A 3500-Hz audio tone amplitude modulates a 200-kHz carrier resulting in a modulated signal having a percent modulation of 85%. The total power being transmitted is 15 kW. (a) What frequencies would appear in a spectrum analysis of the modulated wave? (b) Determine the power content at each of the frequencies that appear in a spectrum analysis of the modulated wave.

A 3500-Hz audio tone amplitude modulates a 200-kHz carrier resulting in a modulated signal having a percent modulation of 85%. The total power being transmitted is 15 kW. (a) What frequencies would appear in a spectrum analysis of the modulated wave? (b) Determine the power content at each of the frequencies that appear in a spectrum analysis of the modulated wave.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. A 1500-kHz carrier and kHz intelligence signal are combined in a nonlin-ear device. List all the frequency components produced. *2. If a 1500-kHz radio wave is modulated by a 2-kHz sine-wave tone, what frequencies are contained in the modulated wave (the actual AM signal)? *3. If a carrier is amplitude-modulated, what causes the sideband frequencies? *4. What determines the bandwidth of emission for an AM transmission? *10. What are some of the possible results of overmodulation? *11. An unmodulated carrier is 300 V p-p. Calculate %m when its maximum p-p value reaches 400, 500, and 600 V. (33.3%, 66.7%, 100%) 12. If V and V as shown in Figure 8, determine %m. (53.85%) 13. Determine and from Problem 12. ( Vpk, Vpk)
P2: An FM transmitter has a 220 MHz carrier frequency. Its modulation index is 3 with a 5 kHz modulating frequency. The total exit power is 100 w in a load de 50 ohms. A) What is the bandwidth of this signal considering the side bands with more than 1% of the signal voltage? B)What is the approximate bandwidth calculated by Carson's rule?
2 (AM) A 10 V amplitude sinusoidal signal is used as a modulating signal to generate an AM signal with modulation index 0.8. What is the amplitude of the carrier? What is the power of the side bands? What is the efficiency of the modulated signal?
Calculate the frequency deviation and the carrier swing of a frequency- modulated wave which was produced by modulating a 50.4 MHz carrier. The highest frequency reached by the FM wave is 50.415 MHz. Then calculate the lowest frequency reached by the FM wave. If the frequency of the modulating signal is 5 KHz, what is the bandwidth of the FM wave?
What is the bandwidth of a narrowband FM signal generated by a 2 kHz audio signal and 110 MHz FM carrier?
The equation of an angle-modulated voltage is v = 10 sin (l08t + 3 sin 104,). What form of angle modulation is this? Calculate the carrier and modulating frequencies, the modulation index and deviation, and the power dissipated in a 100-ohm resistor.
A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplitude of 20 V. a. Sketch the audio signal. b. Sketch the carrier. c. Construct the modulated wave. For a, b and c - label your diagram d. Determine the modulation factor. e. What frequencies would show up in a spectrum analysis of the modulated wave? f. Write trigonometric equations for the carrier and the modulating waves. Kindly answer a-f. Please have mercy. Thanks!
H.W A) An amplitude modulated signal has a carrier frequency 10KHZ. The upper sideband is transmitted at 11KHZ. plot the frequency spectrum and determine the Bandwidth required for the AM signal? B) compute the Signal Energy
1)the average value of the signal is? /2) the effective value of the signal is?
(a) What is the frequency deviation and carrier swing necessary to provide 75% modulation in theFM broadcast band? (b) Repeat for an FM signal serving as audio portion of a TV broadcast.
A 93.2 MHz carrier is frequency modulated by a 5-KHz sine wave. The resultant FM signal has a frequency deviation of 40 KHz. (a) Find the carrier swing of the FM signal. (b) Determine the highest and lowest frequencies attained by the modulated signal. (c) What is the modulation index of the FM wave (d) Calculate the percent modulation? (e) Determine the bandwidth using approximation method.
When the modulation percentage is 75, an AM transmitter produces 10 kW. How much of this is carrier power? What would be the percentage power saving if the carrier and one of the sidebands were suppressed before transmission took place?