A 6.36 µF capacitor is connected in parallel with a resistance of 5000 and the combination is connected in series with a 500n resistor. The whole circuit is connected across an ac source given by e=300sin (wt) + 100 sin(3wt +30°). If w = 314 rad/s. find: a) Irms b) Vrms c) total active power d) total power factor e) total reactive power f) total apparent power

A 6.36 µF capacitor is connected in parallel with a resistance of 5000 and the combination is connected in series with a 500n resistor. The whole circuit is connected across an ac source given by e=300sin (wt) + 100 sin(3wt +30°). If w = 314 rad/s. find: a) Irms b) Vrms c) total active power d) total power factor e) total reactive power f) total apparent power

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V, that the voltage drop across the...

See similar textbooks

Similar questions

a series r-c circuit takes a current whose equation is i=0.85sin(754t+pi/4) when connected to a source of emf having the equation e=340sin754t. calculate the capacitance of the capacitor, circuit power factor, and power.
In the series circuit of Fig, the source has voltage amplitude 20.0 V and angular frequency 5.40 x 103 rad/s, the inductance is 6.50 mH, the capacitance is 0.600 µF, and the impedance is 474 Ω. Find (a) the resistance, (b) the current amplitude, (c) the resistor voltage amplitude, (d) the inductor voltage amplitude, and (e) the capacitor voltage amplitude
A series L–R–C circuit has a supply input of 5 volts. Given that inductance, L = 5 mH, resistance, R = 75ohms and capacitance, C = 0.2µF, determine A) the value of the maximum voltage across the capacitor. B) A capacitor having a Q-factor of 250 is connected in series with a coil which has a Q-factor of 80. Calculate the overall Q-factor of the circuit.
A patient is coupled by 5pF stray capacitance to a 220V 50Hz ac power-line bus while his body is insulated from ground. The resistance experienced from the right side of the circuit, Za is measured to be 4MΩ.Find the voltage, Vo(t) and the voltage, Io(t) by usingphasor techniques.
A 200V, 50 Hz sinusoidal supply is connected to a parallel network comprising three branchesA, B and C as follows: A, a coil of resistance 3 ohm and inductive reactance 4 ohm; B, a seriescircuit of resistance 4 ohm and capacitive reactance 3 ohm; C, a capacitor. Given that the powerfactor of the combined circuit us unity, find (a) the capacitance of the capacitor inF; (b) the current taken from the supply. [Ans. 127.32 F, 56A]
a series rlc circuit having values of pure resistance r=40 ohms and pure inductance l = 50.07 mh. the circuit draws 10 A of current when it is connected across a 400 v , 50hz ,ac supply. calculate the (1) capacitor value and (2) power factor of circuit.
Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v, the current is 2mA, resistance is 12 kΩ , inductance 27 mH and capacitance 0.2 µf
A pure inductance of L = 120 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the inductor is given by
A resistor'R' with resistance value of 24 ohm, an inductor 'L' with inductance 20mH, and a capacitor 'C' with capacitance 50 micro Farrad are connected in series with a AC voltage v(t) where v(t) = 50 cos (2 vt + 30 degrees) v. Determine the current i(t) and total impedance if the frequency f is i. 60 Hz ii. 400Hz
Show your complete solution and attached it here. Answer must be in 4 decimal places. An industrial coil is modeled as a series combination of an inductance L and resistance R. Since an ac voltmeter measures only the magnitude of a sinusoid, the following measurements are taken at 60 Hz when the circuit operates in the steady-state: |Vs| = 145 V, |V1| = 50 V, |Vo| = 110 V Use these measurements to determine the values of L and R.
Show that at a given frequency ω, the circuits will have the same impedance between the terminals a,b ifR1=R21+ω2R22C22,C1=1+ω2R22C22ω2R22C2.2. Find the values of resistance and capacitance that when connectedin series will have the same impedance at 40 krad/s as that of a1000 Ω resistor connected in parallel with a 50 nF capacitor.
Write in rectangular and polar notations, the impedance of each of the following circuits at a frequency of 50Hz. That have a, 2.1 A resistor of 2002 in series with an inductor of 0.1H.