A 40-microfarad capacitor is connected in parallel with a 40-ohm resistor. What is the real power drawn when source voltage is V = 220 sin100t V?

Q: Basic Electrical Engineering (UPVOTE WILL BE GIVEN. WRITE THE COMPLETE SOLUTIONS. NO LONG…

A: The given problem is from circuits. The detailed solution is given in the next step

Q: (b) Re-produce Figs. 2 and 3 and draw lines in the figures to indicate the ranges (in nm) of the…

A: (a) From Figure-1, the wavelength ranges of red, green and blue LEDs are found out as: Wavelength…

Q: 3. Given the circuit below, use NODAL analysis to solve the circuit. 792 ww 692 1202 Node a: 3 A…

A:

Q: Question 23 What's the wavelength of an electromagnetic wave with frequency 2.00 x 10³ Hz? 3.90 × 10…

A: Given data, Frequency f=2×105 Hz. Speed of light c=3×108 m/s.

Q: G(s): b₁S¹ + b₂ So Saz (aoS² + a₁S¹ + a₂S°)

A: Given: System transfer function, a0=-78, a1=18, a2=3, b0=0, b1=10, b2=-90 To find: System response…

Q: b) The electrical circuit below has all values of resistance equal to 2 2. R1 R3 ww R2 ww www R4

A: The detailed solution is provided below.

Q: A 4 pole ,50 Hz, 3 phase Induction motor, runs at no load with a slip of 0.02 p. u, calculate: 1.…

A: It is given that: p=4f1=50 Hz or rpss=0.02 p.u.Ns2=0.8Ns1

Q: 1. Suppose the following two functions are given. (a)Find out M= P.Q with the help of kmap. (b)Next…

A: DIGITAL ELECTRONICS The area of electronics known as "digital electronics" is concerned with the…

Q: Obtain the node voltages in the circuit.

A: The given circuit diagram is shown below,

Q: a. write the b. solve the initial c. make V (t) ing DE for the network if V (t) = V(E). a unit step…

A:

Q: NOTE: THIS IS A ELECTRONICS ENGINEERING SUBJECT

A: Rectifier is used convert AC Input to Pulsating DC output  Pulsating DC output is converted to less…

Q: An analog voltage in the range 0 to 10.8 V is divided in 16 equal intervals for conversion to 4-bit…

A: We need to find out the maximum quantization error for given quantization.

Q: v₂/0° + 1 R₁ 1 'A HH R, -jX, Q + 1 V/180°

A: Given VA = 9 and VB = 4 Volts. The resistor values are R1 = 10 Ω and R2 = 16 Ω, and X1 =2 finding…

Q: Explain What is Operating Temperature.

A: Every device or electrical instrument operates on a particular range of temperatures, if the device…

Q: Find the Norton equivalent with respect to terminals a-b in the circuit shown in the figure. Take Vs…

A:

Q: Your company has been chosen to supply a 50 Hz alternator to a European utility. The stator is wye…

A:

Q: If R₂ becomes open-circuited, what will be the reading of the volt-meter V. Show your solution and…

A: The voltage across the open circuit terminal is finite and current through the open circuit terminal…

Q: R A of cost ap +2²az созфар convet it into Cartesian System

A: To convert the given cylinderical to Cartesian coordinate

Q: G(s) = K s(s+2)(s² +8s +80) Given unity feedback system forward transfer function, determine: The…

A: Given data: The transfer function of the unity feedback system, Gs=Kss+2s2+8s+80 We need to…

Q: (a) (b) The impulse response of the system is h(t) = (4e¯¹ - 2e-3t)u(t) Find Laplace transform of…

A: It is given that: ht=4e-t-2e-3tut

Q: Investigate about Phase Control Thyristors this investigation must contain the following: -Building…

A: It is asked to show the building (schematic symbol or structure), the behavior in different…

Q: describe all parts

A:

Q: Question No. 1 The number of chords in the graph of the given circuit will be ww HH

A: Given circuit-   To find- The number of chords in the graph.

