Answered: A 60-Hz induction motor runs at 860…

A 60-Hz induction motor runs at 860 r/min at full load. Determine a. the synchronous speed, b. the frequency of the rotor currents Note: Number of poles are 8.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 6RQ: Name three factors that determine the torque produced by an induction motor.

See similar textbooks

Related questions

Q: Q3: A// Use Boolean Algebra techniques to simplify. (Answer 1 or 2). 1-Y =[AB (C+BD) + ABJC 2-Y AB+…

Q: 4 For an intensity of a single sided exponential pulse I(t) = eat; find I(w) using the Fourier…

Q: 4. Acar lot uses incandescent lamps to supply outside lighting during the night. There are three…

Q: A transformer works at 6 KVA with a primary voltage of 82 V. If the load voltage is 235 V ,then the…

A: Given: A transformer works at, Rated apparent power, S=6 kVA. Primary voltage, V1=82 V. Secondary…

Q: Problem 8. For the oscilloscope display of a pulse waveform shown in Figure 10.18 the 'time/cm'…

Q: 30 V (1) Find the relevant physical INITIAL CONDITIONS for the circuit shown (2) Find the…

Q: The impulse function is denoted by: оооо Oh(t) u(t) or 8(t) O 8(t) Ou(t)

A: Given here a question and asked to find the correct option.

Q: Please answer this with complete solution A coil of 1000 turns is wound on a toroidal magnetic core…

Q: The terminal p.d. of a d.c. source is 22.5V when supplying a load current of 10 A. If the emf is 24V…

Q: Using current divider for the below circuit 5 mA R₁ 14 2 ΚΩ 0₁ R₂ 13 ΚΩ

A: Given data, Circuit diagram is given as,

Q: If the unit step response of a network is (1 - e-at), then Find its unit impulse response

Q: 5A V3 O a. 5v1 Ob. 201 www O c. 5v₁ - 492 202 w www Pi V2 2v3 = -2 5v₂ + 2V3 ww = V2 - 2v3 = 4 Od.…

Q: 4. Determine / in the given circuit. SV 3.2 M 75 8V

A: Given data, Circuit diagram is given as,

Q: Compare the sum of the current passing through R1, R2 and R3 with the total current. What have you…

A: Given- Source voltage = 12 V To find- Current through R1, R2 and R3 and total current= ?

Q: Show that the current through a room temperature silicon diode with ideality factor n = 2 increases…

A: SOLUTION GIVEN--> Ideality Factor n = 2…

Q: 1. For all questions, assume T = 300K unless specified, VT = kT/q = 0.026V, q= 1.6x10-19, ni =…

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Introduction: The term IoT or Internet of Things refers to a collective network of connected devices…

Q: How to combine 3(s-1)+5 like terms?

A: Given term: 3(s-1)+5

Q: Given is the buck-boost(Cuk) converter with the following data: Input voltage Vg = 42 V Output…

A: Given Vg=42 V V0=24 V fs=200 kHz R =10 Ω

Q: For the circuit shown in the figure, the Nodal Equation for node 1 is: ΤΩ www 5A Vs a. 5v1 ww ******…

A: We need to write nodal equation for node 1

Q: Problem 20. The current I flowing in a resistor R is measured by a 0-10A ammeter which gives an…

A: Given data, Current I=6.25 A Voltage V=36.5 V Limit of error=2 %

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: Given data, Change in Zener current △I=10 mA=0.01 A. Change in Zener voltage △V=0.05 V.

Q: WA (↑ 2 5 lov 15 + VX- 10 SOV

Q: ? The unit of the electric field intensity is V/m O V/O VO V/Nm O

A: Given that electric field intensity

Q: 2. If I is equal to 2A, find l en fanden. 202 422 $82 M to 1652

Q: Q- A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulated with two modulating…

A: We need to find out the total bandwidth for given signal .

Q: An important difference between the open- and closed-loop control systems is that the Question 9…

Q: analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz. The…

A: We need to find out number of bits per sample , first we will find out the number of level then we…

Q: A capacitor of 2 mF has a voltage of 525cos(201). The energy stored in it at t = 850 ms is: a. 36.22…

A: Given data: C=2 mFV=524 cos20tt=850 ms

Q: Perform the following computation (3.7 -1.2j) +2e/4 and show the result in rectangular form. Script…

A: Given, Computation is n3= (3.7-1.2j)+2ejπ/4 Answer in rectangular form using MATLAB?

Q: Hand calculate the phasor voltage for VR and Vc1 using the 50 source resistance. Compare the hand…

Q: 1. Design a clamper to perform the function indicated. Determine the proper value of VDC Calculate…

A: This is a problem of analysis of diode. The detailed explanation is given in the next step.

Q: 6. Determine Vo using mesh analysis. 30V 24V(± 182 M Il 922² + +- 14 1022 12 122 2052 M 13 +48V

A: According to kvl the sum of voltages in a closed it mesh is equal to zero

Q: For the s-domain circuit in figure 1, (a) Compute the admittance Y(s) = I₁(s)/V₁(s). (b) Compute the…

Q: ow is used to measure an Q4.) A Maxwell's capacitance bridge shown in figure unknown inductance in…

Q: Given the discrete signal below. Determine the signal x(2n-4 1+ −3 ≤ n ≤ −1 1. 0<n<3 elsewhere 11 3…

A: We need to find out the shifted and scaled version of input sequence .

