A 55000-kW thermal plant of National Power Corporation delivers an annual output of 238000000 kw-hr with a peak load of 44 MW. What is the capacity factor?  49.4% 42.4% 48.2% 44.6%

Q: In the equation for part 2 should the first term be AB instead of AD. You have AB in the original…

A: Given minterms are 8,11,12,13,15 Don't cares are 0,1,2,5,7,10,14 Asked to find output expression?…

Q: 1. Can the given. oscillation Circuit oscillate, if so find Wo. B₂ + and the condition fo

A: According to the question, we need to explain the given circuit.

Q: a). Find the voltage, Vs in the electric network shown in figure B, R₁ = 3 k2

A: Given data, Circuit diagram is given as,

Q: What is EMI and EMC ? How we take care in case of Electrical Hardware design?

A: EMI (Electromagnetic Interference) and EMC (Electromagnetic Compatibility) are two related concepts…

Q: Determine which of the logic circuits In Figure bellow are equivalent. O O 'B' Select one: O O O E…

A: We need to select correct option for given logic diagram .

Q: What are available techniques to start a synchronous motor?

A: Synchronous motors are AC motors that spin at a consistent speed in time with the power supply's…

Q: Use the principle of superposition to find th rent i in the circuit of Fig. P4.97. Figure P4.97 de…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: with the help of Routh`s stability criterion find the stability of the following systems represented…

A: systems represented by the characteristic equation. a) s^2+s^4+2s^3+2s^2+3s+5=0 b)…

Q: Find the Norton equivalent of the circuit of Figure P3.37. 10 V + 3 Ω 6Ω + V 4Ω 2Ω •v/2

A: For Norton equivalent circuit , we need to find Isc as and RN  For this circuit

Q: Find and use the Laplace transform of ejot+0)u(t) to obtain the Laplace transform of x(t) = cos(not…

A:

Q: Find i W 2^ 34 tony чк

A:

Q: Obtain the sum of the products expressions for the function F = Σ (1, 4, 7, 8, 9, 11) + d (0, 3, 5)…

A:

Q: Implement the following three Boolean functions using a PLA with 3 inputs, product terms, 3 outputs.…

A: Given,The boolean functions are,F1a,b,c=∑0,3,4,7F2a,b,c=∑0,1,6,7F3a,b,c=∑1,2,5,6

Q: Find RT , VT , and IT

A: It is given that: Assuming ZM1 as load.

Q: ao 25 mH 10 mH 60 mH 20 mH 30 mH -ob N 4 H 9 H 10 H 6 H 12 H 3H

A:

Q: 2. Using nodal voltage method, find the magnitude and direction of current I in the network of Fig.…

A: Using node voltage method calculation of current I of the given circuit. In this circuit there are…

Q: Problem 3: a) vc (t), t≥ 0. t=0 The circuit is at steady-state before the switch closes at t = 0.…

A: problem 3:-

Q: what are t and f stands for

A: The transfer function is derived based on the cutoff frequency of the given bode plot and from the…

Q: 20. For the circuit of Fig. 4.50, determine all four nodal voltages. 10 Ω Θον 4Ωξεν 6V V Μ 1Ω 2 Α Μ…

A: We need to find out the node voltage for given circuit .

Q: In the circuit given below, Op-Amp is ideal. Calculate the voltage V,, Vy and Vo 20k ww 9+10V 4V Vy…

A:

Q: Prove that (A + B) • A + B

A:

Q: 1. If S is closed for a long time, and then opens at t=0, find the voltage across the capacitor as a…

A: Introduction Transient Analysis: The examination of a circuit's performance during the time just…

Q: Problem 3: You can choose your analysis method. The circuit is in DC steady-state before switch…

A:

Q: A synchronous motor is operated form a bus voltage of 1.0 P.U. and is drawing 1.0 P.U. zero power…

A: Given: A synchronous motor operated from, Bus voltage, Vt=1 pu Current drawing, Ia=1 pu Synchronous…

Q: 5 ww 25 V V₁ A ww 10 V/₂ B 4 2 ww 50 V + 7. With the help of nodal analysis, find V, and V₂ and…

A: We need to find out the current and voltage for given circuit. First we will find out the voltage by…

Q: Refer here for the specifications of the D400. a)     What power output should you be able to…

A: Given the information, the specifications of the D400. Able to supply Votage from the 24V D400 at…

Q: Given the following transfer function, where time is measured in seconds: X(s) F(s) The natural…

A: We need to find out natural frequency and we need to check stability for given system .

