90 ampere current flows into two parallel resistors having resistances of 12 and 24 ohms. Determine the current passing through the 24 ohm resistor

Q: For pnp transistor in the active

A:

Q: The following system is a simple dashpot spring system with a twist. The dashpot is also mounted on ...

A:

Q: Q1)Design moving coil ammeter as a voltmeter to read 15 V (RMS) alternating voltage. If the internal...

A: As per guidelines given to us, we can provide the solution of one question in multiple type of quest...

Q: 470 k2 5 V 1 MQ 100 k2 (b) Charge equivalent circuit (c) Discharge equivalent circuit (a) Circuit. C...

A:

Q: 5. What is the purpose of a starter?

A: A glow switch starter, sometimes known as a glowbottle starter, is a form of fluorescent light prehe...

Q: nominal value at steady state operation is due to: (a) The shortage of reactive power generated. (b)...

A: A bus in power system is the node present across a single line diagram at every bus the main electri...

Q: Question 7 10s? +4 25? +1 The transfer function of a system is given by H(s) = Find the steady state...

A: We need to find out steady state Value of given system.

Q: 4) For the below signal determined the following: 1) The mathematical expression. 2) The suitable sa...

A:

Q: If we want to make a coil consisting of an aluminum wire of length (100 m), so that it carries a cur...

A:

Q: 3. Use the resistor color code chart to determine the value and tolerance of the resistor below. II

A: 1 COLOUR DIGIT MULTIPLIER TOLERANCE Black 0 1   Brown 1 10 ± 1% Red 2 100 ± 2% Orange 3 1...

Q: Suppose a resistor has a voltage drop of 0.000034 volts across it.  How many µ (micro) volts is drop...

A:

Q: If we want to make a coil consisting of an aluminum wire of length (100 m), so that it carries a cur...

A: Given: A coil consisting of aluminum wire having, Length, L = 100 m Carries a current, I  = 5 A Pote...

Q: Problem #2: An 8-pole simplex wave connected dc generator has 1000 armature conductors and fluX per ...

A: Given: A dc generator with, Number of pole, P = 8 Simplex wave connected, so number of parallel path...

Q: Qz findd L'of these fanctions 55+1 0-25 +1-8 2- S2-25 5 324

A:

Q: What is the voltage across the capacitor when the source voltage is 100V and the Q factor is 10?

A: Given, Source voltage, Vs = 100 V Quality factor, Q = 10

Q: Get the positive and negative half cycle of both questions please,

A: According to the question, we need to plot the outputs for the given circuit. Note: Considering the ...

Q: VrtVLtvet 0.06H 0.2mF t. f = 60 V - 310 Find a: It and 2T 6. VR, VL; Va C. PR, PL, Pa

A:

Q: Solve and please show an eligible solution: 1. Refer to Figure 1. A Y-connected source supplies 3 ba...

A: As per the guidelines gives to us, we can only provide the answer of first three subpart in multipar...

Q: QUESTION 3 A 1KVA ideal transformer supplied with 120V RMS and connected to a 1kQ load draws 100mA R...

A: The solution is given below 

Q: * final Lod there fanctions 서- 3- (S+€) (s-V3)

A:

Q: The voltage of a 100 kw, 250 volts shunt generator rises to 260 volts when the load is removed. What...

A:

Q: Who has the responsibility for Code interpretations? When are rules in the PEC mandatory and when...

A: 1. Who has the responsibility for Code interpretations? Answer :  As per NEC, section 90.4 and secti...

Q: 5. For the given circuit below, provide the following unknowns: RS RI = 1.2k2 R2 = 2.2k2 R3 R3 = 3.3...

A:

Q: Some reasons for adopting per unit system in tackling power system problems are The surge impedance ...

A: Reasons for adopting per unit system in power system are: Regardless of their absolute size, equiva...

Q: Table 4.6. 100 ohms RI 1k ohm $470 ohms 330 oh Figure 4.7 Table 4.2

A:

Q: 1. Refer to Figure 1. A Y-connected source supplies 3 balanced 3-phase loads. The source has voltage...

A: As per the guidelines given to us, we can provide the solution of three parts in multipart questions...

Q: A transformer is built with 200 primary turns and 50 secondary turns. What's the transformer's turns...

A: Given a transformer with, Primary turns, N1=200 Secondary turns, N2=50

Q: Q2. Number of information signals are multiplexed with 20KHZ sampling frequency, and f(t) max = If (...

A: According to the question,   Number of information signals are multiplexed with 20KHZ sampling frequ...

Q: Using thevenin theorem, determine the charge and discharge equivalent

A:

Q: 10 kW induction motor initially operating on a power factor of 0.5 lagging. If power factor is impro...

A: Given active power rating for induction motor. Active power, P=10 kW Initial power factor, cosφ1=0.5...

Q: ) Write (but do not solve) the mesh current and node voltage equations by inspection 3 2s (directly)...

A: In this question,  Write the mesh and nodal analysis equation in the circuit.  Here 4 nodes and 5 lo...

Q: 7. The rotor resistances per phase of a 4-pole, 50-Hz, 3-phase induction motor are 0.024 ohm and 0.1...

A: The solution is given below 

Q: 1) Find out the impulse, step, and parabolic response of the 1 order control system of transfer func...

A:

Q: : What is the effect of increasing the value gain (K) on the system using the proportional controlle...

A: Actually proportional gain K is fixed value of controllers but in some proportional controllers K is...

Q: What are the colors of the band of a 10%, 5.6 ohm resistor?

A:

Q: Draw a three-bulb circuit in which one of the bulbs goes out when the switch is closed, and two of t...

A:

Q: find the total voltage (VT) in the network * VI V2 V3 lov 5V 5V +1, VT O 20 O - 20 O 10

A:

Q: A spring-mass-damper system has transfer function as follow: 1 TF (3s²+4s+k) Spring constant is foun...

A:

Q: A certain diff-amp has a differential voltage gain of 2000 and a common-mode gain of 0.2. Determine ...

A: Given a differential amplifier has, Differential voltage gain, Ad=2000 Common-mode gain, Ac=0.2  

Q: The no-load speed of a compound motor us 1650 rpm. How fast will it operate when it delivers rated h...

A: The solution is given below

Q: In cross circuits, how do i know the resistances are in parallel or in series connection?

A: The solution is given below 

Q: The contract load of a medium scale Industry (MSI) at 11 kV, 50 Hz is 0.8 MW, but the maximum demand...

A:

Q: Figure Q2 shows a BJT amplifier circuit. Assume VA = 150 V, B = 130, VT =25 mVand VBE = 0.64 V. The ...

A: According to the question, for the given circuit as shown below (a) We need to sketch a small-signa...

Q: A 230 v, 10 hp d.c. shunt motor delivers power to a load at 1200 r/min. the armature current drawn b...

A: Given data, Terminal voltage V = 230 V Speed N = 1200 rpm. Armature current drawn by motor Ia=200 A ...

Q: 11:01 1 1. Part B 1. Demorgan's (B + C) 3. SOP truth table B.C AB CAB BC BC X 0000 0 1 100 0 11 1 10...

A: The solution is given below

Q: For the circuit given below, assume Vcc= 15V, Rc= 18 KΩ, RE= 8.6 KΩ, RB1= 160 KΩ, RB2= 100 KΩ, β=100...

A:

Q: 1- Consider the circuit shown in Fig. 1. Given that R;=1.5kN, R;=1.2kN, R3=1kN and R1=1.8kN, find th...

A:

Q: Application of Microwave in Communication Systems and Integrațed Microwave Circuits?

A: Microwave : The electromagnetic radiation which has the wavelength ranges from 1 mm to 30 cm are kno...

Q: 2) For the feedback amplifier circuit shown below, assuming the internal resistor in each MOSFETS is...

A:

Q: 1. Refer to Figure 1. A Y-connected source supplies balanced 3-phase loads. The source has voltag Va...

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.