Answered: a) A battery having an emf (ɛ) of 6V…

a) A battery having an emf (ɛ) of 6V and an internal resistance (r) of 0.30 is connected to a load of 302 as shown below. What will be the readings in the ammeter and the voltmeter?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 69AP: Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r =...

See similar textbooks

Related questions

Q: A 3.0N resistor is connected to a non-ideal source with internal resistance r = 1.0N and EMF e = 16…

A: Given value--- resistance R = 3 ohm. internal resistance = 1 ohm. EMF = 16 V. Voltage drop across 3…

Q: An auto mechanic needs to determine the emf and internal resistance of an old battery. He performs…

A: The auto mechanic performs two measurments.

Q: The RC charging circuit in a camera flash unit has a voltage source of 295 V and a capacitance of…

A: The voltage source is V=295 V. The capacitance is C=126μF=126×10-6 F

Q: Why should you not connect an ammeter directly across a voltage source as shown ? (Note that script…

Q: An uncharged capacitor and a resistor are connected in seriesto a source of emf. If ε = 9.00 V, C =…

A: a)Formula to calculate time constant of the circuit

Q: Mei Lin, an electrical engineering professor sets up the circuit shown in the figure. The reading of…

Q: Consider n parallel-connected resistors each having resistance of R. Which of the following is true…

A: Given data: n resistors are connected in parallel combination Resistance of each resistor = R…

Q: What are the expected readings of the following in the figure below? (R = 5.80 N, AV = 6.50 V) A R…

A: The circuit diagram for the given problem:

Q: When switch S in the figure is open, the voltmeter V of the battery reads 3.11 V . When the switch…

A: Answer:- Given The Resistor R and the internal resistance r are connected in series when the…

Q: Consider the circuit shown in the figure below, where and E = 11.0 V. R, = 9.00 Q, R2 = 6.00 N, 10.0…

Q: Mel Lin, an engineering professor sets up the circ snown in the figure. The reading of the voltmeter…

A: According to ohms law - V=IR Reading of Voltmeter and Ammeter are - Vr=6.50 vIr=2.50 mA1 A = 1000…

Q: An uncharged capacitor and a resistor are connected in series to a source of emf. If ε = 9.00 V, C =…

Q: Question 24 Consider the following circuit. Assume that the emf of the battery is 12 V and that the…

A: 24Emf of battery E=12v so their equivalent 45Ω=0.8 Ω Req=0.8+2+2.2+124.1 Req=6Ω24.2 Reading of…

Q: For the circuit shown below, the ideal voltmeter reads 7.40 V and the ideal ammeter reads 2.90 mA.…

Q: Consider n parallel-connected resistors each having resistance of R. Which of the following is true…

A: Given Resistance of each resistors is R. Number of resistors is n. All the resistors are connected…

Q: In the circuit below, the ammeter has an internal resistance of 200.00 oh ms. The voltmeter has a…

Q: What are the expected readings of (a) the ideal ammeter and (b) the ideal voltmeter in Figure?

A: A voltmeter is used to measure voltage between two points and will be connected parallelly between…

Q: An ideal emf e = 12 V is wired into a circuit with resistors R1 = 4.0 N and R2 = 8.0 N, as %3D shown…

A: According to Ohm's law, V = I×R where, V = Voltage I = Current R = Resistance Also, equivalent…

Q: Consider the circuit shown below where the battery has an emf of & = 51 V, the resistors have the…

A: Given:- E= 51 V R1=12 ohm R2=R3=13 ohm The capacitance C= 2μFThe switch S is closed at t=0 . The…

Q: An auto mechanic needs to determine the emf and internal resistance of an old battery. He performs…

A: Emf=11.8v Current=17.7A

Q: FIGURE 6 shows a simple potentiometer. Wire PQ has length 100 cm and resistance 2.4 N. The…

Q: The circuit shows R= 1 ohm, Emf1= 12.2 V and Emf 2= 7.1 V. What is the power delivered to the 10R…

Q: An emf of 10 V is connected to a series RC circuit consisting of a resistor of 2.0 × 106 Ω and an…

Q: What are the expected readings of the following in the figure below? (R = 5.80 N, AV = 6.50 V) A R…

Q: What are the expected readings of the following in the figure below? (R = 5.50 0, AV = 6.70 V) R ΔVν…

Q: What are the expected readings of the following in the figure below? (R = 7.60 0, AV = 5.00 V) R Δν…

A: A). ideal ammeter I= 0.327MA B) ideal voltmeter V=0.5V C).ideal ammeter i =0.93Ma Ideal…

Q: You are asked to measure e.m.f of a cell. Which instrument will you use? A high resistance Voltmeter…

A: The potentiometer is used to measure the e.m.f of cell.

Q: A battery with an emf of 12.0 V has a terminal voltage of11.5 V when the current is 3.00 A. (a)…

A: a)Terminal voltage is given by

Q: Say you have two resistor with resistane R = 32 KN and R = 59 KN. What is the equivalent resistance…

Q: What are the expected readings of the following in the figure below? (R = 7.10 0, AV = 6.70 V) A AV…

Q: Why can a null measurement be more accurate than one using standard voltmeters and ammeters? What…

Q: Consider the circuit diagram given below. where V1 = 109 V and R1 = 7.50 Ω. Find the unknown emf ε…

Q: Why does the total emf of dry cells in series not equal the reading in the voltmeter?

