A 75µF capacitor has a voltage drop of ve = 24 Sin (100TT t-48°) mV across it. A. Find the frequency В. What is the impedance, Z. ?
Q: Two coils of inductance ?1 = 1.16 mH, ?2 = 2 mH are connected in series. Find the total energy…
A:
Q: Using the given circuit, calculate: 1) Equivalent capacitance 2) Charge across each capacitor 3)…
A: Solve the problem
Q: Q1. For I=1,e*which is best represented by the following data t(msec)= 0 4 8 10 12 14 16 I(HA)= 5 3…
A: Here, we have given an RC circuit. We have given some tabular data where the value of currents at…
Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the…
A:
Q: In the circuit given, what is the value of the inductor such that the current is in phase with the…
A:
Q: What is the impedance of the 40 μH inductor at the given frequency of 200,000
A:
Q: 3. A 100 µF capacitor, a 4.0 H inductor and a 35 Qresistor are connected in series with an…
A:
Q: What is the impedance of the 1 μF capacitor at the given frequency of 200,000 rad/s?
A: What is the impedance of the 1 μF capacitor If frequency of 200,000 rad/s
Q: In the circuit given, what is the value of the inductor such that the current is in phase with the…
A:
Q: If the initial current of an inductor of 1 mH is null, calculate the current, the instantaneous…
A: The solution is given
Q: . Consider a device connected to an ac power supply. The current leads the voltage by 90°, with the…
A: (a) Since the current leads the voltage by 90° the given device is capacitor. (b) The angular…
Q: 70. Ideal inductors and capacitors are 90 degrees out of phase with each other. True False 71.…
A:
Q: The voltage across a 75 mH inductor is described by the equation νL = (25 V) cos(60t), where t is in…
A: Given: VL = (25 V) cos(60t) L = 75 mH SOL. a) at t = 0.1 s VL = (25 V) cos(60×0.1)VL = 24.86 V b)…
Q: Q1. For I=1,e"which is best represented by the following data t(msec)= 0 2 4 8 10 12 14 16 I(HA)= 5…
A: In this question, current I= Io e-t/ tao is given. We need to determine the source voltage, and…
Q: 18. A 40 µF capacitor in series with a coil of resistance 80 and inductance 80 mH is connected to a…
A:
Q: In a 50 hertz circuit, containing a 10 microfarad capacitor, the capacitive reactance is Select the…
A:
Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an AC power supply…
A:
Q: The inductance and capacity values used in a transmission path are 20 mH and 60 nF, respectively.…
A:
Q: A capacitor and a 30-ohm resistor are connected in series. What is the equation of the resulting…
A: The current through the capacitor can be calculated by finding the total circuit impedance and then…
Q: A 120 microfarad capacitor is connected in parallel with a coil of 78 ohm resistance and 321 mH…
A: Given data, Supply voltage V =215 V C=120 μF R=78 Ω, L=321 mH Frequency f = 60 Hz
Q: Q2. A 50 Q carbon resistor has two lead wires with inductance of 10 nH each. If the stray…
A: Impedance of inductor given byXL= jwL Impedance bof capacitor given by Xc= -j/wC
Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…
A:
Q: Find the equivalent capacitance seen at the terminals of the circuit 50 µF 60 µF Ceq 120 µF 70 μ 20…
A:
Q: 7. An ideal inductor, capacitor and resistor are connected in parallel across a 40 V a.c. supply.…
A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question for…
Q: A pure inductance of L = 120 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…
A: Ohm's law is very important to find the current, voltage, or resistance of a circuit. According to…
Q: 50 μF 60 μΕ Ca 70 μ 20 μΕ 120 μF
A:
Q: R L 10 Q ll V sine The frequency of the voltage source is 5000 rad/sec. The impedance &f the…
A: In this question, We need to determine the value of capacitance C for the unity power factor? We…
Q: A 397-Vrms, 60-Hz supply serves a load that is 10 kW (resistive), 5 kVAR (capacitive), and 15 kVAR…
A:
Q: . Acoil having an impedance of (8 + j6) Nis connected across a 200-V supply. Express the current in…
A:
Q: Ina transmission line, to reduce the inductive coupling, one should Reduce the inductance None of…
A: In a transmission line inductive coupling depends on distance between the transmission line ,…
Q: 1. A coil of 10 Q resistance and 0.1 H inductance is connected in parallel with a capacitor of…
A: In this question, Choose the correct option What is value of capacitance C We know Xc= 1/wC XL =…
Q: Q) Consider the circuit shown in Fig.1. The input to the circuit is the voltage source v(t)=7.68cos…
A: Given Input voltage and output voltage.we need to determine capacitance. Please find the below…
Q: ure inductance of L = 144 mH 118 V, 50 Hz supply. The cure ctor is given by
A:
Q: Calculate the equivalent capacitance, the equivalent charge, V1234, V67, and Q6.
