а A Cz C3 C4 B CE C₁=C₂=C3 = 2 μF C4 = Cr² C6 - 4mF - TOTAL CAPACITANCE FROM ROINT AB? TOTAL ENERGY STORED? C6

Q: 1- Connect the following 8*8 Dot-Matrix LED display to AT89C51 microcontroller. C1-C8 are the…

A: The 8×8 LED matrix consists of 8 LED in each row and each column. Therefore there are total of 64…

Q: each resistor. d. Find V2,V4V6, and V8 e. Find P2, P4, P6, and P8 Hint: Look for the expression of…

A:

Q: Rea The equivalent resistance.6 : of the circuit in Fig. below is 2 ΚΩ 3 ΚΩ 3 ΚΩ (a) 4k O (b) 5 k Ο…

A: Given circuit,

Q: Problem Consider the following circuit below, assume V = 1.2 V and k = 0.5 mA/V². th a. Determine I…

A: Given data Vth=1.2 K=0.5

Q: The waveform shown below is periodic with T=10 s. Determine the average and effective values of…

A: The solution is given below

Q: Use NODAL analysis to find vab and io Note: Intelligent ground placement in this circuit could…

A: We need to find out current and voltage for given circuit

Q: Using mesh analysis find it , iz and iy in the circuit in Figure 3. 5Ω 20 V +4 12V + 2Ω 6Ω Figure 3

A: given here a network and asked find the currents in the i1,i2,i3 in the network.

Q: In the circuit shown in Fig. 8-14, the switch closes at t=0 s. Find r, and i for >0 s if (0) 100 V.…

A:

Q: 2. Find IB, IC, IE, VCE and VCB for the common emitter configuration of a PNP transistor. Rc 390 Ω…

A:

Q: Explain the V-I characteristics of a P-N junction diode when it is connected in forward bias and…

A: Brief description : Diode is a semiconductor device which is used as a switch and amplifier in any…

Q: 6. Describe in your own words the conditions established by forward and reverse-bias conditions on a…

A:

Q: w is an NMOS logic circuit. For all of the MOSFETs assume V th 5V 5V R₂ = 5600 R₁ = 4700 M3 Vo

A:

Q: Draw the equivalent circuit and characteristic curve of a forward biased diode using the first or…

A: In this question,   We need to Draw the equivalent circuit and characteristic curve of a forward…

Q: BJT has a current gain Beta of 100.If base current is 2 μA,what is col O collector current = 200…

A:

Q: A 3-phase alternator generates an open circuit voltage of 4000 V per phase when exiting current is…

A: The solution is given below

Q: A power transistor is specified to have a maximum junction temperature of 150°C. When the device is…

A:

Q: Im тоб VS R1 Given that VD = 5V, VS = -5V, R1 = 8.2k, R2 = 50k, R3 = 4.7K, Vth = 1.2V and k =…

A:

Q: Two filament lamps rated 200 W/200 V and 50 W/200 V are connected in series across a 200 V, 50 Hz,…

A: The total power is

Q: 4- In a bode magnitude plot, which one of the following slopes would be exhibited at high…

A: We need to select correct option for given statement.

Q: 3. Determine the dc resistance of a diode at VD =-20V if its reverse saturation current is 1µA (The…

A:

Q: Assume beta = 100, V = 0.7 V, V CE,sat = OV. ВЕ a. If R = 0 and V = 3 V, determine the value of V.…

A:

Q: Find IB, IC, IE, VCE and VCB for the common emitter configuration of a PNP transistor.

A:

Q: If the voltage across a 0.1-F capacitor is 30001 V, find the capacitor current.

A:

Q: 6. A 50 hp, 550 volts shunt wound motor draws a line current of 4.5 Amp at no load. The shunt field…

A: In this question we need to find a efficiency and total loss of motor at full load

Q: Problem 3. th Consider the following circuit below, assume V = 1.2 V and k = 0.5 mA/V². Determine I…

A: The solution is given below

Q: 7. Given the following linear series voltage regulator calculate the minimum (VOMIN ) and maximum…

A: We need to find out the output voltage for given circuit .

