A 420-mH coil has a resistance of 10 ohms. If a 12V supply is applied to it, how long will it take for the coil current to build up to 69% of its maximum value

Q: The value of Qe supplied by the generator for the specification E = 1.53 p.u, V = 1 p.u, 80 = 21.5, ...

A: Given, Generated voltage, E = 1.53 pu Terminal voltage, V = 1 pu Load angle, δ=21.5° Synchronous rea...

Q: 3. y" – 2y' + 5y = 0 initial conditions: y(0) = -1 and y'(0) = 7 %3D %3D

A:

Q: foo 3.

A:

Q: In the figure, the load absorbs 22.256 KVA at a power factor 0.544639 inductive. For the feeder (cab...

A: The solution is given below 

Q: Find the voltage drop across the 150resistor and 300resistor.

A:

Q: Theoretical Calculations: 1. What is the polarity of the input voltage Uin compared with the output ...

A:

Q: 4. What is the polarity of the input voltage Uin compared with the output voltage Uout in Non-invert...

A:

Q: QI. The figure below shows a one line diagram of a three-phase power network in which a load of 1.5 ...

A: given transformer 33/11 kV voltage at 33 kV side is maintained at 33.6 kV Hence voltage at 11 kV sid...

Q: 2. A shunt generator delivers 100 A at terminal voltage of 250 v. The armature resistance and shunt ...

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other par...

Q: An 8-pole, 3-phase, 50 Hz induction motor is operating at a speed of 720 rpm.. The frequency of the ...

A:

Q: name of symbol name of symbol name of symbol name of symbol name of symbol * name of symbol name of ...

A: Hydraulic- Hydraulic is the technology that deals with the generation, control, and transmission of ...

Q: Transient C1 10µF V1 D1 10Vpk 1kHz 0° R1 25.6kQ -15 -20 -25 Om 2m 4m 6m 8m 10m Time (s) V(1) VPRI) S...

A: We need to find out output voltage for given clamper circuit.

Q: 0.003 VA 20V 200MA 0.4Va t. 2502 io 1002 S0052 2002

A:

Q: Q2/ Calculate the value of the battery shown in the circuit below, given that the current value is 1...

A:

Q: Design a combinational circuit with three inputs x, y, and z with three outputs A, B, and C, when th...

A: Brief description : According to the given question here they want to design a combinational logic c...

Q: Calculate the value of the source voltage in the circuit shown below and the equivalent resistance? ...

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per ...

Q: Determine Ip. Si Si 12V 5.6 kN O 2.143 mA O 1.893 mA O 2.036 mA O O mA

A: The solution is given below 

Q: The energy dissipated in a circuit is rated at 240 microJoules. If the supply voltage is given to be...

A:

Q: 50. It is the resistance of a material when there is no supply. Hot Resistance Infinite Resistance ...

A:

Q: Determine the voltage across the resistor if the Diode is GaAs. 0.2 V 3 kQ O 0.2 V O 0.44 V Ov O 0.0...

A: Knee voltage of GaAs diode is 1.5 V . In order to turn on the diode , the voltage at anode must be g...

Q: Compare the results of static or dc resistance of the diodes obtained from different values of forwa...

A: The characteristics of a virtual diode and a 1N4001 diode is shown in the question. The values of re...

Q: Current is the flow of charges in a directed path. When we connect your mobile phone charger to the ...

A: Charging up a battery is the exact opposite of discharging it: where discharging gives out energy, c...

Q: = 79.265 + j56.586 = 97.39Z35.52°V or 97.39Z0.620 V What is the formula or process to get this kind ...

A: Consider the formula to convert the polar form to rectangular. r∠θ=x2+y2∠tan-1yx

Q: 6. For the ac series-parallel circuit (Fig. 11-32), find the total current, the current through each...

A:

Q: solve the I1, I2, IT using mesh analysis

A:

Q: A 4 pole, long-shunt lap wound generator supplies 20 kW at a terminal voltage of 300 V. The armature...

A: This question belongs to electrical machine . It is based on the concept of induced e.m.f. in long s...

Q: Applying the different laws and identities in Boolean algebra, determine the minterm expansion of th...

A:

Q: 3. Adding Extra DC Voltage Source (+5V) R1 Vo 1K Vi D 5V 4. Adding Extra DC Voltage Source (-5V) R1 ...

A:

Q: Find the equivalent impedance across a and b in polar form. Find the magnitude and angle in four dec...

A:

Q: VCC 10V RC $3.6kN 10% R1 10kn 10% C2 B = 150. 01 2N3904 C1 RS 1kn 10% 1pF RL vs 1.5kN 10% CE 470uF R...

A: We will do DC analysis to find current and we will do ac analysis to find input, output impedance an...

Q: An FM signal expressed as S(t)-1000cos[2*z*10°t+0.5cos(2* x*10*t)] is measured in an 50 N antenna. D...

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part y...

Q: 1. A boatman rows to a place 48 km distant and back in 14 hours; he finds that he can rous 4 km with...

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...

Q: An Ensineer i to cating. desigin r applianawt apote I W. If Ithe fallowwing date were dotainal of fr...

A:

Q: Q3: Calculate the value of the eye aid in Figure T? V-5V V=7V V=6V V=8V

A:

Q: (sti)°+5

A:

Q: A capacitor is constructed with parallel metal plates, If the plate separation is 2 mm and the capac...

A:

Q: A power conversion system having an impulse response h[n]={1,-1} accepts the input x[n]={1,-2,2, 1,3...

A:

Q: Two alternating voltages are given by vị = 120 sin wt volts and v2 = 200 sin(wt volts. Obtain the si...

A: This question belongs to basic electrical . It is based on the concept of calculation of expression ...

Q: Determine the current I1, I2, and I3 in the circuit below in polar form. Write the angle only in fou...

A: This question belongs to circuit theory . It is based on the concept of equivalent impedance and cur...

Q: A 75 MHz carrier having an amplitude of 50 V is modulated by a 3 kHz audio signal that has an amplit...

A: Given, Carrier frequency (fc) = 75 MHz Carrier amplitude (Ac) = 50 V Amplitude of audio signal ( Am)...

Q: Answer b, c, d D2.6. Four infinite uniform sheets of charge are located as follows: 20 pC/m2 at y 7,...

A:

Q: piece of cotton cloth is used to clean a piece of wood. In the process of rubbing these two material...

A:

Q: The open loop transfer function of unity feedback system is given by G(s)= - K (s+1)(s+2)(s+3) Using...

A: Given, Open loop transfer function, Gs=Ks+1s+2s+3 Unity feedback, Hs=1

Q: (s+0.5)2+4 H(z) Iš designed from H«(s) by many-one mapping method, assuming sampling period T. Then,...

A:

Q: For the network of Fig. 5.154: a. Determine r.. b. Calculate Z; and Z,. c. Find Ay. d. Repeat parts ...

A: Solve the first three sub-parts in a multiple sub-part question, unless the student has asked for sp...

Q: find a sinusoid that is equivalent to 4.12 sin (64t - 10°) - 6.23 sin (64t - 35°) + 7.26 cos (64t - ...

A:

Q: DFT

A:

Q: For the given circuit and input waveform, determine the output waveform maximum and minimum voltages...

A:

Q: The discrete time periodic signal has (2, 0, 0, 1} samples. The frequency domain samples of the give...

A:

Q: S+4

A: