Answered: A 4 Pole, 50 Three Phase Motor 25 Kg.…

A 4 Pole, 50 Three Phase Motor 25 Kg. The meter produces a maximum torque of 1350 Nm per minute. So calculate the torque developed with 5 percent slip. The rotor resistance per winding is 0.5 ohm.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 6RQ: Name three factors that determine the torque produced by an induction motor.

See similar textbooks

Related questions

Q: hybrid parameter his (a) (c) O + V₁ ww R₁ (aR3 + R₂) R₂ + R₂ (1-α) R₂ R₂ + R3 ww network as shown.…

Q: The minimum 4-bit Carry save Adders using to add 6-numbers (5-bit) are 6 CSA 10 CSA 8 CSA None of…

A: A particular kind of digital adder called a carry-save adder is used to quickly calculate the sum of…

Q: 4- A system with a state matrix A = a- critical damped b- over damped 5- A system with input matrix…

Q: What is the voltage drop across the 2Ω resistor? 10 Ω 122 V Select one: a. Ο • b. 12 c. 18 d. 22 e.…

A: Given, The circuit is,

Q: A potential gradient of 3 x 10° V/m is maintained between two horizontal parallel plates 1 cm apart.…

A: A potential gradient of 3 * 106 V/m is maintained between two horizontal parallel plates which are 1…

Q: Given the AM voltage equation. Determine the carrier voltage and frequency, the modulating voltage…

A: Given: VAM=310 cos (6,540,000 t)+650 sin (6,600,000 t) - 310 cos (6,660,000 t) Volts To do:…

Q: 67. In a short circuit test on a circuit breaker, the following readings were obtained on single…

A: Given a short circuit test on a circuit breaker having, Time to reach the peak restriking voltage =…

Q: An ebony circular disk has a uniformly charge density of 2 C per square meter. The radius of the…

A: Given, A uniform circular disk has a uniform charge density ρ=2 C/m2. Radius of the disk r=1 cm.

Q: What is the simplified algebraic expression for the logic gate sho Doz X C Y OX+Y OX.Y OX.Y ΟΧΘΥ…

Q: An 8 × 1 multiplexer has inputs A, B, and C connected to the selection inputs S 2 , S 1 , and S 0 ,…

A: As per the data given, Inputs of 8 × 1 multiplexer are A, B, and C. Selection input of multiplexer…

Q: 10. In a step-down transformer, the number of turns in the secondary coil is 20 and the number of…

A: The given transformer is a step-down transformer. Thus the output secondary voltage will be lower…

Q: A d.c. series generator supplies the load of 5 kW at 250 volts. The armature resistance and series…

A: Solution: Given data ; d.c. series generator ; output =5 KW , V =250 V, armature resistance Ra=1 Ω,…

Q: 9. The transfer function of an inverting amplifier with a short circuit feedback is -1 b--Rin Rin…

Q: 1.31 The current waveform as shown below, is applied in a pure resistor of 10 2. What is the power…

A: Given current waveform,

Q: Problem 10 The core of the magnetic circuit of Fig. (a) is made of steel whose B-H characteristic is…

Q: Use the duality property to find the inverse transforms of the following functions: F(w) 10u(w) - 5…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: Determine the product of (1 + i) and (1-3i) (A) 4-2i B) 2-2i C) 2-4i (D) 2+4i

A: Given: To determine the product of 1+i and 1-3i.

Q: 2.41 Suppose you want to add a third radiator to your garage that is identical to the two radiators…

A: I am attaching detailed solution image of first question as per guidelines.

Q: SKILL BUILDING ACTIVITY # 1 Write the AM voltage equation for a 120 Vp, 700 KHz carrier and a 100…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: The span of the same level transmission line is 300 meters. The diameter of the conductor is 15 mm.…

Q: What is the simplified algebraic expression for the logic gate shown? X xa Y OX + Y OX.Y OX.Y ΟΧΘΥ…

A: Given, The logic gate,

Q: Design a 18 person voter system using 4 bit parallel adder(s) only. Use a minimum number of…

A: Given components: 4-bit parallel adders To design: An 18-person voter system using a minimum…

Q: What Is setup time?

A: Setup: Particularly UPR and forceful body carriage. b: characteristics, make-up. The preparation…

Q: 1A (A ww 3Ω + 8F VC - The circuit above is in DC steady state. What is the value of v, in volts? 5Ω

Q: a) Based on Figure Q1(a), prove that the voltage across resistor R3 is; R3 R₁ + R₂ + R3 VR3 = V₁ VRI…

A: Given circuit: To prove: Voltage across resistor R3 is VR3=R3R1+R2+R3VT.

Q: Find the F. T. of the following Signals using differentiation. prop.

A: It is given that:

Q: Q5) For the waveform shown below, find Vrms v(1) 2 2 6 8 l10 -1

A: from given figure find the expression for the voltage v(t) then calculate RMS value of V(t) using…

Q: Calculate the values of i2, 13, V2, V3,Vc and v₁ in the network shown in Fig. at the following times…

A: We have been given an network as shown in figure, We need to determine the value of, i2 , i3 , V2 ,…

Q: The characteristics S¹ + 2s³+6s²+4s+1 = 0 Set up the Routh Table and determine the stability of the…

Q: 8 The EMF induced in the secondary winding of a 50 Hz single-phase transformer having 500 turns on…

A: Given: The EMF induced in the secondary winding, E2=13.2 kV Frequency, f = 50 Hz Number of turns on…

Q: A machine is attached to the following loads for light in the winding shop. The light affixse…

Q: 0 SK 34K 2k www ww 4K LOK www зок AM 20K www IK 33K H 12K 24K www 4K ww www 2.K www 18k

Q: The line input to a three-phase star connected alternator having a line input of 400V 50Hz supplies…

Q: Consider the following section of a multiloop circuit, with current directions as indicated: zero…

A: Given circuit is,

Q: Which of the following is a device designed to protect electrical devices from voltage spikes? A)…

A: Voltage spikes are said to be occured if there is a sharp rise in the voltage in short time . They…

Q: A power station has a maximum demand of 100 MW and produces 1008 × 10^3 units per day. The power…

Q: Is it more efficient to heat your home with a natural gas furnace or an electric furnace? Explain?