A:
Q: Given that the steady-state AC circuit shown operates at a frequency of 400 rad/sec, find the…
A: To solve above problem, one should have a basic idea about the working of AC circuits. The above…
Q: A pure inductance of L = 158 mH is connected to a V = 116 V, 50 Hz supply. The %| current taken by…
A: In this question we need to find a current taken by inductor.
Q: Determine the current through a 8 microfarad capacitor given that the v(t) = 3t3 volt 5t+1
A: In this question we will find current through capacitor...
Q: A pure inductance of L = 144 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…
A:
Q: Capacitance by AC- Bridge: In AC Bridge experiment, the balance was obtained as shown. Therefore,…
A: In this answer we will find the value of Cx for the bridge balance condition as shown below.
Q: A 15 mH inductor is in series with a parallel combination of 80 ohm resistor and 20 microFarad…
A: This question belongs to circuit theory . It is based on the concept of relation between impedance…
Q: 1. Determining the inductance value of an inductor: Repeat step 1 section by connecting a 0.1H L…
A: Given data: Vst=5sin1000πt VR=1 kΩL=0.1 H
Q: 5. (Post Test 2 material) For the following circuit with v, (t) = 10 cos (1000t + 5°), determine %3D…
A: Active Power(P): The power which is deployed and absorbed by the electric circuit to do some useful…
Q: Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v,…
A: Given Voltage, V = 8V Current, l = 2mA Frequency, f = 10KHZ Resistance, R = 14K ohms Inductance.…
Q: Calculate the velocity factor of a coaxial cable used as a transmission line with the characteristic…
A:
Q: If the frequency of the supply voltage to the circuit shown below is 50 Hz, calculate the…
A:
Q: ✰ 6. A quarter piece of a transmission line is connected to a capacitive load from one port. At the…
A: We need to select correct option for given line
Q: A coil, with 100 mH of inductance and 10 Q of resistance, has been connected to an C power supply…
A:
Q: When an inductive coil is connected across a 250-V, 50-Hz supply, and the curent is found to be 10 A…
A: Impedance = voltage/ current. Power dissipated by the resistance = (current)2×resistance.
Q: A pure inductance of L = 152 mH is connected to a V = 106 V, 50 Hz supply. The current taken by the…
A: Given data : V= 106 VL=152 mH =0.152 Hf= 50 Hz
Step by step
Solved in 3 steps
- A 50ft transmission line is used for a microwave system. Aportion of the transmission line is found to have an inductanceof 0.5 mH, a capacitance of 1000 uF, 1000Ω resistance and 1uSconductance. Find the characteristic impedance of the trans lineassuming at Low frequency application.A resistor of 100 Ω, a coil of 4.50 μH, and a capacitor of 220 pF are in parallel. What is the admittance vector at 6.50 MHz? Provide illustration of the circuit.In the series circuit of Fig, the source has voltage amplitude 20.0 V and angular frequency 5.40 x 103 rad/s, the inductance is 6.50 mH, the capacitance is 0.600 µF, and the impedance is 474 Ω. Find (a) the resistance, (b) the current amplitude, (c) the resistor voltage amplitude, (d) the inductor voltage amplitude, and (e) the capacitor voltage amplitude
- The capacitor of external defibrillator must be loaded at 1500V, in order to generate a two-phase wave of 150 J.Considering a transthoracic impedance is 80ohms and a capacitance of 30 000 uF. 3- What is the energy of the capacitor?4- What is the internal impedance of the defibrillator in the previous cases?The voltage across the terminals of the 5μF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the capacitive reactance; (b) the impedance of the capacitor; (c) the phasor current I; and (d) the steady-state expression for i (t). 5 μF + v iFind the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v, the current is 2mA, resistance is 12 kΩ , inductance 27 mH and capacitance 0.2 µf
- 1.3 A coaxial cylindrical capacitor is to be designed with an effective length of 10 cm. The capacitor is expected to have a capacitance of 100 pF and to operate at 11 kV, 1000 kHz. Determine the required thickness if the required insulating material is Polytetrafluoroethylene (P.T.F.E.), &r= 2.0, Eb = 250 kV/cm. Allow a factor of safety of 4 and take to = 8.85x10-1² F/m.Differential Equation: y′′+6y′+58y=0 describes a series inductor-capacitor-resistor circuit in electrical engineering.The voltage across the capacitor is y (volts). The independent variable is t(seconds). Boundary conditions at t=0 are: y = 6 volts and y′=8 volts/sec . Determine the capacitor voltage at t=0.40seconds . ans:1Given the following circuit. Determine the Z parameters. * 8Q 10Q “
- If the roots of the characteristic equation are -3,0 then the system is _________________________. Marginally stable Conditionally stable Stable UnstableA 100 Ω resistor in parallel with a 5 pF capacitor terminates a 100 Ω transmission line. Calculate the SWR on the line at 2 GHz.The inductance and capacity values used in a transmission path are 20 mH and 60 nF, respectively. Accordingly, find the significant impedance value that will eliminate the delay time per sector of this transmission path and the reflections at its output.