A 450.0 N, uniform, 1.50 m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 500.0 N without breaking, and cable B can support up to 300.0 N. You want to place a small weight on this bar. Part A For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Locating your center of gravity while you work out. What is the heaviest weight you can put on without breaking either cable? Express your answer with the appropriate units. HẢ ? Value Units Submit Request Answer Part B Where should you put this weight? Express your answer with the appropriate units. d = Value Units from the cable A Submit Request Answer

A 450.0 N, uniform, 1.50 m bar is suspended horizontally by two vertical cables at each end. Cable A can support a maximum tension of 500.0 N without breaking, and cable B can support up to 300.0 N. You want to place a small weight on this bar. Part A For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Locating your center of gravity while you work out. What is the heaviest weight you can put on without breaking either cable? Express your answer with the appropriate units. HẢ ? Value Units Submit Request Answer Part B Where should you put this weight? Express your answer with the appropriate units. d = Value Units from the cable A Submit Request Answer

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter14: Static Equilibrium, Elasticity, And Fracture

Section: Chapter Questions

Problem 69PQ

See similar textbooks

Similar questions

1.Two people are carrying a uniform wooden ladder that is 3.0 m long and weighs 100 N. if a man applies an upward force equal to 40 N at one end, at what point should the other man apply the upward lift to keep the system in equilibrium?
Suppose the weight of the drawbridge in Figure 9.34 is supported entirely by its hinges and the opposite shore, so that its cables are slack. (a) What fraction of the weight is supported by the opposite shore if the point of support is directly beneath the cable attachments? (b) What is the direction and magnitude of the force the hinges exert on the bridge under these circumstances? The mass of the bridge is 2500 kg.
What Is Static Equilibrium? Problems 13 are grouped. 1. C A ball is attached to a strong, lightweight rod (Fig. P14.1). The rod is supported by a horizontal pin near the top. The ball is at rest. Is the ball in static equilibrium? If not, why not? If so, which type of equilibrium is itstable, unstable, or neutral? Hint: What would happen if you displaced the ball slightly? FIGURE P14.1
Explain the need for tall towers on a suspension bridge to ensure stable equilibrium.
a) What is the mechanical advantage of a wheelbarrow, such as the one in Figure 9.24, if the center of gravity of the wheelbarrow and its load has a perpendicular lever arm of 5.50 cm, while the hands have a perpendicular lever arm of 1.02 m? (b) What upward force should you exert to support the wheelbarrow and its load if their combined mass is 55.0 kg? (c) What force does the wheel exert on the ground? Figure 9.24 (a) In the case of the wheelbarrow, the output force or load is between the pivot and the input force. The pivot IS the wheel's axle. Here, the output force is greater than the input force. Thus, a wheelbarrow enables you to lift much heavier loads than you could with your body alone. (b) In the case of the shovel, the input force is between the pivot and the load, but the input lever arm is shorter than the output lever arm. The pivot is at the handle held by the right hand. Here, the output force (supporting the shovel's load) is less than the input force (from the hand nearest the load), because the Input is exerted closer to the pivot than is the output
What force must be applied at point P to keep the structure shown in equilibrium? The weight of the structure is negligible.
In an isometric exercise a person places a hand on a scale and pushes vertically downward, keeping the forearm horizontal. This is possible because the triceps muscle applies an upward force M perpendicular to the arm, as the drawing indicates. The forearm weighs 24.0 N and has a center of gravity as indicated. The scale registers 103 N. Determine the magnitude of M. N
A 5.15-N beam of uniform density is 1.70 m long. The beam is supported at an angle of 35.0° by a cable attached to one end. There is a pin through the other end of the beam (see figure below). Use the values given in the figure to find the tension in the cable. (Assume L = 1.70 m and d = 0.390 m.)
A uniform platform with mass M=30kg and length L=15m is placed on two supports as shown. The distance between the supports is a=6m and F=340N is applied as shown with distance b=4m. The system is in static equilibrium. a) Find Normal force FN1 in Newtons. b) Find Normal force FN2 in Newtons.
A 45.1 kg man is walking on a 147 kg uniform beam that is attached 19.0 m below the top of a building and is 21.2 m long. If a wire is attached to both the top of the building and end of the beam, and is able to handle 1.52E3 N of tension, how close to the end can the man walk before the wire breaks?
A uniform 36.0-kg beam of length ℓ = 4.20 m is supported by a vertical rope located d = 1.20 m from its left end as in the figure below. The right end of the beam is supported by a vertical column. Answer parts a-b.
A uniform 34.5-kg beam of length ℓ = 5.95 m is supported by a vertical rope located d = 1.20 m from its left end as in the figure below. The right end of the beam is supported by a vertical column. (a) Find the tension in the rope._____________N(b) Find the force that the column exerts on the right end of the beam. (Enter the magnitude.) _____________N