A 30 ohm resistor is connected in parallel with a 0.106 H inductor. The parallel combination is then connected in series with a 98 F capacitor. f the whole circuit is connected with the 125 V, 60 Hz, find the current through the conductor

Q: 1.Explain what will happen if two current sources of different magnitude are connected in  series 2...

A: Voltage source: It is an electrical component that has a fixed value of voltage. Current source: It ...

Q: A system transfer function can sometimes be experimentally determined by injecting white noise n(t) ...

A:

Q: We know the Fourier coefficients a,, b, of some signal which is being transmitted. The transmitter m...

A: I am giving the answer of both conditions  given that ar and br are fourier series coefficient.  

Q: PROBLEM 2: Four capacitors are connected in series with a battery shown in the figure. Simply the sc...

A: This question belongs to circuit theory . It is based on the concept of equivalent capacitance in th...

Q: How many lines are there in an NTSC signal?

A: In this case, from the given options, the correct option corresponding to the number of lines presen...

Q: We know the Fourier coefficients a,, b, of some signal which is being transmitted. The transmitter m...

A: The fourier coefficients are affected by doubling and shifting   the modified parameters are written...

Q: Q3) Design a three-section binomial transformer to match a 40N load to al502 transmission line, and ...

A:

Q: 4/ Calculate the effective value of a semi-circle waveform shown below Ans (0.816a] -a a

A: From given waveform write the expression for waveform and using RMS value of integral calculate effe...

Q: Examlpe: Assume that an analog signal is given by a) x(t) = 5 cos(4 × 10°nt) + 3 cos(6 × 10°nt),t > ...

A: We need to find out spectrum for sampled signal .

Q: Find the quadratic polynomial whose graph passes through the points (1, 18), (2, 35), (3, 60). y : N...

A:

Q: 4.15 For the circuit in Fig. 4.83, use superposition to find i. Calculate the power delivered to the...

A:

Q: For a speech signal, if a ratio of SNR value over the absolute maximum value of the analog Xrms sign...

A: Given that ratio of SNR value over the absolute maximum value of an analog signal =(xrms\|x|max), We...

Q: Using the figure shown, what will be the amount of current i (short-circuit current) in the circuit ...

A:

Q: 2. A generating unit of 10 MW capacity supplies the following loads: Domestic consumers with a maxim...

A: Since you have posted multiple different question. we will solve the first question for you. To get ...

Q: Solve, correct to 2 decimal places, the equation 21n.x+x=2 using the method of bisection.

A: The solution is given below 

Q: What are the static characteristics of a measurement system? De- scribe them with proper example.

A:

Q: 1. Draw the signal x(t) = A(1- 0.5t) + 8(2t – 1) sin?(t) and mark all important points in the axes. ...

A:

Q: 3. Let Is= 50A, find Vx 3Ω. 50 we

A:

Q: Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a- The nu...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: Power consumed by an electrical equipment  is 600 watts and voltage rating is 120 volts then find cu...

A:

Q: A wide sense stationary process X(t) is passed through a linear time-invariant filter with impulse r...

A: SOLUTION- a)  Syf =Sxf Hf2                  

Q: 2 ohms 10 ohms 12 ohms eo 16 V 8 A 6 ohms

A: Given

Q: -2et + 2e-2t V.(t) + 1.5 e=t = dV.(t) + 0.5- dt? d?V.(t) dt 2 O a. -2t O b. -2e-t + 2te-t c. C. -2e-...

A:

Q: Convert 1000 W into its equivalent mechanical horsepower.

A: Given information: Power of 1000 W is given.  This power needs to be converted into its equivalent p...

Q: considering a logic circuit to transmit information, which has three input signals (group of bits) a...

A: Output is given only when even parity will be generated. So when no of 1's are even then only output...

Q: 1. In the circuit of Fig., calculate the average power absorbed by the resistor and inductor. Find t...

A: The solution is given below

Q: E The Probability density funetron (PA) of a signal is ginen by PCx) = ke 1x1 <4 otherwse a) what Ts...

A:

Q: The electric field that is created due to the deflection of charge carriers in a Hall probe is paral...

