PRACTICE 7.9 If vc (t) = 4 cos 105t V in the circuit in Fig. 7.26, find v¸ (t). Ans: -2.4 cos 10ºt V. We will not attempt the solution of integrodifferential equations here. It is v (1) 2 mH m 80 nF FIGURE 7.26 18+ VC

Q: digit Digital voltmeter with a 100 mV lowest full-scale range would have a sensitivity of how much…

A:

Q: Determine whether the following Boolean equation is true or false.x ′ y ′ + x ′ z + x ′ z ′ = x ′ z…

A: Considering the LHS: f1=x'y'+x'z+x'z' =x'y'+x'z+z' =x'y'+x' =x'1+y' =x'                  ....1…

Q: Use nodal analysis to determine each of the circuit parameters for the provided circuit

A: The circuit is shown below:  Using the nodal analysis,  VA=40 VVC=10 VVB-VAR1+VBR3+VB-VCR2=0

Q: PSPICE 1.25 MULTISIM The voltage and current at the terminals of the circuit element in Fig. 1.5 are…

A: Given  v = 100e-50tsin(150t) V  i = 20e-50tsin(150t) A P = ? at t = 20ms Energy absorbed

Q: Exercise (3): Show that Z = dz di(z,t) dz R+ joL VG+jwC using the equations: v(2,1)= V(z)e and…

A: Given : ∂vz,t∂z=-Riz,t-L∂iz,t∂z∂iz,t∂z=-Gvz,t-C∂vz,t∂z vz,t=Vzejωtiz,t=Izejωt Find:  The equation of…

Q: A sequential circuit has one flip-flop Q, two inputs x and y, and one output S. It consists of a…

A: Considering the sequential circuit. Determining the truth table. x y Q(t) S C=D D=Q(t+1) 0 0 0…

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

A:

Q: A d.c. 2-wire system is to be converted into a.c. 3-phase, 3-wire system by the addition of a third…

A: A DC 2-wire system is to be converted into 3-phase 3-wire system.   We need to calculate the…

Q: Design a 18 person voter system using 4 bit parallel adder(s) only. Use a minimum number of…

A: Given components: 4-bit parallel adders   To design: An 18-person voter system using a minimum…

Q: B. Find, graphically, y(t) = f(t) * h(t) where h(t) = 8(t) - 8(t - 1) and f(t) is the signal shown…

A:

Q: In BJT transistor V₁ = 0.7 V and V₁ = 25 mV and reverse saturation current is BE 10-13 A. Find the…

A: Given- BJT transistor-VBE=0.7 VVT=25 mVReverse saturation current Is=10-13 ATo Find-The…

Q: Q3:-Using superposition, determine the current through the (6 ) resistor for network of Fig.2.…

A: It is given that:

Q: Q1\ Design the electronic circuit to transformation source voltage (220 V-AC) to output voltage (5…

A:

Q: Vc = -3.50 @ positive half cycle Vo = 8.50 @ negative half cycle Vo = -1.50

A: The clamper circuit is used to Swift the DC line of the input signal based on the diode connection.…

Q: A 415 V, 3-phase voltage is applied to a balanced star-connected 3-phase load of phase impedance (5…

A: We have given an 3-phase voltage which supplies to a balanced star connected 3-phase load with phase…

Q: A transformer primary has 320 turns of wire and the secondary voltage measures 160 V when 40 V is…

A: Given: A transformer has, Primary turns N1=320. Secondary voltage V2=160 V. Primary voltage V1=40 V.…

Q: What substance acts as the moderator in a pressurized water generator?

A: Pressurized Water Generator:- The water in the core is heated by nuclear fission and then pumped…

Q: Plot the response y(k) of the following discrete system (with 5 points is enough) to an input…

A:

Q: d Construct the truth table for the following circuit: D D -

A:

Q: A 100 kVA distribution transformer has an iron loss of 2.0 kW and a total load copper loss of 4.5…

A:

Q: An unbalanced 2-0, 1000 V, 50 Hz induction motor has unequal winding impedances, Z₂=3+j2.7 and Z=…

A: Given- 2-ϕ, 1000 V, 50 Hz, Induction motor. Impedance- Za=3+j2.7,Zb=7+j3 Ω, To Find- Phase currents…

Q: 3. Two 750 kW alternators operate in parallel. The speed regulation of one machine is 100% to 103 %…

A: Given: 750kW alternators are operated in parallel.  P1=750kW, P2=750kW Speed regulation of one…

Q: 5. For the following graph find the Fourier series Ans sin x + sin 3x sin 5.x F Fig. -1

A:

Q: Draw a PLA circuit to implement the functionsF1=A′B+AC+A′BC′ F2=(AC+AB+BC)′

A: Given two functions F1 and F2. F1=A′B+AC+A′BC′ F2=(AC+AB+BC)' Draw the PLA circuit.

