Answered: A 39-kΩ resistor has a 10 percent…

A 39-kΩ resistor has a 10 percent tolerance. What is the range of resistor values corresponding to this resistor? Repeat for a 3.6-kΩ resistor with a 1 percent tolerance.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter5: Resistors

Section: Chapter Questions

Problem 8RQ: A 10,000- resistor has a tolerance of 5%. What are the minimum and maximum values of this resistor?

See similar textbooks

Related questions

Q: When measuring a short to ground with an ohmmeter the display will rea O Approximately 0 ohms…

Q: 1. WHAT IS THE RESISTANCE AND THE TOLERANCE VALUES OF THE RESISTOR BELOW, WHICH COLOR CODES ARE…

Q: (a) A 4.7-kΩ resistor is purchased with a tolerance of 1 percent. What is the possible range of…

A: Given: Rating of the resistance = 4.7 kΩ = 4700 Ω Tolerance = 1% Maximum Resistance…

Q: What is the total internal resistance of an ohmmeter with a 1mA meter movement and having a 5VDC…

A: Given data: I=1 mAVB=5 V

Q: A resistor with color bands blue-red-green-yellow-gold has a length of 5cm. If the material is made…

A: ρg=104Ω−m Length of resistor,L=5 cm =0.05 m Color band,…

Q: In the circuit show in Figure 3, at the temperature of room increase what happen to the resistance…

A: Given: Circuit

Q: 9. One meter rod of 2 inches diameter is drawn until its resistance is 100 times the initial…

Q: You are working on an electronic circuit. The circuit current is 5 mA. A resistor is marked with the…

A: Given: The circuit current is 5 mA. A resistor is marked with the following bands: brown, black,…

Q: The resistance of a certain copper wire is 0.5 Ω. Determine the resistance of a tungsten wire having…

Q: 34. Those components or devices which are specially designed to have a certain amount of resistance…

Q: there are 100 graduations in the scale of an ammeter with internal resistance of 0.18 Ω and intended…

A: We need to find out resolution and Shunt resistor for given ammeter

Q: I want an assembly where total 10 C negative charge will be contained. Estimate how many electrons…

A: Electrons are negatively charged particles and the charge of an electron can be expressed as

Q: Refer to Figure 2, determine the voltage with respect to ground at each point, A, B, C, and D. D₁ R…

A: The circuit diagram is, Assuming the diode is forward bias then diode is replaced by a 0.7 V…

Q: A lamp draws 0.5 A at 110 V. The cold resistance of the filament of this lamp is 20 Ω at 20˚C. Find…

Q: Special Procedure In figure 2.4 (same circuit as figure 2.1), using the Resistance Mode of the…

A: In the above circuit as it is seen that point c and f are short circuited and points e and d are…

Q: Carbon has a negative temperature coefficient of resistance of -0.5 · 10³ (°C)*!. What temperature…

A: Given data: The negative temperature coefficient of Carbon is α=-0.5×10-3/∘C. The amount of…

Q: Explain the changes of this when I change the Wire gauge size from medium to thick. Elaborate

A: It is asked to explain the changes of this when we change the Wire gauge size from medium to thick.

Q: Calculate the ratio of the resistivity of 2 wires having the same length and sar resistance with…

Q: Is there difference between percentage errors of three resistors (1K,10K,100K)ohms? Explain

A: The explanation is as follows.

Q: What is the resistance of the unknown value resistor

Q: A galvanometer coil has a resistance of 12 and the metre shows full scale deflection for a current…

A: Given: Meter resistance, Rm=12 Ω. Meter current, Im=3 mA. Voltage across meter, Vm=ImRm=3×10-3×12=36…

Q: resistance R to maintain a voltage of 7.2 V across the voltage is constant at 12V and the minimum…

Q: 5.The value of a resistance is 4.7kN while measurements yields a value of 4.63kN .Calculte…

A: Given, Measured value = 4.63 kΩ Exact value = 4.7 kΩ

Q: Calculate the series resistor required to convert the 100 microampere meter to a voltmeter with a…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 1. A given material has a resistance of 20 2 at room temperature (20°C) and 25 2 at a temperature of…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: It is desired to renew two different electrodep systems with a 9 Volt supply source. The first…

Q: A certain milliameter, with a scale of 0 to 1.0 mA, has a resistance of 32 ohms. If this milliameter…

A: If we connect ammeter directly to 120volt line, Then actual current flowing through the ammeter =…

Q: The Wheatstone bridge has been in use longer than almost any other electrical measuring instrument.…

A: The Wheatstone bridge circuit will be used to measure an unknown resistance to an accuracy of about…

Q: There are 5005 electrons in an assembly. What will be total charge in coloumb?

A: Electrons are negatively charged particles and the charge of a single electron can be expressed as…

Q: A 12.1-mA current flows through a 10 percent, 2.7-k2 resistor. What range must the resistor voltage…

A: I = 12.1 m A R = +- 10% of 2.7K ohm Voltage range is required From the ohm's law V = I× R .

