A 55-kg skateboarder enters a ramp moving horizontally with a speed of 6.5 m/s, and leaves the ramp moving vertically with a speed of 4.1 m/s. (A) Find the height of the ramp, assuming no energy loss to frictional forces. (B) What is the skateboarder's maximum height above the bottom of the ramp? h? G.5 ms

A 55-kg skateboarder enters a ramp moving horizontally with a speed of 6.5 m/s, and leaves the ramp moving vertically with a speed of 4.1 m/s. (A) Find the height of the ramp, assuming no energy loss to frictional forces. (B) What is the skateboarder's maximum height above the bottom of the ramp? h? G.5 ms

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter8: Potential Energy And Conservation Of Energy

Section: Chapter Questions

Problem 68P: Shown below is a box of mass m1 that sits on a frictionless incline at an angle above the horizontal...

See similar textbooks

Similar questions

A roller-coaster car of mass 1.50 103 kg is initially at the top of a rise at point . It then moves 35.0 m at an angle of 50.0 below the horizontal to a lower point . (a) Find both the potential energy of the system when the car is at points and and the change in potential energy as the car moves from point to point , assuming y = 0 at point . (b) Repeat part (a), this time choosing y = 0 at point , which is another 15.0 m down the same slope from point .
A 2.0-kg block starts with a speed of 10 m/s at the bottom of a plane inclined at 37 to the horizontal. The coefficient of sliding friction between the block and plane is k=0.30 . (a) Use the work-energy principle to determine how far the block slides along the plane before momentarily coming to rest. (b) After stopping, the block slides back down the plane. What is its speed when It reaches the bottom? (Hint: For the round trip, only the force of friction does work on the block.)
In a Coyote/Road Runner cartoon clip (https://openstaxcollege.org/l/21coyroadcarcl), a spring expands quickly and sends the coyote into a rock. If the spring extended 5 m and sent the coyote of mass 20 kg to a speed of 15 m/s, (a) what is the spring constant of this spring? (b) If the coyote were sent vertically into the air with the energy given to him by the spring, how high could he go if there were no non-conservative forces?
The force on a particle of mass 2.0 kg varies with position according to F(x)=3.0x2 (x in meters, F(x) in newtons). The particle’s velocity at x=2.0m is 5.0 m/s. Calculate the mechanical energy of the particle using (a) the origin as the reference point and (b) x = 4.0 m as the reference point. (c) Find the particle’s velocity at x=1.0m . Do this part of the problem for each reference point.
A shopper pushes a grocery cart 20.0 m at constant speed on level ground, against a 35.0 N frictional force. He pushes in a direction 25.0° below the horizontal. (a) What is the work done on the cart by friction? (b) What is the work done on the cart by the gravitational force? (c) What is the work done on the cart by the shopper? (d) Find the force the shopper exerts, using energy considerations. (e) What is the total work done on the cart?
A block of mass m = 5.00 kg is released from point and slides on the frictionless track shown in Figure P7.6. Determine (a) the blocks speed at points and and (b) the net work done by the gravitational force on the block as it moves from point to point . Figure P7.6
The Flybar high-tech pogo stick is advertised as being capable of launching jumpers up to 6 ft. The ad says that the minimum weight of a jumper is 120 lb and the maximum weight is 250 lb. It also says that the pogo stick uses a patented system of elastometric rubber springs that provides up to 1200 lbs of thrust, something common helical spring sticks simply cannot achieve (rubber has 10 times the energy storing capability of steel). a. Use Figure P8.32 to estimate the maximum compression of the pogo sticks spring. Include the uncertainty in your estimate. b. What is the effective spring constant of the elastometric rubber springs? Comment on the claim that rubber has 10 times the energy-storing capability of steel. c. Check the ads claim that the maximum height a jumper can achieve is 6 ft.
Answer yes or no to each of the following questions. (a) Can an objectEarth system have kinetic energy and not gravitational potential energy? (b) Can it have gravitational potential energy and not kinetic energy? (c) Can it have both types of energy at the same moment? (d) Can it have neither?
When jogging at 13 km/h on a level surface, a 70-kg man uses energy at a rate of approximately 850 W. Using the facts that the “human engine” is approximately 25 efficient, determine the rate at which this man uses energy when jogging up a 5.0 slope at this same speed. Assume that the frictional retarding force is the same in both cases.
“ E=K+Uconstant is a special case of the work energy theorem.” Discuss this statement.
In the movie Monty Python and the Holy Grail (https://openstaxcollege. org/l/21monpytmovcl) a cow is catapulted from the top of a castle wall over to the people down below. The gravitational potential energy is set to zero at ground level. The cow is launched from a spring of spring constant 1.1 104 N/m that is expanded 0.5 m from equilibrium. If the castle is 9.1 m tall and the mass of the cow is 110 kg, (a) what is the gravitational potential energy of the cow at the top of the castle? (b) What is the elastic spring energy of the cow before the catapult is released? (c) What is the speed of the cow right before it lands on the ground?
Shown below is a box of mass m1 that sits on a frictionless incline at an angle above the horizontal =30. This box is connected by a relatively massless string, over a frictionless pulley, and finally connected to a box at rest over the ledge, labeled m2 . If m 1 and m2 are a height h above the ground and m2m1: (a) What is the initial gravitational potential energy of the system? (b) What is the final kinetic energy of the system?