A galvanometer coil has a resistance of 12 and the metre shows full scale deflection for a current of 3 mA. How will you convert he metre into a voltmeter of range 0 to 18 V?

Q: Need it ASAP A transformer has a rated output of 200 kVA at a power factor of 0.6. Determine the…

A:

Q: Write a short conclusion for AM SSBSC

A:

Q: Q3-Find V₂ & 1 using nodal analysis. 140 HE 5/0° A + -jan TEX IT An 120 NC 20/90 V

A:

Q: coil of power factor 0.4 is in series with a 50-μF capacitor. The p.d. across the coil is equa to…

A:

Q: Assume VBE 0.7 V and ß 50 for the transistor in the circuit shown in the figure. For VCE - 2 V, the…

A: Given- Voltages- VBE=0.7 V,β=50,VCE=2 V, To Find- The value of RB.

Q: noninductive load with a resistance of 30 Ω is connected in series with a capacitor. The capacitor…

A:

Q: Q4: Three identical coils connected in wye connection take 8 kW at 0.8 power factor when connected…

A: 8

Q: The tariff in force is Rs 150 per kVA of maximum demand and 8 paise per unit consumed. If the load…

A: We have an tariff of RS 150/KVA of maximum demand . Energy charge/unit = 8 Load factor = 30% = 0.3…

Q: Q5. Give the reason for(4) of the following? (assist your answer with necessary drawings) a) Series…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A 100 kVA, 4000V/200V, 50 Hz single phase transformer has 100 secondary turns. Determine (a) the…

A: Given that Transformer rating = 100 kVA Voltage V1 = 4000 V Voltage V2 = 200 V Frequency = 50 Hz…

Q: A coil of inductance 120 mH and resistance 150 is connected in parallel with a variable capacitor…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Eliminate the arbitrary constant. 2x -X y=c₁e²+c₂e² 2

A: It is given that: y=c1e-x+c2e2x....................(A)

Q: The power input to the rotor of 440 V, 60 Hz, 8-pole, 3-phase, induction motor is 90 kW. The rotor…

A:

Q: 5. Connect the circuit as shown below. Measure the voltage across the capacitor and the current…

A:

Q: 10 V A 11 の本 Si B R1 1 kohms D Si с R₂ 1 kohms 12 13 Ge

A:

Q: NOR IMPLEMENTATION Given Boolean Function: (AB +B'C')' Instruction: A. Construct the truth table. B.…

A: Given- F= AB+B'C'' To find- A. Truth table =? B. Logic circuit diagram using gates =? C. Logic…

Q: 4. Determine 1₁ and 1₂ using current division. 52 MAPUS UNIVERSITY I₁ W 1552 ution 12 40A ↑ L!!! M…

A: We need to find out current for given circuit

Q: 2) A DC circuit with a 12 V source has three resistors wired in parallel, with resistances of 50, 17…

A: Given  Vs = 12V R1 = 5Ω R1 = 17Ω R1 = 22Ω Asked to find the following Current in each loop Total…

Q: A transformer has a turn ratio of 1: 10. A resistance of 2000 ohms is connected across the secondary…

A: Given, Transformer turns ratio, a=110=0.1. Secondary terminal resistance, R2=2000 Ω.

Q: A 2,000-V, 3-phase, 4-pole, Y-connected synchronous motor runs at 1500 r.p.m. The excitation is…

A:

Q: The registers that are necessary in the operations of memory data write and read (which of the…

A:

Q: A 3-phase, 60 Hz induction motor has 2 poles. If the slip is 2% at a certain load, determine the…

A: Given parameters Frequency = 60 Hz Number of poles = 2 Slip = 2%

Q: Q4:A. Design ADC using VTC (Voltage to Time Converter) with clock generator fc=32Hz and the slope of…

A: Introduction: An analog-to-digital converter (ADC) is a data converter that allows digital circuits…

Q: Q3// A single phase 110V, 60 Hz, four pole induction motor has the following constant in equivalent…

A: Given data, Line voltage VL=110 V Number of poles P=4 Frequency f=60 Hz Resistances, R1=1.86…

Q: Determine resistor values using the color code and find all missing electrical values.

A: The resistor values can be calculated by using the resistor colour coding method and the remaining…

Q: 15. Determine the nodal voltages for the networks ce" E = 50 V / 120° 10 Ω Μ -10 Ω 8 Ω moo 4 Ω ΖΩ Οι…

A:

Q: Q In the arithmetic operations in ALU the meaning of arithmetic shift left instruction for a binary…

A:

Q: For the circuit below: a) Determine the range of R₁ and I, that will result in VR being maintained…

A:

Q: 5. Connect the circuit as shown below. Measure the voltage across the capacitor and the current…

A:

Q: The registers that are necessary in the operations of memory data write and read (which of the…

A: We need to select correct option for given statement

Q: The cross-sectional area of a transformer limb is 80 cm2 and the volume of the transformer core is…

A: Given parameters are: The cross-sectional area of a transformer limb,Ac=80cm2=80×10-4m2 The volume…

Q: What is the effect in the overall capacitance, stored charge and energy of a network of identical…

A:

Q: Vs The source Vs=10 sin (ot); R=100 ohms; w=2лf; f=1000 Hz; C = 1 mF. R w +1₁

A:

Q: A. Solve the given problems: Show your solution. 1. Use Richardson Extrapolation to estimate the…

A:

Q: What is the energy Bauit?

A:

Q: Q2) Infinite line charge of pu-5nc/m at X-1, Y-1 and a sheet of charge of ps-3 nc/m² at y=-2, the…

A:

Q: PRACTICE EXERCISE 4.2 Three identical small spheres of mass m are suspended from a common point by…

A: Given: P is the common point, Fe = the force exerted by the other 2 spheres, mg = the force exerted…

Q: solve this please and thank u

A: Signal is given here the amplitude of squre wave is considered as one and the complex exponential…

Q: Suppose we construct a voltage divider circuit as shown in Figure 1.1 where the voltage source V₁ is…

A:

Q: Two identical diodes with Is-7 × 10-16 A are connected in series as shown in Figurey. Calculate the…

A:

Q: Using Mesh Analysis, find the value of the current through the 10 ohms resistor. 4ohms. ww 7V 6ohms…

A:

Q: Determine the output waveform by choosing the best answer below: D (A) 12V 12V A TV -12V (C) 17V…

A:

Q: An ideal DC/DC step-down converter is supplied by a direct voltage of 40V and operates in continuous…

A: Given data, Direct voltage applied Vs=40 V. Switching frequency, fs=20 kHz On state time, Ton=20 μs

Q: The current i(t) through a 10 2 resistor in series with an inductance is given by: i(t) = 3+4 sin…

A: Given, Current, it=3+4 sin100t+45°+4 sin300t+60° A. Resistance, R=10 Ω.

Q: The input to the circuit in Figure P 3.6-25 is the voltage of the voltage source vs. The output is…

A: The required parameters can be calculated by using the basic circuit theorems by reducing the…

Q: if R1 = 4.0 KQ, R2 = kQ 1.0 KQ then ID1 is: +5.0V IDI R₁ ID2

A: Given Two doides one is connected to ground and other is connected to -5v source. Let us first…

Q: For the circuit shown in fig., in(t) and Vu(t). use the LAPLACE transform method to find the…

A:

Q: Convolution the following: A xit) t Jh(t) et

A:

Q: A 200V, 50 Hz supply is connected across a coil of negligible resistance and inductance 0.15 H…

A:

Q: Is Mc microfarads?

A: Given, The abbreviation of mc =?

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.