A: Select the option True or false for the following Question. The Electric Field is created due to th...

Q: Calculate the difference in profit (Aprofit) between the case of CC1 and CC2 ( Aprofit = profitcci –...

A: Answer - Given - CC1 cost = $100 CC2 cost = $275 Pmpp  = 10 [W] Vmpp = 16 [V] Vbat = 12 [V]

Q: Given A=e"a, +2 cos ya, +2 sin za,, find V A at the origin.

A:

Q: The equivalent phasor domain representation of the equation of the current i = 60 Sin (100πt - 30°) ...

A: We need to draw the phasor for given current .

Q: -4 y(t) d 3 dt d dt 2 4x (t) + 2d²r(t) dt? dy(t) y(t) – 35 dt = -4x(t) + 2d²x(t) dt? dy(t) d'r(t) y(...

A:

Q: Consider a digital radio that uses a digital modulation scheme of the 128 QAM type, the width of the...

A: Considering a digital radio that uses a digital modulation scheme of the 128 QAM type, the width of ...

Q: 7. A certain cable signal transmission system is shown. The nominal level at the signal source outpu...

A: We need to find out gain at receiver amplifier .o

Q: * The Probability density function (Pd) of a signal is ginen by Pcx) = ke Ix1 <4 otheruse a) what Ts...

A:

Q: When the electric current through the DC motor is 2.0 A and the torque on the shaft is 0.34 Nm, the ...

A:

Q: 1 kΩ ww 1 V RL Figure 4.55 For Example 4.15. Find the maximum power transferred to RL if the 1-k2 re...

A: In this question,  We need to determine the maximum power transfer to the load resistance RL   If 1k...

Q: 13-Find the Thevenin and Norton equivalent circuits between ab. 2 A a 6 0 18 V 3 A 10 V

A: Given:

Q: Here are the list of the resistance value of each resistor, compute for the total current and total ...

A:

Q: Data: e1=11e0, e2=11e0, e3=5e0, €4=6€0 and e5=7e0 Calculate: a) E,D, and P in all media; b) The equi...

A: capacitance= (permitivity)(Area)/(distance between plates)  TOTAL ENERGY STORED = 0.5* CAPACITANCE *...

Q: Question No. 2: Let z1 = 2 - j2 and z2 = 2 + j6 (a) Compute the polar form of z1 and z2. (b) Compute...

A:

Q: 12. 3) vi Vo Vo Out. draw Voi

A: Given: Consider the circuit: To find: Determine and draw Vo.

Q: A2 3:2 220V 1k V2 V3 1. What is V1 reading? 2. What is V2 reading? 3. What is V3 reading? 110V 146.6...

A: Rectifier circuit: This is used for converting the AC quantity into the DC quantity.

Q: 1. For the circuit, obtain the Thevenin equivalent at terminals a-b. Calculate the current in R= 82....

A: The thevenins equivalent for the given circuit can be obtained by converting the current source into...

Q: 3. In the circuit shown in figure below, the resistance R is random and uniformly distributed betwee...

A: The circuit shows a voltage source which provide supply to the constant resistance and R in form of ...

Q: 5/ Compute the r.m.s and average values of the voltage waveform shown below v(t) 4 →t(msec) 1 -4 21

A: Calculation of r.m.s. (root mean square) and average values of the given voltage waveform : We know...

Q: Find the Nyquist rates for the following signals: X(t)= sin (20t) X(t) =4sin (30nt) + 3cos (70nt) X(...

A:

Q: What is the POS representation equivalent to the SOP Boolean formula shown? Y = ABC + ABC +ĀBC + ABC...

A: Given, Y=AB¯C+AB¯ C¯+A¯ B¯ C¯+A¯ B¯C  

Q: A 600-kg machine is mounted on a rigid floor of a factory through a spring of stiffness 1,500,000 N/...

A: I am answering first three parts of this question as per guidelines.

Q: Examlpe: Assume that an analog signal is given by a) x(t) = 5 cos(4 × 10 t) + 3 cos(6 x 10 tt),t 2 0...

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.