Q: Determine the Thévenin equivalent with respect In the terminals a, b for the circuit shown in Fig.…

A: Independent voltage source is short circuited to find the RTH:   v2=66+4×5000i1    =3000i1current…

Q: Draw logic diagrams of the circuits that implement the original and simplified expressions in…

A: Logic diagram:- It is a representation of Boolean arithmetic expression which consists of logic…

Q: A single-phase transformer, with primary turns of 500, is delivering full-load of 80 kW at a lagging…

A: As per our guidelines when student asks multiple subpart questions , we have to answer only first…

Q: and (, we have, 1₁ + 1₂ E₁ + E₂ 2 Z+Z₁ 11

A: Given: Equation for simplification

Q: A PV module produces 334 W at 18 °C and 245 W at 45 °C. a) What is the nameplate power? Give your…

A: Given information, A PV module produces P1=334 W power at T1=18°C and P2=245 W power T2=45°C. We…

Q: 2. A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk C. Vrms d. Period e.…

A: According to Bartleby question answer rule I have to solve first three part of a question hence I…

Q: and Now Z₁ = x₁ + 38 = 1·2+ 38 = 552 Z₂ = x₂+41 = 0.9+4·1=552 Z₁ E₁ E₂ Referring to Fig. 12.87, we…

A: Given I1+I2=200+j250 and    I1-I2=78.1-j56.6 Add above two equations to get current I1 and then…

Q: What is RG rating of coaxial cable? Give detailed answer please

A:

Q: 14 ww 3Ω 8F: + - The circuit above is in DC steady state. What is the value of v, in volts? VC 5Ω

A: We need to find out voltage for given circuit

Q: Plot the following signals: 1. (a) y(t) = f 8(x)dx (b) 92 (t) = f(x-t)dx (c) ys(t)= (t(u(t)-…

A:

Q: An information signal of 3cos(2m10¹t) is given to 3 bit PCM system. Sampling rate is twice of the…

A: Given data: Message signal expression, 3cos(2πm104t) number of encoder bits used per sample, n = 3…

Q: For the circuit shown: b) Find AVS at (re = 10 2)? c) At CE removed, repeat the step b? d) At no…

A: In a small-signal model, the nonlinear circuit components are swapped out with linear ones whose…

Q: In the figure below, what is the voltage Vı in volts? 1000 hel ac Round your answer to 0 decimal…

A:

Q: PROBLEM 4: DETERMINE WHICH CIRCUIT ELEMENTS ARE PASSIVE OR ACTIVE, EACH CIRCUIT ELEMENT'S POWER, AND…

A:

Q: Which is not a source of DC EMF? a. batteries  b. inverter  c. thermocouple  d. piezoelectric…

A: DC EMF:- An electrostatic charge that is present on an object can be compared to DC electric…

Q: Vc = -3.50 Vo = 8.50 C positive half cycle 1.5 Vo = -1.50 KHH negative half cycle 4

A: Given circuit, Graph,

Q: (e mra Given an amplifier with an effective noise temperature of 15,000 K and an 8MHZ bandwidth,…

A: Given- Temperature = 15000 K Bandwidth = 8 MHz To find- Thermal noise level =?

Q: Simplify F(A,B,C₁, D₁E) = {m (0₁4, 7, 8, 9, 12, 16, 18, 20, 22, 23, 24, 25, 26, 27, 28, 30) using a)…

A: Given function: A five-variable function, F which is expressed as, F(A,B,C,D,E) = Σm…

Q: Find V and I in the network shown in Fig. 6.14 (i). Use simplified model.

A: We have been asked to find the values of VQ and ID (Diode current) using simplified model.   First…

Q: Explain the function of the common control block when used with the standard graphic symbols.

A: The control blocks are present in the PLC control system for added functionality in the system. The…

Q: For the electric circuit shown below: a. What is the type of the logic used? b. Draw the truth table…

A:

Q: Consider the following system X₁=x₂-1 X₁₂=X²₁²-x₁ - x₂ + 1 Find the equlbrium 2

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Investigate the stability of the following system (Consider quadratic Lyapunov system) 54 = {==…

A:

Q: -66 Draw direct form I and direct form II implementa- tions for the following difference equations:…

A: Since you have asked multipart questions, we will solve the first three question for you. If you…

Q: 2) Determine (Vo) for the two circuits below using superposition. 20 V 6Ω www 2Α ΣΩ IA να 3 Ω TO 125…

A: When multiple source act on circuit then circuit parameter can be obtained by using superposition…

Q: (2) Q1/ To Design parallel adder that add two numbers A (5-bit) and B (7-bit) must using None of…

A: Given data, Adding two numbers, A (5-bits) B (7-bits)

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.