Q: The current flow in the FET device is only due to the ............ carriers. Choose correct answer :…

A: FET is of two types 1) N- channel FET 2) P-chapnnel FET

Q: The resistance of a 2m length of cable is 2.5 . Determine (a) the resistance of a 7m length of the…

Q: Resistances can be measured with the help of a O voltmeter O ammeter wattmeter ohmmeter

A: Voltmeter is used to measure the voltage between two node. Ammeter is used to measure current flow…

Q: 3. WHAT IS THE RESISTANCE AND WHICH COLOR CODES ARE GREE (VALUE 10%) 4.DETERMINE THE RESISTANCE O…

A: The solution is given below

Q: Question: a.) Find the equivalent resistance between points A and B in the given figure. b.)…

Q: HOW MUCH ENERGY IS USED TO MOVE 10 COULOMBS FROM ONE POINT IN A CIRCUIT TO ANOTHER WHEN THE VOLTAGE…

A: The solution is given below The problem is from electric potential

Q: Determine the width of a carbon resistor having a sheet resistance of 15 0 12 if the length is 1/2…

A: Due to guidelines we can solve one complete question at a time .if you want another solutions too…

Q: A student is using a voltaic cell and voltmeter to identify two polished metal strips, which could…

A: one must be iron and the other zinc, but you can't tell which one is which

Q: A l mA meter movement with an internal resistance of 100 ohms is to be converted into a 0 - 100…

Q: it is the resistance of a material when there is no supply.

A: The correct answer is : option "D" : COLD RESISTANCE

Q: Design a multirange d.c. milliammeter with a basic meter having a resistance 75 ohm and full scale…

Q: A resistor must provide a voltage drop of 27 V when the current is 10 mA. What is the required value…

A: Given data Voltage drop across Resistor V = 27 V Current passing through the resistor i = 10mA To…

Q: A voltmeter rated 150 volts has an internal resistance of 10 k?. What resistance should be added in…

Q: What is the formula for resistance

A: Resistance :- It is the opposition offered by a material to flow of current in an electrical…

Q: Differentiate by take a single quantity of your interest. Measured it by different methods…

A: Here i took the quantity of the electrical current as my interest. measurement of electrical current…

Q: A one meter rod 2 cm diameter is drawn until its resistance is 100 times the initial resistance. Its…

Q: A) A carbon resistor has colored bands as shown in Figure 3.…

A: The resistor with the shown color band is as shown in the figure,

Q: A 6.3-V tube filament (consider it a resistor) requires 300 mA. What resistance is required in…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

A 39-kΩ resistor has a 10 percent tolerance. What is the range of resistor values corresponding to this resistor? Repeat for a 3.6-kΩ resistor with a 1 percent tolerance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 10,000- resistor has a tolerance of 5%. What are the minimum and maximum values of this resistor?
(a) A 4.7-kΩ resistor is purchased with a tolerance of 1 percent. What is the possible range of values for this resistor? (b) Repeat for a 5 percent tolerance. (c) Repeat for a 10 percent tolerance.
there are 100 graduations in the scale of an ammeter with internal resistance of 0.18 Ω and intended to measure a current up to 10 A. a. what is the value of each gradutation? b. convert this to an ammeter than can measure up to 100 A. c. how will the value of the graduation change?
Design a multirange d.c. milliammeter with a basic meter having a resistance 75 ohm and full scale deflection for the current of 2 mA. The required ranges are 0-10 mA, 0-50 mA and 0-100 mA ??
How can I get the solutions and answer for this problem? (Answers must be in 3 decimal places), (please ignore part (c)) Complete question for part b): How many Coulombs can you get if a current of 5A exists in a 10 Ω resistance for 4 minutes?
An ohmmeter is used for measuring the resistance of a circuit between its two terminals. What would be the reading of such an instrument used for the circuit at point (a) AB (b) AC and (c) BC? All resistances are in ohm.
What is the current flow through an ohmmeter when it indicates zero resistance? A. MAXIMUM B. Mid-scale C. MINIMUM D. NONE OF THE ABOVE
For a given wire gauge, the longer the wire the greater the resistence. A copper wire 750ft long has a resistance of 1.89 ohms. How long is a copper wire of the same gauge whose resistance is 3.15 ohms? I need to show work
A resistor with color bands blue-red-green-yellow-gold has a length of 5cm. If the material is made out of carbon, how much material (in terms of volume) is present in this resistor? If you are going to change the carbon to glass, how much smaller would it be (Note, take the lower limit of the final resistance and the resistivity constant of carbon and glass.
All resistors in the circuit are the same measuring at 1 ohm at 25 deg celcius. At the same temperature, its resistivity is 1.76 mΩ-cm and its and the temperature coefficient of resistance is 0.00393/oC. Calculate for the equivalent resistance between b and c at 50 deg celcius.
Calculate the equivalent resistance and equivalent current.
Please answer the required portion. Show full solutions with brief explanation. Current flow of 50-ohm resistor shown in picture Required: - total energy by the resistor