A (650 ohm) resistor, (6 μF) capacitor, and (3 mH) inductor are all in a series connected to a 10V power source. If the power source is using a frequency two times larger then the resonant frequency, what would be the power dissipated by the resistor?

A (650 ohm) resistor, (6 μF) capacitor, and (3 mH) inductor are all in a series connected to a 10V power source. If the power source is using a frequency two times larger then the resonant frequency, what would be the power dissipated by the resistor?

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 34RQ: Which of the following is the capacitance of an 88-microfarad and a 108-microfarad starting...

See similar textbooks

Related questions

Q: Find the phase angle of the given circuit, if V = 70V, 50HZ, R = 1000, X = 4750 and C = 360µF R V…

Q: A quartz crystal oscillator has an equivalent inductance L = 10 mH and series and parallel…

Q: At what frequency is the current be 4A with lagging power factor?

A: In series ac circuit, if the inductive reactance is more than the capacitive reactance, then the…

Q: A capacitor of 30µF capacitance is in series with a coil across an 8000 cycles supply. What is the…

A: Need to find L for resonance

Q: In a series resonant circuit, a resistor of resistance 500 ohm, an inductor of inductance 4.5 henry…

A: For a series resonant circuit, the value of the resonance frequency (f0) can be expressed as

Q: For the given circuit for a 20 Vpeak sinusoidal input vi, what is the value of the clipping line?…

A: The solution is given below

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to…

Q: What will be the resonant frequency of a tank circuit, when the capacitance and Inductance of the…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: An inductor is attached to an AC voltage source. Which change will result in a halving of the…

A: Write the current in the circuit, it=vtZhere,Z= 2πfL A). if voltage will half and frequency will be…

Q: Calculate the phase angle of the inductor current in the AC circuit given below. 150 250

A: The solution ca be achieved as follows.

Q: What will be the total impedance of a series resonant circuit if the resistance is of 1.5 ohms, the…

A: The total impedance of a series resonant circuit can be expressed as Z=R+jωL-1ωC Ω--->(1) where R…

Q: crystal has the following parameter L = 3 H, C= 0.05pF and the mounting capacitance is 1pF find…

A: In this question , we will find series and parallel resonating frequency for quartz oscillator...

Q: The two - sided exponential voltage f(t) = Be-Ale| volt is developed %3D across a 1 2 resistor. 1-…

A: The voltage is f(t)=58e-29|t| and determine the power, Power=V2R=58e-29|t|1=58e-29|t| W Consider…

Q: A series-tuned antenna circuit consists of a variable capacitor (40 pF to 360 pF) and a 240- u H…

A: Given values are - C1=40pFC2=360pFL=240μH

Q: t, what will be the capacitance of the capacitor when the circuit is in resonance?

Q: Given R = 20, C = 6µF, and the resonant frequency of the circuit is 60HZ, then L = H Note: Make sure…

Q: A 150 ohms resistor, 20 uF capacitor, and 300 mH inductor are in a series circuit, connected to an…

Q: 3. What must be the relationship between the values of RL and RC if the networ shown in Fig. 2 is to…

A: The inductor and capacitor are the energy storing elements. They exchange energy among themselves in…

Q: A 0.796-mH inductor produces an inductive reactance of 50 ohms at 10 kHz. What value of capacitance…

Q: 5. A 1500-pF capacitor is used in a tuned circuit with an inductor having a resistance of 12 2. What…

Q: What is the voltage applied across the resonant circuit if the ac voltage across resistance R,…

A: Given data, Voltage across resistor VR=10 V Voltage across inductor VL=20 V Voltage across capacitor…

Q: An inductor produces an inductive resistance of 50 Ω at 10 kHz. What value of capacitance will be…

Q: A circuit resonates at 750 Hz with a resistance of 100 ohms and 12 microfarad. Determine the…

A: Given:-f=750HzR=100ohmC=12μf

Q: Q4) Figure 4 below shows a series circuit for an electronic device. In order to implement the…

A: We need to find out the inductance and capacitance for the given circuit

Q: What will be the resonant frequency of a circuit with capacitance of 5 mF and inductance of 3 mH?

A: In electrical circuits consisting of active and passive elements, resonance represents a particular…

Q: 2. How much is Xµ ( in polar form ) of a 60-mH inductance at 40 KHz? Answer : XL =

A: Given, L = 60 mHL = 60 × 10-3 Hf = 40 KHz = 40 × 103 Hz In this problem, we need to find the…

Q: V, 1Η ΤΩ ww ΤΩ ΤΗ

Q: A series circuit contains a 20-ohm resistor and a capacitor with a value of 75uF. If the circuit has…

A: Given: A series RC circuit R=20 ΩC=75 μFf=60 Hz

Q: 1. The following data are given for a three – branch parallel circuit: V = 12 V , R = 82 kN, L = 15…

A: Note :- Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: 1. The following data are given for a three – branch parallel circuit: V = 12 V , R = 82 kN, L = 15…

Q: given the following points: A(3,-2,0) B (4,5,2) C (-3,2,1) Determine RAB ⋅ RAC

Q: C= 63 pF/m. Detennine the propagation constant, phase velocity, and

Q: What is the inductive reactance at 13 kHz of a 9 mH inductor?

