A 240v 3phase circuit has a current of 116 amps. A wattmeter connected to the circuit indicates a load of 34.7 kilowatts. What is the power factor? How many capacitive VAR would be needed to correct the power factor to 95%?

Q: 19 Three parallel loads drawing 3 kW, 5kVA at 0.866 PF lagging and 4 kVA at 0.707 PF lagging are…

A:

Q: - previous 4- If VI 400V and the wattmeter read 800W at no load test then the value of Ro is b)40052…

A:

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 - j6.5)A and (1.8 –…

A: Since you have asked for question 10 . So we are providing solution for question 10 . This question…

Q: A star connected 3 phase resistive load each of resistance 30 ohm is connected to a 3-  phase…

A: For AC power distribution, the star connection (Y) method, also known as the three-phase four-wire…

Q: The power measured with the help of a single phase one wattmeter method in a balanced three phase…

A: We will try to find the power of the 3-phase circuit by the following analysis.

Q: Three heater units each taking 1, 500 watts are connected delta to a 120 Volt three phase line. What…

A: Answer -

Q: Determine the power angle in the series circuit which consists of R = 25 ohms, L = 0.123 H and C =…

A: Given Data: R = 25 ohms L = 0.123 H C = 123 uF V = 200 V f = 30 Hz

Q: The current through the current coil of wattmeter is 2+3cos(t-30o) and voltage across it's pressure…

A: Given: Current i=2+3cost-30° A and Voltage v=1+4sin2t-30° V

Q: Based on the Figure 4.1, calculate the voltage across the resistor, the real power and reactive…

A:

Q: If the power factor is 1/10 and the value of impedance is 20 ohm, calculate the resistance in the…

A:

Q: Page Use node veltage method to Calcelate the power delivered by the dependent Voltage soUsce in the…

A:

Q: i(t) 42 v(1) 0.9H For the accompany circuit, if the source voltage v(t) = V 2 95 cos(12t) volts what…

A: Given, Source voltage, vt=2×95cos12t volts

Q: es the wattmeter has resistance and resistance halwlate the Percentage error if the Wattmeter is So…

A: When the current coil is connected near to the load then error in power measurement =I2 RC When the…

Q: A balance delta connected load draws 10Amps of a line current and 3kw  at 220v. What is the…

A: The solution is given below

Q: A plant has a load of 290 kilowatt with an average power factor of 70%. The owner request you to…

A:

Q: Two types of connections of Wattmeter pressure coil are shown in the figures. 20 A ll V 10 k2 20 A V…

A: we need to determine r which makes the connection error same.

Q: Narb = 4OV WHAT Is THE VALUE OF Rab AnD ċ ? 202 Rab

A:

Q: Q. No. 9. Sketch vo for the network of Figure given below. 100 V 83 KA -100V Answer:

A: We need to check which diode will be on or off given positive and negative cycle of input .

Q: From the circuit diagram of power measurement using two wattmeter for delta connected load in…

A: Two wattmeter connection is used for measuring the three phase power of circuit This two wattmeter…

Q: wye-connected load has a voltage of 480 V applied to it. What is the voltage dropped across each…

A: Given,  Line to Line voltage applied to wye-connected load is VL = 480 volts

Q: Connected to the same circuit are two equipment: 1. Equipment 1 draws 8.6 kW at unity power factor…

A: we need to find out effective kVA.

Q: In the experiment 1, the values are tabulated, find the load power factor. VL in Volts W, in watts…

A: In this question , we will find power factor using given data..

Q: Considering the energy conservation law, answer the following question using the diagram bellow:…

A: Here, given value of current is negative so current direction will be changed. In the given circuit…

Q: One end of the voltage coil should be connected with the M terminal of the wattmeter Select one:…

A:

Q: THE BELOW CIRCUIT IS SHOWN PLEASE FIND WHAT THE WATTMETER READING WILL BE

A: Here, in the given circuit the current coil is in series with the impedance and the voltage coil is…

Q: From the experiment 2, the two wattmeter method is used to measure the power. In that current coil…

A: wattmeter has two coils namely current coil and pressure coil. For power measurement current coil…

Q: Given the circuit below, determine the magnitude of the voltage reading across the terminals a and…

A:

Q: How many kilowatts of power are delivered to a circuit by a 240V generator that supplies 20A to the…

A:

Q: Question 22 4/4 pts A Wattmeter and Varmeter are connected into a 100 [V] single phase line that…

A: Given; 1phase wire ,Ac motor wattmeter and varmeter reading , supply is 100volts . Calculate: value…

Q: The circuit shown will transfer maximum power at Vi=2sin⁡(10000 πt ) volts if: *

A: According to question: The equivalent impedance seen by the source is calculated as…

Q: In 3-phase power measurement, wattmeter is used to measure power.

A: In three phase power measurement , wattmeter is used to measure active power (P) or real power of…

Q: In wattmeter, the coil connected in parallel is called.........................................?

A: In wattmeter, the coil connected in parallel is called

Q: A 300 V, 5A, 0.2 pf low power factor wattmeter is used to measure the power consumed by a load. The…

A: Given values are - Vt=300VoltIt=5Acosϕ=0.2Total division=150Reading division=100

Q: A wattmeter connected to a load is showing a reading of 15, in a scale of 150 with a voltage coil…

A:

Q: Det. the voltage roltaye and olHtage voltage and current @ the load vsing the 3rd Appiex.

A:

Q: What is the magnitude of the impedance of a 35 Ohm resistor? Assume the frequency is 180 Hz .Write…

A: Given, Resistance, R = 35 ohm  Frequency, f = 180 Hz

Q: Considering the energy conservation law, answer the following question using the diagram bellow: A B…

A:

Q: Pls help with below homework-) A 3 Phase, 380 V motor is drawing 80 Amps and a real power of 45 KW.…

A:

Q: A load with a power factor of 0.9 draws 10 A current from the 220 V network. The power drawn will be…

A:

Q: 4. For the figure below, determine the (a) Power dissipated in the load (b) Wattmeter reading 1-20 A…

A: The power dissipated in the load is given by:                 Pload= I2xR…

Q: With an AC voltage source of 5.4V and an f = 32000Hz. a) Calculate the Voltage and Current 1,7mH.…

A:

Q: 220 V, 60 Hz circuit draws a current of 11 A with a power factor of 0.8 lagging. Find

A: PRESENCE OF SOURCE In the presence of sources, all tolerant essentials, which are R, L, and C,…

Q: Thirty (30) units of 200 watts, 250 V incandescent bulbs are connected in balanced delta across a 3…

A:

Q: The current through the current coil of wattmeter is 2+3cos2(t-30) and voltage across it's pressure…

A: Given: v=1+4sin(2t-30)i= 2+3cos2(t-30)

Q: A 75 ohm transmission line is used to feed a 300 ohm resistive load. What is the SWR ?

A: Given: Zo=75 ΩZL=300 Ω

Q: Q2/ Calculate the carrier and modulating current for an AM circuit if the total power is 200 watts…

A:

Q: In a two wattmeter method power measurement. One of the wattmeter measures 0 watt power what is…

A: Given:- In two Wattmeter method of power measurement,one of the Wattmeter measures 0 Watt.

Q: A balanced three-phase, star-connected load draws power from a 440 V supply. The two wattmeters…

A: Balanced three phase star connected load line voltage (V) = 440 v Wattmeter readings (W1) = 4.2 kW,…

Q: A power station has a maximum demand of 2500 kW and number of kWh generated per year is 45 x 105.…

A: Given a power station with, Maximum demand = 2500 kW Number of kWh generated per year = 45×105