A: Natural gas furnace and electric furnace both are used to generate heat. But the natural gas has the…

Q: PRACTICE 7.9 If vc (t) = 4 cos 105t V in the circuit in Fig. 7.26, find v¸ (t). Ans: -2.4 cos 10ºt…

Q: 6- A system with a unity positive feedback gain has error ratio ----------- where R(s) is the system…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: (a) Calculate the synchronous speed of an eight-pole induction motor when supplied with power from a…

Q: Investigate the stability of the following system (Consider quadratic Lyapunov system) ( 4 =- (यँ-1)…

Q: The Fig. shows the part of a typical power system. If for the discrimination, the time grading…

Q: 4 Find the F.T. of the following Signals using differentiation prop. <-2 2 2 Ans F(w) = 4(sinc(w) -…

Q: A protective put can be used for risk management. A. TRUE B. FALSE

A: ANSWER TRUE A protective put can be used for risk…

Q: What semiconductor materials would be more suitable for a single junction pv device for ground or…

A: GIVEN: Graph between normalized absorbance and wavelength FIND: Based on data, suggest a…

Q: The current rating of an over current relay is 5 A. The relay has a plug setting of 150 % and time…

Q: List the eight degenerate two-level forms and show that they reduce to a single operation. Explain…

A: Two-Level Logic:- A logic design that only employs two logic gates between input and output is…

Q: In the circuit shown below each resistor are 10052. If the battery has 30 V potential differences…

A: Given circuit,

Q: Which electrical component can rectify AC current into DC current? a) p-type semiconductor b) diode…

A: Given , The component which can rectify AC Current into Dc Current is....

Q: 12 v 100 Ω B 200 Ω · A C E 300 < What is the Equivalent Resistance through A to E?

A: Given circuit:

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

A 4 Pole, 50 Three Phase Motor 25 Kg. The meter produces a maximum torque of 1350 Nm per minute. So calculate the torque developed with 5 percent slip. The rotor resistance per winding is 0.5 ohm.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is the horsepower output of the motor?
A 3Ø induction motor has a 4-pole, Y-connected stator winding. The motor runs on a50Hz supply with 200V between lines. The rotor resistance and reactance per phase are0.1 ohms and 0.9 ohms respectively. Calculate:a) The gross torque at 4% slip in N-mb) The maximum torque in ft-lbsThe ratio of rotor to stator turns is 0.67.
The maximum torque of 3-phase induction motor occurs at a slip of 11 percent. The motor has anequivalent secondary resistance of 0.08 ohm/phase. Calculate the equivalent load resistance RL theequivalent load voltage VL and the current at this slip if the gross power output is 8 kW.
3-phase 3730W, 220V, 6-pole and 50 Hz induction motor operates at full load with a slip of 0.025. The sum of the rotational losses including friction + windage losses and other (stray load) losses is 5% of the output power. Find the induced (electromagnetic) moment at full load
3.An induction motor has a rotor resistance and reactance at standstill of 0.1 ohm and 3.5 ohm respectively. At standstill the voltage induced to the rotor is 60volts per phase. If the slip is 5%, determine the rotor current
The rotor resistance and standstill reactance of a 3-phase induction motor are respectively 0.015 ohmsand 0.09 ohms / phase. At normal voltage, the full-load torque at the full-load speed. b.) Calculate thepower factor.
1.Show that if three phase currents, each of equal magnitude and differing in phase by 120degree, flow in a three phase winding that are 120 degree apart from each other then it willproduce a rotating magnetic field of a fixed magnitude. 2. A three phase, 5-hp, 60Hz, 115V, 4-pole induction motor is operating at rated voltage, rated frequency, and 125 percent rated load has an efficiency of 85.4 percent. The stator conductor loss, rotor copper loss and core loss are 223.2W, 153W, and 114.8W respectively.Sketch the power flow diagram, enter the given data, and determine i) shaft speed ii) shaft torque 3. Can single phase induction motor be self-started? Explain the operation of a split phase single phase induction motor?
A 4-pole series motor has 800 lap connected armature conductors. At a certain load, the flux per pole is60mWb and the total mechanical torque developed is 400 N-m. Calculate the line current taken by themotor and the speed at which it will run with a back emf of 400 V. Total motor resistance is 4 ohm.
What is The total losses of 3-phase induction motor at 4A armature current and 1.14Ω rotor external resistance. And the practical result ( T=9.5 N.m, N=1196.17 rpm, Pph=600 watt)
4. A 3 phase,60Hz ,6 pole induction motor has a full load slip of 5%. The rotor resistance is 0.002Ω/ph and the standstill reactance 0.006Ω/ph. Find the speed at which maximum torque occurs.
A 3-phase, 4-pole, 230-V, wound rotor induction motor has both its stator and rotor connected in Y. The stator has half as many turns per phase as the rotor. It has a rotor resistance and blocked rotor reactance of 0.09 and 0.385 ohm respectively. If the rotor is turning at 1760 rpm, determine the rotor power developed in hp. *
A 6 pole, 50 Hz, 3 phase induction motor running on full load develops a useful torque of 150 N.m at a rotor frequency of 1.5Hz, if the mechanical torque lost in friction be 10 N.m, determine the efficiency when the total stator loss is 700W