A 3 phase, 50Hz, Two bus, single transmission line power system consisting of line series resistance of 10, line series inductance of 25 mili Henry and shunt line charging capacitance of 50 micro Farads. Base values are 110kV, 100MVA. Form the bus admittance matrix in per unit.

A 3 phase, 50Hz, Two bus, single transmission line power system consisting of line series resistance of 10, line series inductance of 25 mili Henry and shunt line charging capacitance of 50 micro Farads. Base values are 110kV, 100MVA. Form the bus admittance matrix in per unit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.26P: A small manufacturing plant is located 2 km down a transmission line, which has a series reactance...

See similar textbooks

Related questions

Q: pen PowerWorld Simulator case Example 5_10 with the series capacitive compensation at both ends of…

A: P=VI cos∅To determine maximum amount of real power that can be transferred to the load at unity…

Q: 1.A single phase transmission line has two parallel conductors 1·5 metres apart, the diameter of…

A: We are authorized to answer one question at a time, since you have not mentioned which one you are…

Q: Investigate the operation principle of 3- phase inverter for 120° conduction intervals (by sketching…

A: Three phase inverter with resistive load, 120 degree conduction interval 1) star connected load 2)…

Q: 3-phase, single circuit66kV,50 km, Overhead transmission line has horizontal spacing with 3m between…

A: Here we have given A 3-phase single circuit which has voltage=66kVtransmission length…

Q: A 3-phase, 50 Hz, 132 kV overhead line has conductors placed in a horizontal plane 4·56 m apart.…

A: 3 Phase overhead transmission line, voltage=132kV frequency=50HZ Conductor diameter=22.4m line…

Q: • Zh = 100 ohm • Draw the pu reactance diagram by taking Ut(base) = 132kV, St(base) = 100MVA. If…

A: Zh = 100 ohm Draw the pu reactance diagram by taking Ut(base) = 132kV, St(base) = 100MVA. If the 33…

Q: 2- Petermine the Veilue of Rs which is requireed to conneel it with the moving Cail to obtain (5v,…

Q: tVec b) For the circuit shown in Problem 4 above, suppose Vce = 20 V, R = 4 2, L = 15 mH, T = 10…

Q: active and reactive power drawn by the mixer fed from a 230 Vrms, 50 Hz single phase AC network was…

Q: D: A 3 phas e, 50 HZ Transmission line (100km) Long delivers 50 MUA, o.8pf Lagging and 110kv the…

Q: A coaxial cable of 105 N impedance is used to connect a satellite receiving antenna to the decoder.…

A: Given, the impedance of the coaxial cable is 105Ω. capacitance (C)=75pF/m = 75*10-12 F/m diameter of…

Q: Q: A 3 phas e, 50 HZ Transmission line (lo0km) delivers 50 MUA, o.8pf Lagging and (aokv), Long the…

Q: the radius of the conductor ii) the radius of the sheath iii) the capacitance of the cable

Q: A 200 km, 3-phase transmission line has its conductors placed at the corners of an equilateral…

A: The configuration for the transmission line in the triangular conductor form is drawn as:

Q: family dwelling unit to be provided with 230V, 1-

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: The inductances per phase and capacitance per phase of a three-phase, 50H z, 450KV transmission line…

Q: Question 4 a) A 3-phase, single circuit transmission line, is given with the length somewhere in the…

Q: A ower system is operating at 1000Mw, 132kV, 50Hz, with 0.8 p.f. laging in parallel with another…

Q: F,(P,) = 1000P, Baht 30 < P, < 150 MW F,(P,) = 1500P, Baht 40 < P, < 200 MW %3D %3D Bus 1 Bus 2…

A: Total load demand, Pd = 120 + 200 = 320 MW Since no losses…

Q: 15. Which term implies that there's solid connectivity and current-carrying capacity in electrically…

A: Equipment bonded: Bonding is the process of joining two conductors like two wires or a wire and a…

Q: A 3-phase, 50 Hz, 132 kV overhead line has conductors placed in a horizontal plane 4 m apart.…

Q: Q5. A 3-phase, 50 Hz , 100 Km transmission line has conductors composed of 12 strands of Aluminum…

A: 5. 3-phase 100km transmission line: Resistivity=2.85×10-6 1+22840-20 =0.012996…

Q: Q. No. 1. Figure I shows the single-line diagram of a simple four-bus system. Table 1 gives the line…

A: "Since you have asked a question with multiple subparts, I will answer only first three subparts of…

Q: a- what is the physicalmeaning of system instability? b- All other things being equal, is a system…

Q: Q5. Assume that the following permanent outage data has been given for the system shown below:…

A: (a) In the given figure each parallel line consists of 138kV breaker, 138 kV line, Transformer and…

Q: 7. 3.1 Evaluation only. Created with Aspose, words 2003-2001 Aspose Pty Ltd. Vcc ASSIGNMENT TWO…

Q: Q3. A 30 line is 100 km transmission line is delivering 100MW, 0.8 p.f. lag at 132KV. Each conductor…

Q: For a Cockcroft-Walton voltage multiplier circuit, if Vmax = 460 kV and n = nopt = 14, %3! (i) What…

A: Because of our policy only first 3 questions will be answered;

Q: Given a 3-bus power system as follows. |Val = 1.0 pu Vi = 1.05/_0 pu Poen = 1.2 pu Z12 = 0.01 +…

