Q2. Number of information signals are multiplexed with 20KHZ sampling frequency, and f(t) max = If (t)Imin = 6 v. and entered to pulse modulator: %3D i. If PDM used and part of PDM-TDM spectrum is shown below with maximum and minimum guard bands are 10us, 4.5 us, respectively Find KPDM: If the modulator is PAM Sketch the 3rd time frame where; K PAM = 1, (assume t = Tg). If the modulator is PPM, how can generate the PPM signals from PDM spectrum, with pulse width is 2us. ii. 111.

Q2. Number of information signals are multiplexed with 20KHZ sampling frequency, and f(t) max = If (t)Imin = 6 v. and entered to pulse modulator: %3D i. If PDM used and part of PDM-TDM spectrum is shown below with maximum and minimum guard bands are 10us, 4.5 us, respectively Find KPDM: If the modulator is PAM Sketch the 3rd time frame where; K PAM = 1, (assume t = Tg). If the modulator is PPM, how can generate the PPM signals from PDM spectrum, with pulse width is 2us. ii. 111.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An analog signal of maximum frequency component of 10 kHz is applied at the input of a PCM system with an uniform quantizer having 32 levels. What will be the Transmission bandwidth of the PCM system? Please answer only if you are confident.
There exist several methods to perform AM demodulation, consider a requirement where we intend to design an AM receiver which is characterized by less distortion and high SNR.Identify which type of AM demodulation scheme is mentioned in the above statement and explain one such demodulation with appropriate sketch.Compare and contrast different AM modulation and demodulation schemes in various aspectsExplore one interesting application area involving Amplitude Modulation with explanation and neat sketch.
(a) Write the expression for the output voltage for the Jones mixer as shown for IBB =2 mA, Vm= 10 mV, RC = 5 kΩ, 2R1 = 1 kΩ, fc = 90 MHz, and fm = 10 MHz. Include the terms for n = 1 and 2. (b) What is the largest value of V1 that satsifies our small-signal assumption?
Q4. a) Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher than the Nyquist rate. The maximum quantization error of the sample amplitude is 0.5% of the peak amplitude? . Assume binary encoding. Calculate the minimum bandwidth ? of the channel to transmit the encoded binary signal.
For a user signal with maximum frequency 20KHz: What must be the proportionality constant Kf and the modulation index β for the maximum FM modulated signal bandwidth to be 200 KHz, if the maximum signal amplitude is 2 volts? What is your standard deviation in Hz? Calculate modulated signal strength
Digital Communication . Consider a BPSK system with equally likely waveforms s1(t) = cos(ω0t) ands2(t) = − cos(ω0t). Assume that the received Eb/N0=9.6 dB, giving rise toa bit error probability of 10-5, when the synchronization is perfect. Considerthat carrier recovery with the PLL suffers some fixed error φ associated withthe phase estimate, so that the reference signals are expressed as cos(ω0t + φ) and − cos(ω0t + φ). 1. How badly does the bit-error probability degrade when φ = 25 degrees? 2. How large a phase error would cause the bit-error probability to degrade to 10-3?
Design a 3rd order HPF without any kind of attenuation of ur original signal?
A PCM binary stream is produced using an 8,000 samples/s rate and 7-bit encoding. 32 synchronization bits are inserted into the binary stream for every 224 data bits. The resulting binary stream is then transmitted in two-level pulses over a baseband channel, with r = 0.2. This is followed by digital band-pass modulation before the transmission. a. What is the bandwidth of the baseband transmission? b. Determine the bandwidth of the pass-band transmission under the following digital modulation schemes: c. BPSK. d. QPSK. e. BASK.
A quaternary PCM system worksfor sinusoidal modulation signa of40 dB, the desired SNR if 50 dB,find the new levels of quantizationthat must be added to make thesystem works under targeted SNRfor sinusoidal modulation signal.and the bits added
4/ For a QPSK modulator with a 10 Mbps transmission rate and a carrier frequency 70 kHz. Consider a high cosine pulse with r = 0.5. (1 A/ Determine the minimum transmission bandwidth B/ Determine the wide width of a BPSK modulator with the same data transmission rate and the same type of pulse.
12-21. For a 16-QAM modulator with input bit rate fb = 10 Mbps and carrier frequency fc = 60 MHz, calculate the minimum bilateral Nyquist rate and baud rate. Tracea schematic of the output spectrum
For the FSK modulation Develop the output equation for the modulation scheme for the 2nd discrete level, if the total number of discrete levels are 6, and the frequency of the modulated signal is given as 3.55 MHz,and power per signal is given as 35 Kilo watt