p6 (a) A lightbulb has a resistance of 175 N when operating with a potential difference of 160 V across it. What is the current in the lightbulb (in mA)?(b) What If? What would be the current in the lightbulb (in mA) if it were used in Peru, where the potential difference across it would be 220 V?mA

a. Given R=175 Ω, V=160 V By using Ohm's Law V=IRI=VR=160175A=0.9143A=914.3 mA…

(a) A lightbulb has a resistance of 175 N when operating with a potential difference of 160 V across it. What is the current in the lightbulb (in mA)? mA (b) What If? What would be the current in the lightbulb (in mA) if it were used in Peru, where the potential difference across it would be 220 V? mA

(a) A lightbulb has a resistance of 175 N when operating with a potential difference of 160 V across it. What is the current in the lightbulb (in mA)? mA (b) What If? What would be the current in the lightbulb (in mA) if it were used in Peru, where the potential difference across it would be 220 V? mA

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter28: Current And Resistance

Section: Chapter Questions

Problem 67PQ

See similar textbooks

Similar questions

A conductor carries a current that is decreasing exponentially with time. The current is modeled as I=I0et/ , where I0= 3.00 A is the current at timet = 0.00 s and =0.50 s is the time constant. How much charge flows through the conductor between t = 0.00 s and =3 ?
Resistors are commonly rated at 18W,14W,12W ,1 W and 2 W for use in electrical circuits. If a current of1 = 2.00 A is accidentally passed through a R=1.00 resistor rated at 1 W, what would be the most probable outcome? Is there anything that can be done to prevent such an accident?
A 0.900-V potential difference is maintained across a 1.50-m length of tungsten wire that has a cross-sectional area of 0.600 mm2. What is the current in the wire?
An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C contains pure carbon resistors. By what factor does their resistance increase over this range?
The potential difference across the filament of a light-bulb is maintained at a constant value while equilibrium temperature is being reached. The steady-state current in the bulb is only one-tenth of the current drawn by the bulb when it is first turned on. If the temperature coefficient of resistivity for the bulb at 20.0C is 0.004 50 (C)-1 and the resistance increases linearly with increasing temperature, what is the final operating temperature of the filament?
When the potential difference across a certain conductor is doubled, the current is observed to increase by a factor of 3. What can you conclude about the conductor?
Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
Consider a resistor made from a hollow cylinder of carbon as shown below. The inner radius of the cylinder is Ri= 0.20 mm and the outer radius is R0 = 0.30 mm. The length of the resistor is L = 0.90 mm. The resistivity of the carbon is =3.5105 m. (a) Prove that theresistance perpendicular from the axis is R=2L1n(R0Ri) . (b) What is the resistance?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
A potential difference of 12 V is found to produce a currentof 0.40 A in a 3.2 - m length of wire with a uniform radius of0.40 cm. What is (a) the resistance of the wire? (b) The resistivityof the wire?
It’s possible to estimate the percentage of fat in the body by measuring the resistance of the upper leg rather than the upper arm; the calculation is similar. A person’s leg measures 40 cm between the knee and the hip, with an average leg diameter (ignoring bone and other poorly conducting tissue) of 12 cm. A potential difference of 0.75 V causes a current of 1.6 mA. What are the fractions of (a) muscle and (b) fat in the leg?
A piece of material with a square cross-section measuring 1 mm on each side has a length of 1 m. What is the resistance of this material if it were made of aluminium? Fused quartz? Finally, calculate the current through each piece of material if a potential difference of 1 volt is applied over its length.