A: "For solving the first two subparts pf the question, we have to solve many parameters before that,…

Q: Investigate the operation principle of 3- phase inverter for 180° conduction intervals (by sketching…

A: Given: Three-phase inverter is operated in 180° conduction mode. Consider the delta and…

Q: A synchronous generator.connected to 1.0 per unit voltage infinite bus has 0.8 per unit reactance.…

Q: A 3 phase, 50Hz, Two bus, single transmission line power system consisting of line series resistance…

A: It is given that: Rse=1ohmLse=25 mHCsh=50 μF

Q: Suppose an unelectrified remote village of Thar desert having population around 150 individuals’,…

A: The unelectrified village which 100 km far from road and 200 km far from power grid and having…

Q: 400 psoft Word (Product Activation Failed) Table Tools ences Mailings Review View Design Layout Aa…

A: Here it is ask that line charging admittance of Y bus connected between two buses is affects as

Q: Develop block diagram of hybrid electric vehicles

A: Hybrid Electric Vehicle (HEV) A hybrid electric vehicle (HEV) is a kind of vehicle that integrates…

Q: If for example communication power is often normalized by assuming R to be a unity in Ohms, although…

A: Power is usually referred to as the amount of energy transfer from one form to another and…

Q: For the cirouit shown below, draw the d.cA load line and defermine the oferading Point. 530 ka Ic

Q: Suppose a power system consists of two isolated regions: a western region and an eastern region.…

A: When all the units are working properly, the system is complete and the storage area is workingtoo…

Q: 3 A 3-phase, 50 Hz transmission line 100 km long, Load current i 5A at 0-9 p.f.lagging and at 110…

Q: Using the nominal-π method find the sending end voltage VS, the receiving end voltage ,VR and…

A: Using the nominal-π method find the sending end voltage VS, the receiving end voltage , VR and…

Q: For a single phase ac voltage controller/chopper, which is designed by using thyristors, with the…

A: A rectifier circuit is used to rectify the AC power generated by this source to the DC power that…

Q: Quiz No.1 5-6-2021 For the power system shown in Fig.1 (below), The impedance data and the bus data…

Q: Q17. The mathematical expression + E=, , determine the total effective load current when h%3D2…

A: Total effective load current

Q: 1. Gas insulated substation (GIS) use following gas for insulation a) CO2 b) Sulfur hexafluoride c)…

A: option " b" is correct. Gas Insulated Substation used Sulfur Hexaflouride gas for insulation.…

Q: %AY L. واحدة Which of the following Busbar arrangement has the best reliability Double Busbar…

A: SUB-STATION: The assembly of apparatus used to change some characteristic of electric supply is…

Q: A 3 phase, 50HZ, Two bus, single transmission line power system consisting of line series resistance…

Q: Imagine that you're told to install a grounding electrode conductor to the TMGB. Based on this…

A: As per BARTLEBY GUIDELINES, For Multiple Questions, we have to answer only first question. So I…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Discuss the method of forming YBUS by inspection, taking a simple example ofsystem with a 5-BUS and 7-Lines. Take half line charging at each node/BUS
With the system shown in the figure, use 100MVA as system base, and 230 kV as base voltage along the transmission line. For the same system in the figure, build the Y-bus matrix without the Load. 1. What is the element Y11? Provide the susceptance value 2. What is the element Y22? Provide the susceptance value
HIGH VOLTAGE . A 132 kV, three-phase, 50Hz transmission line uses 18 mm diameter, equally spaced ACSR conductors. Determine the spacing between these conductors, if it is to be designed such that the corona inception voltage is 5% higher than the normal operating voltage of the line at 40o You may assume the expression relating the electric field and the voltage of the line as a starting point.
a) Find the IBC load current.b) Give the Vca line voltage.c) Calculate the total complex power on the transmission line.
Explore the potential of high-voltage direct current (HVDC) transmission systems in interconnecting regional power grids.
• Zh = 100 ohm • Draw the pu reactance diagram by taking Ut(base) = 132kV, St(base) = 100MVA. If the 33 kV busbar voltage is kept constant at 30 kV and 0.8 inductive 50 MVA power is drawn from this bus, what is the voltage at the synchronous machine ends?
Draw the reactance diagram of the system whose single line diagram is given below and load flow in the system.the bus admittance matrix required to perform the analysis without using a numerical value.remove symbolically
-) The active and reactive power drawn by the mixer fed from a 230 Vrms, 50 Hz single phase AC network was measured as 600 W and 100 VAR, respectively. According to this information: a) Calculate the apparent power drawn from the network? b) Calculate the current drawn from the network? c) Calculate the cos(a).
Explain how you would create a pcb design for transmission line?
A small manufacturing plant is located 2 km down a transmission line, which has a series reactance of 0.5/km. The line resistance is negligible. The line voltage at the plant is 4800V(rms). and the plant consumes 120kW at 0.85 power factor lagging. Determine the voltage and power factor at the sending end of the transmission line by using (a) a complex power approach and (b) a circuit analysis approach.
A 132 kV, three-phase, 50Hz transmission line uses 18 mm diameter, equally spaced conductors. Determine the spacing between these conductors, if it is to be designed such that the corona inception voltage is 5% higher than the normal operating voltage of the line at 40oC. (You may assume the expression relating the electric field and the voltage of the line as a starting point, m=0.9)
Describe the key components of a power transmission system and their functions.