Q: 3V Solve for ix (t). зуучл молока + tix 8л V. 1

A:

Q: In a coil of 2mH inductance, current changes from 0.2 A to 1.5 A in 0.2 s. Find the magnitude of…

A: Given: Inductance, L = 2 mH Current changes, dI=1.5-0.2=1.3 A. Time, t = 2 sec.

Q: please re-do this question. where did u get p=10W? and when is power in inductor and capacitor 0?…

A: Given data: frequency f=50 hz Apparent power across the impedance Z=(10+j5)VA Capacitance C=2F…

Q: The variable resistor in the circuit attached is adjusted for maximum power transfer to R0. a) find…

A:

Q: How do I get the eight BIT Adder Subtracter Module (the square one) on Quartus 2?

A: To get an eight-bit adder-subtractor module in Quartus II, you can follow these steps: Open…

Q: 1. (a) Write a function file that can be used to calculate the equivalent resistance of n…

A: According to the bartleby's guidelines we have to solve only one question posted by students so…

Q: Refer to the circuit below and use nodal analysis 2A(+) 201 O downward Va O upward O to the right O…

A: We need to find out the current through given resistor in the the given circuit.

Q: 7. Using Millman's theorem, find the value of output voltage V, in the circuit of Fig. 2.244. All…

A:

Q: 5- Find the input x(n) that will produce a response, y(n) = 6(n), for a system described by the…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: Halle the equivalent inductance of the following Circuits

A: Equivalent inductance Lab is calculated by using reduction technique. Series and parallel formulae.…

Q: A Four charges are located on rners a square as shown. Which location (A-E) has the largest electric…

A: Given the Foure charge at corner of squre

Q: Design a circuit to measure AC power using pic microcontroller. 1. Write the circuit diagram. 2.…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 3. When a 3-phase, star connected alternator is fully loaded at 0.8 p.f lagging, the terminal…

A: In this question We need to determine the voltage regulation We know Voltage regulation in…

Q: 18. Two storage batteries, A and B, are connected in parallel to supply a load the resistance of…

A: Introduction Combination of batteries: When two or more batteries are connected together, their…

Q: Problem 3: Estimate the peak-to-peak ripple in vo V(t) 52V 48V 10ms 1+ I V 40k D1 KH D2 z

A: answer : given that  voltage source V(t) = 48 - 52 V normal diode and Zener diode so cut-off…

Q: refer to the circuit below, if R = 5 ohms, V1 = 10V, V2 = 4V and Is = 2A. R Vo V₂ what is the…

A: Concept Voltage in parallel branches will be same, and current in series branches will be same…

Q: The four arms of a Wheatstone bridge have the following resistances ; AB = 100, BC = 10, CD = 4, DA…

A: Drawing the circuit according to the given data:

Q: Question 3. The mean length of the magnetic core is 20 cm, the cross section is 5 cm2, and the…

A: Introduction In electrical engineering, the reluctance of a magnetic core refers to its opposition…

Q: A 120VAC_RMS, 60Hz line is connected to a Triac which produces a RMS output of 89.431 volts.…

A: Given supply voltage Vs=120 V RMS supply voltage peak value = Vm =2 ×120 =169.70 V Output RMS…

Q: For the output y(t) having a Laplace transform of: Y(s)=(s+21)/(s3+7s2+80s) Determine the final…

A:

Q: 1.Draw the circuit using NAND gate ONLY : AB'+B'C+B'D+ACD'

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: An impedance coil of power factor 0.8 is connected in series with a 110 µF capacitor to a 50 Hz ac…

A: