In the Internet of Things, which of the following is responsible for translating an electrical signal into a physical output? Solar Panel a. Photo diode b. Actuator c. Sensor Solar Panel a. Light-Emitting Diode b. Actuator c. Sensor a. Photo diode

Q: Example 12.36. A capacitor of capacitance 10 µF has a loss angle of 10° at 50 Hz. Find (i) power…

A:

Q: An electric heater consumes 3.6 MJ when connected to a 250V supply for 40 minutes. Find the power…

A: Energy consumed by the electric heater = 3.6 MJ = 3.6×106 J Voltage V = 250V Time = 40 minutes =…

Q: 5. Determine the total resistance if each R is 30. O RT M -W

A:

Q: A coil takes a current of 2A from a 12V d.c. supply. When connected to a 240V, 50 Hz supply the…

A:

Q: B// Convert the non-standard SOP function (S = ab + ac + bc) to standard form.

A: We need to write standard SOP form for logic function . We will expand the given function

Q: An example of an invariant feature of a generalized motor program (GMP) is the overall speed…

A: Generalized Motor Program:- The basis for producing movement sequences within a class of movements…

Q: Computed (Show complete solutions.) 1. Using the value of the DC power supply as the theoretical…

A: Given  DC Power Supply(Vs) = 20 V R1 = 10 ohms R2 = 25 ohms R3 = 125 ohms All the resistors are…

Q: Logic gate NAND used mainly for construction of flip-flop type: a. (S-R) Type b. (J-K) Type c. D -…

A:

Q: For the op-amp shown in the following figure, if R1 = 100 2 and Rf = 1 k2, the overall voltage gain…

A: We need to find out the gain for given non inverting amplifier .

Q: 5. What is the total capacitance of a circuit with three capacitors connected in series with the…

A:

Q: 3. Determine l₁ and l₂ using current division. 20A (1 and then for these 1003 200

A: In this question,  We need to determine the current I1  and I2  using the current division method.…

Q: Calculate the Resistance, if the RTD temperature 3.1 °C/ohm is 2559.1 °C and Sensitivity is O a.…

A: Given: In a RTD the temperature is, T=2559.1°C. And sensitivity is S=3.1°C/ohm.

Q: In the Internet of Things, which of the following is responsible for translating an electrical…

A: Electrical quantity: There are many electrical and electronics device which works when an electrical…

Q: RF carrier 10 kV at 1 MHz is a amplitude modulated and modulation index is 0.6. peak cvoltage of the…

A:

Q: Determine the power dissipated by the element of an electric fire of resistance 20 ohm when a…

A: We need to find out the power and energy and cost of electricity for given problem .

Q: 1. Design a clamper to perform the function indicated. Determine the proper value of VDC Calculate…

A: This is a problem of analysis of diode. The detailed explanation is given in the next step.

Q: iii) Simplify the expression sin it t-1 8(t-1/2)

A: In this question we need to simplify the given expression .

Q: 15 V -15 V 15 V 0 O -15 V 플 Vm IN Vm TEIN 플 T T (a) + Vin (b) 3 V R1 Si + ideal diode Vout 5 V R +

A: Here the properties of diodes have been discussed to solve it.

Q: Obtain the Fourier transform of the "switched-on" exponential function shown in Fig f(t) 1 e-ot

A:

Q: A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 resistor…

A: Inductance of coil L = 318.3 mH Resistance R = 200 Ω Voltage V = 240 V Frequency f = 50 Hz

Q: Q 마마마 00 R R R QK OK . Clock

A: Given: A circuit of 5 bit asynchronous serial counter. To do: modulo of the circuit.   Note: *The…

Q: Attenuation, distortion, and noise contribute to transmission impairment. What is the solution, or…

A: Attenuation Attenuation is the broad term for any reduction in a signal's intensity. Any signal,…

Q: R₁ = 52 દે 1₁ род ↑ Vab Va R₂= гол 4 A

A:

Q: 1. WHAT TYPE OF CIRCUIT SHOWN ? 2. WHAT WILL BE THE FREQUENCY AT C IF THE CLOCK IS 320 HZ? 3.…

A: Answer:- 1) Since external clock pulse has been applied to the only one flip flop(right most flip…

Q: 4. Determine / in the given circuit. SV 3.2 M 75 8V

A: Given data, Circuit diagram is given as,

Q: The angle between vector A (2i+3j+k) and ? vector B (i-2j+2k) is 1100 1000 100 2100

A:

Q: 1. Determine the total resistance using delta to wye transformation if all resistors have a value of…

A: Given,

Q: 1. For the motor load, torque -speed curve shown below, solve the following questions. R 2. T (N-m)…

A:

Q: 7.it is an Level triggered digital circuit whose basic function is memory and is capable of storing…

A:

Q: Which of the following does the journeyman electrician exam not cover? A. Fuses B. Motors C.…

A: Journeyman Electrician:- A journeyman is a trained and experienced electrician who can work on his…

Q: 3. Determine and sketch Vout for one complete cycle. 15 V 0 -15 V EN 15 V Vm 我 0 T -15 V HIN T (a)…

A:

Q: 1. Sketch the unit step response of the system shown below: + VIE; = 1V + Determine the following:…

A:

Q: 2. Find 1₁, 12, 13, and 14. 6A 4₁ 20 (2 10 (2 3A 4052 4022 14 2A

A: Given,

Q: Prove the simultaneous relationship mathematically between the steps of the solution in detail:…

A: We need to prove the given relationship for electron and hole concentration . We will use mass…

Q: A single phase 11 kV line with a length of 15 km is to transmit 500 kVA. The inductive reactance of…

A:

Q: On full load a 300V series motor takes 90A and runs at 900 rpm, the armature resistance is 0.10 and…

A:

Q: frequency of 1.5 kHz the open circuit impedance of a length of transmission line is 800∠−50◦ and the…

A: We need to find out characteristics impedance for given transmission line for given open circuit and…

Q: Electrical equipment in an office takes a current of 13A from a 240V supply. Estimate the cost per…

A: Current I = 13 A Voltage V = 240 V Time = 30 hours Cost = 13.56p

Q: A 200/415 V, 10 KVA, 50Hz single phase transformer has a copper loss of 135 W at full load, unity…

A: Given, A 200/415 V single phase transformer has, Rated apparent power, S=10 kVA Frequency, f=50 Hz.…

Q: 4. Acar lot uses incandescent lamps to supply outside lighting during the night. There are three…

A:

Q: 30 V (1) Find the relevant physical INITIAL CONDITIONS for the circuit shown (2) Find the…

A:

Q: IL 300 mH 101A + 100 Q 60 Ω ww TA 1. Determine the Thevenin equivalent circuit seen by the inductor

A:

Q: contains three 60-watt lamps. The light fixture presently installed over the mirror contains four…

A: A homeowner has asked to install a lighted mirror in a bathroom. The mirror contains eight 40-watt…

Q: An operational amplifier has an open-loop transfer function of 200,000 and a feedback path with a…

A:

Q: Convert (3, pi/3, -4) from cylindrical ? coordinate to Cartesian coordinate (4-,2√,3)0…

A: We need to convert given cylindrical coordinate point to Cartesian point .

Q: In AM modulation, if the modulating signal amplitude is of 3.08V and carrier amplitude is of 11.54V,…

A: Given: In AM modulation, Amplitude of modulating signal, Vm=3.08 V. Amplitude of carrier signal,…

Q: An intrinsic germanium has a resistivity of 0.4711 m at room temperature. Find the intrinsic carrier…

A: Given: Resistivity, ρ=0.4711μh=0.19 m2V-sμe=0.39 m2V-s

Q: Write 8086 Assembly language program to find GP series. The limit of the series is stored at 500,…

A: Solution !!

Q: 1. Find the values of I1, I2, V₁ and V₂. 12/0° V + 3 Ω + V₁ 1:4 Ideal + W 4Ω V₂ -j10 Ω 24/0° V +

A:

Q: 4. Determine the node voltages, V₁ and V₂, using nodal analysis. 1 lo A 6A 102 M 482 2 $ 24₁2 (1)…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.