A 365 pF capacitor is charged to 115 V and then quickly connected to a 225 mH inductor. Determine the frequency of oscillation. Determine the peak value of the current. Determine the maximum energy stored in the magnetic field of the inductor.

Q: How much resistance must be added to a pure LC circuit L = 320 mH , C = 1800 pF to change the…

A:

Q: A circular saw blade rotating at 3600 rpm is braked to a stop in 6 sec. What is the angular…

A: The equations of angular motion we use to solve this are ωf = ωi + αt ωf2-ωi2 = 2αθ, where ωf = the…

Q: Q1. Compute potential difference in thermal equilibrium between region where no = 1017 cm-3 and n, =…

A: Write the expression for the potential difference. Here, kT is the thermal energy, e is the charge…

Q: loo Cm is A Sound wave 1S vepresenkd above. If velocíty of the SOund wave the frequency of sound i.…

A:

Q: A loop with a resistance of 4.0Q is pushed to the left at a constant speed of 2.0 m/s by a 24 N…

A:

Q: A car travelling at the speed Vo on a straight level road. After the brakes are applied at t = 0,…

A:

Q: Which of the following is true regarding Newton's Second Law of Motion? A. Increasing the net force…

A:

Q: Q7. Calculate the equivalent resistance of the circuit below. R = 20 2 R2 = 15 Q %3D %3D R5 = 8 0 R4…

A: We have a circuit with a battery of voltage V=12 V and five resistors R1=20 ohm, R2=15 ohm, R3=20…

Q: What is the magnitude of the force and acceleration of an electron that moves at a speed of 5 x 10…

A: Given data :- speed v = 5 × 106 m/smagnetic field B = 0.40 Tcharge on electron q =e = 1.6 × 10-19…

Q: A closely wound circular coil consists of 500 turns and carries a current of 4.4A. The radius of the…

A:

Q: Two point charges q, = +26µC and q2 = -17.5µC are 64 cm apart. a. What is the potential energy of…

A:

Q: Qo Vo = 120 V C = 8.0 µF C2 = 4.0 µF We connect a capacitor C1 = 8.0 µF to a power supply, charge it…

A: Given data- Capacitor C1=8.0 μF,  C2=4.0 μF Potential difference V∘=120 V

Q: The circuit shown below is a R1 The circuit shown below is a

A: 1. Ideal Diode Clamper Circuit 2. Battery Charging Circuit

Q: The masses m; are located at the points Pj. Find the moments My and My and the center of mass of the…

A: Given: m1=1, m2=4, m3=5P1=(2,-6), P2=(-3,2), P3=(3,4)

Q: Charged rubber rods are placed near a neutral conducting sphere, causing a redistribution of charge…

A:

Q: A moving object accelerates uniformly from 75 m/s at time t=0 to 135 m/s at t=10s. How far did it…

A:

Q: The voltage across and the current through a single circuit element connected to an ac generator are…

A:

Q: How long must a 2200 N force act on a van to give it a momentum of 56 000 kg.m/s starting from rest?

A:

Q: 2.68 An objects velocity is measured to be V_x (t)=a-ßt^2 Where a=4.00 m/s and B=2.00 m/s^3. Att = 0…

A:

Q: 1. Three resistors, 250, 450, and 750, are connected in series, and a 0.51-A current passes through…

A: As per our company guidelines we are supposed to answer ?️only first 3 sub-parts. Kindly repost…

Q: 7. An aluminum wire has a diameter of 0.850 mm and is subjected to a force of 1000N. Find the stress…

A:

Q: If a 6.7 cm doll is standing a distance from a convex mirror and the focal length is 4 m, find the…

A:

Q: A fish that is d=d= 2.9 m below the surface looks up and sees a child fishing from the shore.  What…

A:

Q: 9. Two point charges with values of 3.40 C and 6.60 C are separated by 0.20 m. What is the electric…

A: The electric potential energy between two charges separated by a distance is given by U= kq1*q2 /r…

Q: An engineer built the circuit depicted in the figure. Assuming Ɛ = 8.80 V and R = 5.20 Q, find the…

A:

Q: What must be the mass of block A if it is to descend 12 m in the first 3s after the system is…

A:

Q: As shown in the Figure 1 below, the uniform, 1600-N beam is hinged at one end and held by a tie rope…

A:

Q: A circular antenna of area 3 m2 is installed at a place in Madurai. The plane of the area of the…

A:

Q: What is the current produced by a voltage of C. 240 V through a resistance of 0 2 0?

A:

Q: true or false    The electric potential, or voltage, at any point in an electric field is the…

A:

Q: Let the moment of inertia of a hollow cylinder of length 30 cm (inner radius 10 cm and outer radius…

A:

Q: A bag of wheat weight 330 kg .To what height should it be raised so that potential energy is 7800J?…

A: Given data:  Mass (m) = 330 kg Potential Energy (PE) = 7800 J g = 9.8 m/s2 Required: Height (h)

Q: The rms velocity of molecules of a gas at -73°C and ! atmospheric pressure is 100 m/s. The temp. of…

A:

Q: An electron has a charge of 1.6 EXP-19 C. A flow of 1000 electrons/second constitutes a current of

A: Given: magnitude of Charge of one electron is qe = 1.6×10-19 C Flow of electrons is n = 1000/second.

Q: You and a friend pass each other in spaceships that are each traveling 0.61c relative to the other.…

A: Given : Relative velocity of both spaceships, v = 0.61c Stationary time measured for the nap, t =…

Q: A water pipe having a 2.47 cm inside diameter carries water into the basement of a house at a speed…

A: a) Apply the continuity equation to determine the velocity at the second floor.

Q: a) Angle: b) Speed: 1 attachment- Alpha just stole a ball in a basketball game and intends to throw…

A: Horizontal velocity in a projectile motion remains constant as there is not acceleration in…

Q: A spaceship flies past you and you measure its length to be 99 m. If you know its rest length is 193…

A:

Q: What is the strength of the magnetic field at the center of the two concentric conducting coils…

A: According to the given information the correct option is d.

Q: A projectile is launched upward and to the right at an initial slope of 4 vertical and to 3…

A:

Q: An AC source with a frequency of 60 Hz is connected to a lightbulb. The instantaneous brightness of…

A: Instantaneous current can be given as,  I = Imsin(ωt)  And instantaneous voltage can be given as,  V…

Q: The resistance of a copper wire increases by a factor of 1.32 when current flows through the wire…

A:

Q: What is the weight of a 70-kgm man at standard condition?

A:

Q: Determine the constant torque that must be applied to a 50 – kg flywheel, with radius of gyration 40…

A:

Q: Show how a change in ⁰F is equal to a change in R.

A:

Q: If a system of three concurrent forces F1 = 300 dynes, right; F2 = 450 dynes, 30 ⁰ up to the left…

A:

Q: hat role do conductors play in modern technology?

A: Conductors are the materials which allow the free flow of electrons from themselves. For example-…

Q: As shown in the figure, two boxes of mass and are connected by an essentially massless, non-elastic…

A:

Q: 3. The Dimension of a rectangular loop is 0.50m and 0.60m. B and 0 are 0.02T and 45° respectively.…

A: Solution of 3: Given, The Dimension of rectangular loop is 0.50m and 0.60m . Magnetic field , B =…

Q: Interactions between charges at rest and the forces between them are called

A: non ohmic interaction: interaction which ohms law is not obeyed ohmic interaction : interaction in…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.