Q: Please use Equation Operators Here   Apply KVL in the loop-1:…

A: I have provided you the hand written solution for your doubt. Please go through it

Q: R(s) G G H Y(s)

A:

Q: II. III. IV. V. What is the effect of load on the efficiency of an induction motor? Explain the term…

A: Since, the question posted by you has multiple sub-parts, we will solve the first three sub-parts…

Q: 8 Α ↑ 6Ω 4 Ω ΖΩ Τ 6 Α

A: The given circuit diagram is shown below,

Q: Convert the following systems to signal flow graphs and solve for the transfer function using…

A:

Q: 2. The boost converter has parameter 3. The buck-boost converter has parameters Vs = 12 V, D = 0.6,…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: The distance x, measured in metres, of a downhill skier from a fixed point is measured at intervals…

A: It is given that: t 0 0.25 0.5 0.75 1 1.25 1.5 x 0 4.3 10.2 17.2 26.2 33.1 39.1

Q: Which of the following issues degrade the transmission quality of a perfectly synchronised AM…

A:

Q: 3. For the figure below, determine the mode voltages at nodes 1, 2 and 3. (Nodal Analysis) 1 492 292…

A:

Q: 2. Consider the circuit diagram below. Solve for the voltages at nodes a and b using node analysis.…

A: Given is a circuit with a voltage source of 100V. For nodal analysis at node a and b calculate the…

Q: First, a current will run through the solenoid only. Question 2. What does the current running…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: you never gave me the slate diagram.

A: State diagram: It is a pictorial representation of a sequential circuit where each circle indicates…

Q: 6- Plot the signal x(t) = 5 sin(2π x 3 x 10³ t). Find its cyclic frequency, its radial frequency and…

A: The general expression of a sinusoidal signal is given as A sin(2×π×f×t +α) Where A= Amplitude f=…

Q: The time constant for the given circuit will be 1 F==== F: 1 F =1 F 32 M 3 Ω 3 A

A:

Q: "Bias voltage applied to the emitter electrode of a transistor offers greater stability over bias…

A: We need to discuss why bias voltage applied to the emitter electrode of a transistor offers greater…

Q: Determine the range of k using the bilinear transformation method, for which the system remains…

A: This question is based on stability criteria in both s and z domains and the Bilinear transformation…

Q: G 10.77 Find Vs in the network in Fig. P10.77. 1:2 0.1Ω Vs j0.2 Ω 2 kW 0.8 pf lagging Ideal 10 kW…

A: In this question we need to find the voltage Vs of the given circuit.

Q: 2- Draw the Bode Plot of the open loop transfer function of a feedback system given by 10(s+3)…

A: 0

Q: (h) (i) s+1 s(s+ 2)² (s² + 4s+5) $3 (s+ 1)² (s² +2s+5)

A:

Q: Exercise: 1 Consider the system shown in Figure 1. To improve the performance of the system a…

A: The given system can be analysed by reducing the given block diagram to find the closed loop…

Q: i(t) V R e - Rt L

A:

Q: Which of the following-combinations cannot be combined into K-map groups?   A. corners in the same…

A:

Q: 2 Using Complex number approach ONLY, find the voltage drop across the capacitor, where Vs = 100…

A: Given: V=100∠0° V,R=100 Ω,XL=j75 Ω=75∠90°,XC=-j25 Ω=25∠-90°. Circuit:

Q: Problem- A single-phase voltage controller has input voltage of 220 V, 50 Hz and a load of R = 20…

A: Given- A single-phase voltage controller, Input voltage=220 V, Frequency f=50 Hz, Load- R=20 Ω, 6…

Q: A satellite in synchronous orbit is used to communicate with an earth station at a distance of 2.2 x…

A: We need to find out loss and received power for given satellite .

Q: 3. Determine Vo. 12 V (+) 82 M Vo 252 W +7V

A: Given circuit:-

Q: b. The open loop gain cross over frequency of a continuous-time plant is 2.1 rad/s. Determine the…

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.