A: Current is leading when capacitive reactance is more than inductive reactance.  From given values fi...

Q: Find the correct expression of Vout in the given circuit.

A: Apply KVL in loop to find the current in series connected circuit,  using ohms law find output volta...

Q: 6 The area to be considered in using Gauss's Law should be the one where the electric field is perpe...

A:

Q: Find the cross-sectional area of a round conductor in square mils if the conductor's diameter is 11/...

A: Given  Diameter of round conductor is d = 11/16. Fnd area of round conductor in square mils.

Q: 1 The force of an electrostatic field f (x, y, z) has the direction of the gradient of f. Find Vf an...

A: Given  1. f = (x-1)2- (y+1)2, P(4,-3)  Find gradient of f and find its value at point P(4,-3). 2. Fi...

Q: What is the difference between time and frequency domain?

A:

Q: Why is the circuit under damped? Explain.

A:

Q: What is the total gain of amplifiers with a power gain of 6, 8, 5 when connected in series? O 1) 24 ...

A: Given: The gain of individual amplifiers connected in series, A1=6A2=8A3=5  

Q: A magnetic vector potential A is defined as; - a, Wb/m %3D The total magnetic flux o crossing a surf...

A: Using above identities flux = surface integration (B.ds) Where B = curl (A).

Q: Transform the vectors F 10 a, to spherical coordinates at (4, 110°, 120°)

A:

Q: A bacterial population Y is known to have a rate of growth proportional to Y itself. If between 11am...

A:

Q: When the series combination of R1 and R2 is connected across a 30 V battery, the current drawn is 10...

A: Given

Q: Problem 5. while that of the other is -0.43m/s. If the collision is perfectly elastic, what is the f...

A:

Q: 3. Draw the circuit for the following output. Show your complete analysis. ", - +E

A: The solution is given below 

Q: 21. Given a capacitance of 30 nF and a voltage of 30 J, compute for the charge and energy.

A:

Q: Using the following matrix, please come up with a state space representation with the following para...

A: Output response is given asy1t=2θ1ty2t=4θ1t+3θ2t+ςty1ty2t=2043θ1tθ2t+01ςt-----1This is state space r...

Q: A multiple choice examinations has 200 questions each with 4 possible answers of which only one is c...

A:

Q: Given the circuit below. i, (t) = V210 cos(377t). Give your answer in four decimal places if it is n...

A:

Q: V3 A R1 R3 R5 10 V1 12 R2 R4 V2 20 Reference Node 12

A: The given circuit diagram is shown below:

Q: In an AC circuit, the load has a supply voltage of 240 cos(800πt + 60) volts and a current of 120cos...

A:

Q: A magnetic circuit has a 20 V battery connected to an 80 2 coil of 800 turns with an iron bar of 2 m...

A:

Q: An impedance coil takes 10 A and absorbs 250 Watts when connected across a 220 V, 60 Hz source. What...

A: This question belongs to circuit theory . It is based on the concept of power consumed across the re...

Q: 3. The equivalent resistance between points 1 and 2 of the circuit shown is: 2 bentsnicus

A: If two resistors R1 and R2 are connected in series than equivalent resistance is R1 +R2.  If two res...

Q: A coil connected in series with a resistance are supplied from a 240 volts 60 Hz source draw 1.0 amp...

A: Here, we have given a circuit where, the resistor and the inductor are connected in series.  The sup...

Q: Magnetic fields are characterized by the existence of a detectable magnetic force at every point in ...

A: According to the question, Magnetic fields are characterized by the existence of a detectable magnet...

Q: 1. For the following circuit assuming ideal OpAmp, what resistor is needed for Rf to have a gain of ...

A:

Q: (b) Explain the steps involved in analysing balanced bolted fault in power system using Zbus method,...

A: Admittance matrix and impedence matrix is very important to analyze the power system .Admittance mat...

Q: Given vectors A = 2a, + 4a, + 10a, and B — 5а, + ag — 3а,, find The angle between A and B at P Р(), ...

A: This problem comes under electrostatics . It is based on the basic laws of vector . With the help of...

Q: Calculate the value of total current for the circuit. Please

A: In this question we will find current flowing through capacitor....

Q: A 40 micro-farad capacitor is connected in series with a 40 ohm resistor. If the voltage is 220-V, w...

A: Series circuit consists of  Voltage, V = 220 V  Capacitance, C = 40microF  Resistor, R = 40 ohm  Fin...

Q: 5. Trace and discuss the power train of a four-wheel tractor and power tillers. Discuss how power is...

A: due to rules i can answer only one question at a time. so am answering the 5th question. please uplo...

Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...

A: EQUIVALENT RESISTANCE    Equivalent resistance is the sum of the resistance  connected either in ser...

Q: The transfer function of an RC circuit is given as G,(s) = RC- where R= 100 x 102 and C = 0.1 x 10-F...

A: Voltage across the capacitor during charging is vC(t) = V (1 - e-tRC)   ... (1) Voltage across the c...

Q: lculate the core area in Cm 2 required for a 1600kVA, 6600/440 V, 50Hz single phase transformer. Ass...

A: Given data : Emf induced per turn : EN=30VFrequency f=50 HzFlux density, B=1.2 Wb/m2 emf induced in ...

Q: В8. For the circuit shown in Figure B8, calculate: (a) the frequency and period of the supply voltag...

A:

Q: in 6 4 2 IL R1 R2 R3 V1 12 R4 12 6 11 RL 6

A: SOLUTION- for the source transformation,    

Q: Write atleast 3 application of PLC in industries.

A: solve ques..

Q: 3. For the following problems there is no need to consider the position vector. Simply find the magn...

A: Note: It is mentioned in question answer 3 so i am answering 3rd question. (a) Given data, Point cha...

Q: Given the circuit below. i, (t) = v210 cos(377t). Give your answer in four decimal places if it is n...

A:

Q: The hysteresis loop of the core material of a transformer should have (a) a large area (b) a small a...

A: When a transformer is in use, its core is taken up by many complete magnetization cycles. During eac...

Q: Region 1 (y 0) contains dielectric medium with e = 6 E, and p2 = 2.75 Ho- Draw a figure which defin...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: Find the z-transfer function Y(z)/U(z). u(t) -2T: 1 – e s(s + 1)

A:

Q: Problem 2 A capacitor is used to correct the power factor of the load of the following figure. Deter...

A: Capacitance value not given It might be 50 Hz or 60 Hz  So taking both the cases... It is a simple s...

Q: Question 4b Magnetic fields are characterized by the existence of a detectable magnetic force at eve...

A: According to the question, we need to discuss one of the industrial applications of the magnet.

Q: If J = r sin 0 cos o a, cos 28 sin o a, + tan In ra, at T(2, a/2, 3r/2), determine the vector compon...

A: The solution is given below 

Q: An OpAmp-based amplifier is shown below. Each resistor R - 10 kn (1) Suppose OpAmp was ideal, please...

A:

Q: 10V 3V 50 20 |

A:

Q: A resistance of 10 Q and a capacitance of 100 µF is connected in series to the parallel combination ...

A:

Q: For two charges Q at (4,0,-3) and Q, at (2,0,1), find Q if Q, = 4 nC for force F at (5,0,6) has no x...

A: Since you have asked multiple questions, we will solve the first question for you . If you want any ...

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.