A: The electromotive force is the measure of energy that is given to each coulomb of charge, whereas…

Q: The four resistors in the figure have an equivalent resistance of 122. The resistances are as…

A: Given Data Resistance of the resistors are R1=8.0Ω, R2=4.0Ω, R3=4.0Ω Equivalent resistance of the…

Q: What are the expected readings of the following in the figure below? (R = 5.60 N, AV = 6.30 V) R AV…

A: Given: The resistance R=5.6 Ω The voltage ∆V=6.3 volt

Q: Consider n parallel-connected resistors each having resistance of R. Which of the following is true…

Q: The electromotive force of a battery is given by E = 8 volts. A resistor wtih resistance R1 = 24 kSN…

A: NOTE- Since the question in the 2nd image is graded, we will only solve the question mentioned in…

Q: A resistor with resistance R is connected to a battery that has emf 13.0 Vand internal resistance r=…

A: Write the expression of the power consumed by the resistor, The current across the resistor which…

Q: What are the expected readings of the following in the figure below? (R = 6.70 N, Av = 5.30 V) R AV…

A: We will use KVL and KCL for the three loops and will find current through ammeter.

Q: A d.c. supply of 120V is connected to a large resistance X. A voltmeter of resistance 10kohms placed…

Q: The figure shows a circuit containing an electromotive force, a capacitor with a capacitance of C…

Q: What are the expected readings of the following in the figure below? (R = 8.00 0, AV = 5.20 V) AV…

A: Apply Kirchhoff’s voltage law in the right-most loop, and solve it as follows. -∆V+V+4.50…

Q: What is the maximum voltage that can be applied to a 186 k ohm resistor rated at 16 watts? Give your…

Question

23 a

a) A battery having an emf (ɛ) of 6V and an internal
resistance (r) of 0.30 is connected to a load of
300 as shown below. What will be the readings in
the ammeter and the voltmeter?
RLOAD
V
i) The ammeter reading will be =
А
ii) The voltmeter reading will be =
V
------I

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
Semi-truck or trucks use four large 12-V batteries. The starter systemrequires 24 V, while normal operation of the truck’s other electrical components utilizes 12 V. How could the four batteries be connected to produce 24 V? To produce 12 V? Why is 24 V better than 12 V for starting the truck’s engine (a very heavy load)?
An automobile starter motor has an equivalent resistance of 0.0500 and is supplied by a 12.0-V battery with a 0.0100- internal resistance, (a) What is thecurrent to the motor? (b) What voltage is applied to it? (c) What power is supplied to the motor? (d) Repeat these calculations for when the battery connections are corroded and add 0.0900 to the circuit. (Significant problems are caused by even small amounts of unwanted resistance in low-voltage, high-current applications.)
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
An automobile starter motor has an equivalent resistance of 0.0500 and is supplied by a 12.0-V battery with a 0.0100- internal resistance, (a) What is the current to the motor? (b) What voltage is applied to it? (c) What power is supplied to the motor? (d) Repeat these calculations for when the battery connections are corroded and add 0.0900 to the circuit. (Significant problems are caused by even small amounts of unwanted resistance in low-voltage, high-current applications.)
The EMF of the bottom battery is 9.0 V. (a) Calculate the magnitude and directionof the current in the 10 Ω resistor. (b) Find the potential difference across this resistor.(c) Find the rate of power dissipation in this resistor.
A Christmas light is made to flash via the discharge of a capacitor. The effective duration of the flash is 0.21 s (which you can assume is the time constant of the capacitor), during which it produces an average 35 mW from an average voltage of 2.85 V. What is the resistance, in ohms, of the light?
An ideal battery has an emf of 150V on the left side and a second emf on the right side of 50V. If R1 is 3Ω and R2 is 2Ω what is the current in the circuit and which direction does it go?
Your cell phone typically consumes about 400 mW of power when you text a friend. If the phone is operated using a lithium-ion battery with a voltage of 3.6 V, what is the current flowing through the cell-phone circuitry under these circumstances?
The label on a battery-powered radio recommends the use of a rechargeable nickel-cadmium cell (nicads), although it has a 1.25-V emf, whereas an alkaline cell has a 1.58-V emf. The radio has a 3.20 Ω resistance. (a) Draw a circuit diagram of the radio and its battery. Now, calculate the power delivered to the radio (b) when using a nicad cells, each having an internal resistance of 0.0400 Ω , and (c) when using an alkaline cell, having an internal resistance of 0.200 Ω . (d) Does this difference seem significant, considering that the radio’s effective resistance is lowered when its volume is turned up?
. Electric currents in excess of 10 mA (0.01 A) can produce painful shocks. Currents exceeding 100 mA (0.1 A) can be fatal. If a wet human has a resistance of 1700 Ω, and the household voltage is 110 V, what current can potentially flow through the human? Give your answer in decimal notation, to two significant figures with the units. Ohm’s law: Calculations: Answer: