A 30 ohm resistor and a 60 ohm resistor are connected in a series circuit as shown below. 30.2 60. 2 12-volt source Compared to the electric current (I) through the 30 ohm resistor, what is the electric current (I) running through the 60 ohm resistor? O one half O twice as much o the same O one third as much

A 30 ohm resistor and a 60 ohm resistor are connected in a series circuit as shown below. 30.2 60. 2 12-volt source Compared to the electric current (I) through the 30 ohm resistor, what is the electric current (I) running through the 60 ohm resistor? O one half O twice as much o the same O one third as much

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter18: Direct-Current Circuits

Section: Chapter Questions

Problem 42P

See similar textbooks

Similar questions

Hi, Here's my question. 26.8: Three resistors having resistances of 1.60 W, 2.40 W, and 4.80 W are connected in parallel to a 28.0 V battery with no internal resistance. Find (a) the equivalent resistance of the combination, (b) the current in each resistor, (c) the total current throughout the battery, (d) the voltage across each resistor, (e) the power dissipated in each resistor, and (f) the resistor that dissipates the most power- the one with the greatest resistance or the least resistance and why?
A 240-kV power transmission line carrying 5.00x102. A is hung from grounded metal towers by ceramic insulators, each having a 1.00x 109- resistance. Figure 21.51. (a) What is the resistance to ground of 100 of these insulators? (b) Calculate the power dissipated by 100 of them, (c) What fraction of the power carried by the line is this? Explicitly show how you follow the steps in the Problem-Solving Strategies for Series and Parallel Resistors.
(a) Haw much power is dissipated in a short circuit of 240-V AC through a resistance of 0.250 ? (b) What current flows?
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
. The lightbulb used in a computer projector has a resistance of What is the current through the bulb when it is operating on 120 V?
Consider the circuit in Figure 21.29 and assume the batter has no internal resistance. (i) Just after the switch is closed, what is the current in the battery? (a) 0 (b) /2R (c) 2/R (d) /R (e) impossible to determine (ii) After a very long time, what is the current in the battery? Choose from the same choices.
. The generator at a large power plant has an output of 1,000,000 kW at 24,000 V. (a) If it were a DC generator, what would he the current in it? (b) What is its energy output each day—in joules and in kilowatt—hours? (c) If this energy is sold at a price of 10 cents per kilowatt-hour, how much revenue does the power plant generate each day?
(a) F ind the voltage drop in an extension cord having a 0.0600-O resistance and through which 5.00 A is flowing. (b) A cheaper cord utilizes thinner wire and has a resistance of 0.300 O. What is the voltage drop in it when 5.00 A flows? (c) Why is the voltage to whatever appliance is being used reduced by this amount? What is the effect on the appliance?
An automobile starter motor has an equivalent resistance of 0.0500 and is supplied by a 12.0-V battery with a 0.0100- internal resistance, (a) What is the current to the motor? (b) What voltage is applied to it? (c) What power is supplied to the motor? (d) Repeat these calculations for when the battery connections are corroded and add 0.0900 to the circuit. (Significant problems are caused by even small amounts of unwanted resistance in low-voltage, high-current applications.)
What is the voltage across the open switch in Figure 21.43?
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
Check Your Understanding Digital meters are able to detect smaller currents than analog meters employing galvanometers. How does this explain their ability to measure voltage and current more accurately than analog meters?