Q: Determine the d.c. resistance of a diode at V=-20V if its reverse saturation current is 1 μA. (Take…

A:

Q: 3. Obtain the state model for the block diagram shown. 1/s+1 U(s). 1/s 1/s+2 Y(s)

A: From the given block diagram we find a transfer function of the given system and from transfer…

Q: 4. Consider the system below: X(z) 12H (2) (12) 12)→Y (2) compute the output Y(z) in terms of X(z)…

A: The solution is given below

Q: Given two signals, x(t)=2sin(@t-30°) and y(t)=3cos(@t-45°): a. Accurately sketch a phasor diagram…

A:

Q: B-10-11. Consider the system defined by x = Ax + Bu y = Cx where 0 1 0 0 A = 0 01 B: C = [100] " -5…

A: One can easily find a state observer of a observable system using the arbitrary eigenvalues of…

Q: For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To…

A: In this question,   We need to determine the a) Load factor. b) Capacity factor. c) Maximum demand

Q: 3. Draw the equivalent circuit and characteristic curve of a forward biased diode using the third or…

A:

Q: A 500V, single-phase  SM gives a net output mechanical power of 7.46 kW and operates at 0.9 pf lag.…

A:

Q: 9) Which type/types of Amplitude Modulation signal/signals can be detected by the Envelope Detector?…

A: We can detect double side band (DSB) signal by envelope detector. Also DSB-SC, SSB and VSB signals…

Q: Q2):- Find Y[Z] of signal Y[n] (Cos wn). U[n]

A: In this question we will find z transform of given signal....

Q: 5 A coil is in series with a 20uF capacitor across a 230V 50Hz supply. The current taken by the…

A: Given:C=20μFV=230Vf=50HzI=8AP=200W Circuit diagram will be like:

Q: Both D1 and D2 are silicon diodes with forward voltages of 0.7V. Vi is the input, and Vo is the…

A: The conduction of diode can be ensured be validating the node voltage.if the node voltage is greater…

Q: 2 K + D₁ + 1 K Vo Vi D₂ A 2.6 V Diodes D1 and D2 are Silicon with forward voltages of 0.7 volts. v,…

A: Given circuit: Diodes D1 and D2 are of Si with forward bias voltage of 0.7 V.

Q: 1. Find for all the currents flowing and voltages in each circuit components

A:

Q: 6) For IC 7493, answer the following questions: a) What is the maximum count length of this counter?…

A:

Q: Below is an example of an NMOS logic circuit. For all of the MOSFETs in the circuit below, assume V…

A:

Q: Find the T.F of DE (h[n]) Y[n]=2X[n] +3X[n-1] - X[n-2] + 17X[n-3] - 6X[n-4]+Y[n-1] -3Y[n-2]

A:

Q: 2. Sketch the output voltage (v.) and the transfer characteristics (v, against v;) for each circuit…

A:

Q: RI R₁=50 M R2 R₂=100 ww R3R-532 R4N R₂=1022 48V R8 R7 R,= 100 M RON R₂=1022 R,=159 и R₂=52 R5

A:

Q: Is the following 0 6 A= 1 0 01 system BIBO stable? Is it internally stable? why? 9 0 FB-₁0-10 B= C=…

A:

Q: If the average daily load is 67.78 MW what is the weekly load (MWh)?

A: Given, Average daily load = 67.78 MW

Q: 7. Describe the construction and the material composition of a light emitting diode? An illustration…

A: It is a P-N junction diode When a suitable voltage is applied across the leads, it will emit light…

Q: + Vi 2 K D₁ 2.6 V D₂ A 1 K Vo

A: D2 conducts only  when,if the input voltage (Vi) is lessthan zero volts. Here in this case  Output…

Q: The constant of a 0.8 pf 2300V 60 Hz 16 pole 3-phase wye connected 800Hp SM is as follows: leakage…

A: Given, Input of synchronous motor=2300 V, 60Hz, 0.8 pfOutput=800 HpEfficiency, η=94.4 %16 pole…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.