Q: SV (+ un R₁= 10K B = hfe = 50 R3-30KL un VBE = 0.6V b)Find Vce R₂=2012 Rs=6002 VCE V₁ R6 =1001…

Q: Prove the simultaneous relationship mathematically between the steps of the solution in detail:…

A: We need to prove the given relationship for electron and hole concentration .

Q: 3. Determine and sketch Vout for one complete cycle. 15 V -15 V 15 V 0 O -15 V Vi Vm TEN 플 Vm 플 T T…

A: Given that: The circuit is shown below. Determine and sketch the Vout for one complete cycle of…

Q: IV. SOURCE TRANSFORMATION 7. Use source transformation to reduce the circuit to a voltage source in…

Q: 1. For the motor load, torque -speed curve shown below, solve the following questions. R 2. T (N-m)…

Q: Find the Thevenin's equivalent circuit for the network shown in figure 13 at the right of the…

A: Solution !! Let the terminal a-b be open circuited. This leads to I₁ = 0 and the depending voltage…

Q: Computed (Show complete solutions.) 1. Using the value of the DC power supply as the theoretical…

A: Given DC Power Supply = 15 V R1 = 10 ohms R2 = 50 ohms R3 = 75 ohms

Q: Decimal equivalent of Octal number (764), is, O 498 500 496 502

A: Given: The octal number is 7648.

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

Q: Classification of Signals By inspecting plots (a) and (b) in the following Figure. classify the CT…

A: Given: By inspecting plots (a) and (b) in the following Figure: To find: Classify the CT waveforms…

Q: At time t = 0, a sinusoidal voltage 10 sin ωt is applied to an L−R series circuit. Determine an…

Q: 2. Using source transformation, find ix. 100V (+ 52 M 105 M 12A dix 85 M 452 (64V

Q: n = p = n₁ = √N₁N₁ exp(- Ec N₂ 2KT

A: We need to prove the given electron and hole concentration equation for semiconductor .we will use…

Q: The work done by an external source in moving a unit positive charge from one ?,point to another in…

A: Given The work done by an external source in moving a unit positive charge from one point to…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

A 60-Hz induction motor runs at 860 r/min at full load. Determine
a. the synchronous speed,
b. the frequency of the rotor currents
Note: Number of poles are 8.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Would a positive-rotating harmonic or a negative-rotating harmonic be more harmful to an induction motor? Explain your answer.
A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is the horsepower output of the motor?
A three phase induction motor with supply frequency of 60 Hz, 8 poles. If the slip is 2.5 % at a certain load, determine (a) the synchronous speed, (b) the speed of the rotor (c) the frequency of the induced e.m.f in he rotor and (d) speed of the induction motor if the slip changes to 6 %
The rotor resistance and standstill reactance of a 3-phase induction motor are respectively 0.015 ohmsand 0.09 ohms / phase. At normal voltage, the full-load torque at the full-load speed. b.) Calculate thepower factor.
A three-phase induction motor is supplied with power from a 60-Hz source. At full load the motor speedis 1728 rpm, and at no load the speed is nearly 1800 rpm. At full-load conditions, determine thefollowing: 1. speed of rotor field wih respect to the rotor 2. speed of rotor field with respect to the stator 3. speed of rotor field with respect to the stator field.
This question refers to a three-phase induction motor. which statement are false (A) The slip speed is the synchronous speed minus the rotor speed. (B) As the rotor speed is loaded, the slip decreases. (C) The frequency of induced rotor EMF's increases with load on the rotor (D) The toque on the rotor is due to the interaction of magnetic fields.
A 3 phase induction motor is wound for 6 poles and is supplied fromn 50-Hz system. Calculate 1) the synchronous speed 2) the rotor speed, when slip is 2% and 3) the frequency of the rotor currents at standstill.
Q2 Complete the answer : The rotor reactance of the three phase induction motor is varies with ................... of the rotor current.
A three-phase induction motor used for a commercial application in Oman runs at 586 rpm at no load and at 540 rpm at full load. a) How many poles do this motor have? b) What is the percentage slip at full load? c) The frequency of the rotor currents when slip is 7 % d) The frequency of the rotor currents at standstill.
Q)A 3phase induction motor is wound for 6 poles and is supplied fromn 50-Hz system. Calculate 1. the synchronous speed 2. the rotor speed, when slip is 2% and 3. the frequency of the rotor currents at standstill.
A four-pair of pole, 50-Hz squirrel-cage induction motor runs on load at a shaft speed of 720 rpm. Calculate the frequency (hertz) of induced current in the rotor.
A 6-pole, 50-Hz squirrel-cage induction motor runs on the load at a shaft speed of970 rpm. Calculate a) the percentage slip and b) the frequency of the inducedcurrent in the rotor.