a) A block diagram of an indirect (Armstrong) frequency modulation (FM) transmitter is shown in below. Let fi-100KHz, and the frequency deviation Af=10HZ at the input of this indirect transmitter, and the local frequency is ft.-8.5MHz. Evaluate ni and n2 to obtain a carrier frequency fe=100MHz and Af=75KHz at the output of this indirect FM modulator. m(1) NBFM f₁ A/₁ Frequency multiplier XA₁ راد /LO LPF h Frequency multiplier X n₂ le

a) A block diagram of an indirect (Armstrong) frequency modulation (FM) transmitter is shown in below. Let fi-100KHz, and the frequency deviation Af=10HZ at the input of this indirect transmitter, and the local frequency is ft.-8.5MHz. Evaluate ni and n2 to obtain a carrier frequency fe=100MHz and Af=75KHz at the output of this indirect FM modulator. m(1) NBFM f₁ A/₁ Frequency multiplier XA₁ راد /LO LPF h Frequency multiplier X n₂ le

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Calculate the frequency deviation and the carrier swing of a frequency- modulated wave which was produced by modulating a 50.4 MHz carrier. The highest frequency reached by the FM wave is 50.415 MHz. Then calculate the lowest frequency reached by the FM wave. If the frequency of the modulating signal is 5 KHz, what is the bandwidth of the FM wave?
a) If the carrier signal is 10V 100kHZ, the information signal is 5V 3kHZ, an AM Modulator is passed through a filter with Fr=100kHZ and Q=10, what is the sending status of the carrier lower and upper sidebands? b) Draw the AM modulator output envelope? c) Calculate the Modulation index and the sideband and total power to be sent in the transmitter according to the 50 Ohm transmitter output impedance? d) Draw the frequency spectrum? Calculate the antenna length in the transmitter?
A. How many numbers of constellation points exist in phase for 3bit ASK? B. What happens to the radio wave propagation when the frequency is below critical angle? C. If the mark frequency and space frequency are same then what happens to FSK? D. What is the Carson’s rule? E. What is the Maximum data rate in a minimum channel bandwidth is ? F. What is radio horizon and where is it used? G. What are the phase angle limitations of a BPSK? H. What is the change in channel capacity when two number of bits are increased?
For an AM envelope with a maximum peak voltage of 52 V and a minimum peak to peak voltage of 24 V, determine the ff. a. Percent modulation = ________? b. Peak voltages of the carrier and side frequencies = ________? c. Maximum positive to negative envelope voltage = ________?
: Suppose you have the following information signal ?(?) = 4sin⁡(4000?? + 90) modulates with the following carrier signal ?(?) = sin⁡(4000000?? + 90) to produce the 8KHz peak frequency deviation. Compute: 1. The FM expression in the time domain. 2. The frequency sensitivity constant. 3. FM signal bandwidth.
State how the frequency of a carrier varies in an FM system when the modulating signal amplitude and frequency change.
For an Armstrong indirect FM transmitter with the crystal carrier oscillating at 210 kHz, the crystal reference oscillating at 10.2 MHz, the sideband voltage is 0.018 V, the carrier input voltage to the combiner is 5V, the first and second multipliers are both 40, and the modulating signal frequency is 2 kHz, determine: a.) modulation index at the output of the combining network and the power amplifier; b.) frequency deviation at the same two points; and c.) the transmit carrier frequency.
Explain the principles of cognitive radio technology and its applications in dynamic spectrum allocation.
5. The following data is available: fc= carrier frequency = 750kHz, Ac= maximum amplitude of the unmodulated carrier = 10V fm= modulator frequency = 300Hz-8kHz modulation index m=0.5 a) What is the frequency of the upper sideband? b) What is the frequency of the lower sideband? c) What is the amplitude of the modulating signal? d) What is the maximum amplitude of the envelope of the modulated signal? e) What is the minimum amplitude of the envelope of the modulated signal? f) What is the bandwidth of the modulated wave? g) Write an expression for the modulated wave
please find enclosed spot of our general expression in our frequency modulation. And in this frequency modulation instantaneous frequency is given as: fi(t)=fc+400cos(2π100t) a)Here carrier frequency is fc, message signal is fm,so please calculate kf ,β(modulation indicator) ve maximum frequency deviation ∆f ? b)Write the simplest form of the FM modular signal by writing the parameters instead. c)Calculate the average power that the FM modulated signal will create on a 1 ohm resistor.
Explain the concept of "smart antennas" in wireless communication and their advantages in signal enhancement.
A 10Vp carrier signal is amplitude modulated by two different frequencies 5 KHz and 10 KHz with amplitude of 4Vp and 7.5Vp respectively using an DSBFC. If the system is connected to the 100Ω antenna, (a) what is the modulated carrier power and AM wave total power? From DSBFC, different transmitters with different modulation schemes were used to evaluate the performance in terms of power and bandwidth and compare to conventional AM. (b) Complete the table below and provide your solution.