A: The solution can be achieved as follows.

Q: A circuit has a resistance of 20 Ω, an inductance of 0.3 henry, a capacitance of 20 µF and the…

A: As connection of elements are not given. Therefore I solved it by assuming they are connected in…

Q: If the value of the inductance in a resonant circuit is quadrupled, what happensto the resonant…

A: In this question we need to find a resonant frequency when the inductance value is quadrupled.

Q: What is the power of the signal whose frequency spectrum is given in the figure at the 75Ω resistor…

A: Power is integration of power spectral density divided by resistance .

Q: To scan the main beam of an array antenna we apply:- * a linear phase to the elements change of…

A: to scan the main beam of an array antenna we apply ?

Q: 1002 2 sin O (27ft-300) v

A: We need to find out output voltage for given circuit

Q: 15. A series RLC circuit has elements R = 150 ohms, L = 18 mH and C= 2.22 microfarads. What is the…

Q: Find the Q of a circuit when the resonant frequency is 4.468 MHz, the inductance is 47 micro henrys…

Q: Q. For the circuit shown, calculate the upper critical frequency due to the input and output…

A: VB=VCC×R2R1+R2VB=20×4.7 kΩ33 kΩ+4.7 kΩVB=20×4.7 kΩ37.7 kΩVB=2.493 V…

Q: 25: Plot the frequency spectrum of the points (a, b, c, and d), which are shown in the following…

Q: Three-phase bridge, RLC load VD, VD, VD, 本本本 b) 本本本 of VD,VD,VD, a) Explain each of the following…

A: For the purpose of rectification of AC supply to DC supply, rectifiers will be used. The rectifiers…

Q: To tune a parallel resonant circuit to the higher frequency, what change must be made in the…

A: For a parallel resonant circuit, the resonant frequency is expressed as fp=12πLC Hz--->(1) Since…

Q: A series circuit consisting of a 16 – ohm resistor, a 0.1275-henry inductor, and a variable…

A: A series circuit 16 – ohm resistor, a 0.1275-henry inductor, and a variable capacitor is connected…

Q: For the electric circuit shown in figure below, find the value of the total power at resonance? *…

A: For the circuit to be in resonance at the given supply frequency the value of the variable…

Q: In order to tune a parallel resonance circuit to a lower frequency, the capacitance must be…

A: In case of Parallel resonance the resonance frequency given by: fo=12πLC Hz From the formula of…

Q: 1H 10mF 1mF 0.5H H ell + 1050° 304 XH 31, I, ll

Q: Given V 20 sin(@t + 60°) and V, = 60 cos(ot- 10) What is the phase angle %3D between the waveforms?…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is the capacitance of an 88-microfarad and a 108-microfarad starting capacitor connected in series? 196 microfarad 96 microfarad 48 microfarad 40 microfarad
The circuit is connected to a 60-Hz line. The apparent power in the circuit is 29.985 VA, and the power factor is 62.5%. The resistor has a voltage drop of 14.993 V, the inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA29.985PF62.5%ER14.993VIRRPELILXL60VARsLLECICXC45VARsCC
A circuit comprises of two series resistors, each having a value of 10 kohms, one inductor of inductance 10 mH and one capacitor of capacitance 100 mF. If all the elements are in series, then what will be the resonant frequency of the circuit?
Calculate the value of capacitance connected in parallel with a inductance of 3 H, when the resonant frequency of the circuit is 4 rad/sec.
If the system is in resonance at 50 Hz in the given circuit, what is the voltage on the capacitor?
To tune a parallel resonant circuit to the higher frequency, what change must be made in the capacitance, provided the inductance remains constant?
A coil of resistance 25 ohm and inductance 100mH is connected in series with a capacitance of 0.12 F across a 200V , variable frequency supply . Calculate : 1) draw the sinusodial waveform for VL, VC, VR of the circuit and explain the phasor diagram and how they are produced. 2) calculate resonant frequency 3) the current at resonance 4) the Q factor
A series R–L–C circuit having an inductance of 0.40 H has an instantaneous voltage, v = 60 sin(4000t −(π/6)) volts and an instantaneous current, i =2.0 sin 4000t amperes.Determine (a) the values of the circuit resistance and capacitance and (b) the frequency at which the circuit will be resonant.
A capacitance of 50microfarad and an inductance of 0.2025 Henry are connected in series. If the resistance of the circuit is negligible find the frequency at which resonance occurs
A coil of resistance 20 Ω and inductance 0.2 mH is in parallel with a variable capacitor. If the supply is at a frequency of 1 kHz, what should be the value of capacitance that will make the circuit run at resonance?
A 20,000-cycle source is connected to a series circuit consisting of a 50-ohm resistor and a 0.266 microfarad capacitor. An impedance coil, whose resistance and inductance are 25 ohms and 0.191 mh, respectively, is then connected in series with a variable resistor, after which the combination is paralleled with R-C circuit. What value of the variable resistor will the entire circuit be in resonance?
7. Calculate the spectrum efficiency of the system if the signal power is 134.55 fW and its niose power is 1.794 fW -show your whole solution -don't use shortcut method, use the long method -box your final answer