A ball with diameter of 4 inches, is suspended in the middle of a room at 530°R. The ball's surface is maintained at a temperature of 700°R If the convection heat transfer coefficient is 0.04 kW/m2-°C and the emissivity of the surface is 0.7, determine the total rate of heat transfer from the ball.

A ball with diameter of 4 inches, is suspended in the middle of a room at 530°R. The ball's surface is maintained at a temperature of 700°R If the convection heat transfer coefficient is 0.04 kW/m2-°C and the emissivity of the surface is 0.7, determine the total rate of heat transfer from the ball.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solar radiation is incident on the glass cover of asolar collector at a rate of 700 W/m2. The glass transmits88 percent of the incident radiation and has an emissivityof 0.90. The entire hot water needs of a family in summercan be met by two collectors 1.2 m high and 1 m wide. Thetwo collectors are attached to each other on one side so thatthey appear like a single collector 1.2 m * 2 m in size. Thetemperature of the glass cover is measured to be 35°C on aday when the surrounding air temperature is 25°C and thewind is blowing at 30 km/h. The effective sky temperaturefor radiation exchange between the glass cover and the opensky is 240°C. Water enters the tubes attached to the absorberplate at a rate of 1 kg/min. Assuming the back surface of theabsorber plate to be heavily insulated and the only heat lossto occur through the glass cover, determine (a) the total rateof heat loss from the collector, (b) the collector efficiency,which is the ratio of the amount of heat transferred to…
An automotive engine can be approximated asa 0.4-m-high, 0.60-m-wide, and 0.7-m-long rectangularblock. The bottom surface of the block is at a temperatureof 75°C and has an emissivity of 0.92. The ambient airis at 5°C, and the road surface is at 10°C. Determine therate of heat transfer from the bottom surface of the engineblock by convection and radiation as the car travels at avelocity of 60 km/h. Assume the flow to be turbulent over theentire surface because of the constant agitation of the engineblock. How will the heat transfer be affected when a 2-mmthickgunk (k = 3 W/m?K) has formed at the bottom surface asa result of the dirt and oil collected at that surface over time?Assume the metal temperature under the gunk still to be 75°C.
A 50cm by 100 cm stainless steel plate with emissivity of 0.85 is maintained at 500°C. determine the heat produced by the plate in 30 minutes, and the power it dissipates
Water is entering a heated tube at mass ow rate of 1.2 kg/s. The temperature at the inlet is 20 C and at the outlet is 80 C. Assume the surface temperature of the tube is 100 C. The convection coe cient of the water ow is 28 W=m2 C. The speci c heat and density of water can be assumed to be 4180 J=kg C and 990 kg=m3. What is the rate of heat transfer to water during this proces
A 15-cm-diameter aluminum ball is to be heated from 80°C to anaverage temperature of 220C. Taking the average density and specific heat ofaluminum in this temperature range to be ρ=2700 kg/m3and Cp=0.90kJ/kg·°C, respectively, determine the amount of energy that needs to betransferred to the aluminum ball.
An array of power transistors, dissipating 6 W ofpower each, are to be cooled by mounting them on a 25-cm *25-cm-square aluminum plate and blowing air at 35°C overthe plate with a fan at a velocity of 4 m/s. The average temperatureof the plate is not to exceed 65°C. Assuming theheat transfer from the back side of the plate to be negligibleand disregarding radiation, determine the number of transistorsthat can be placed on this plate.
A copper plate, with dimensions of 3 cm x 3 cm x5 cm (length, width, and thickness, respectively), isexposed to a thermal energy source that puts out 150 J every second, as shown in the accompanyingfigure. The density of copper is 8900 kg/m3. Assuming no heat loss to the surrounding block, determinethe temperature rise in the plate after 10 seconds.
The temperature on the two surfaces of a 25mm thick steel plate (k=48w/m°c)
Flat-plate solar collectors are often tilted up towardthe sun in order to intercept a greater amount of direct solarradiation. The tilt angle from the horizontal also affects therate of heat loss from the collector. Consider a 1.5-m-highand 3-m-wide solar collector that is tilted at an angle u fromthe horizontal. The back side of the absorber is heavily insulated.The absorber plate and the glass cover, which arespaced 2.5 cm from each other, are maintained at temperaturesof 80°C and 40°C, respectively. Determine the rate ofheat loss from the absorber plate by natural convection foru = 0°, 30°, and 90°.
In the summer, parked automobile surfaces frequently average 104 °F to50°C and surface emissivity of 0.9, determine the radiant thermal heat fluxemitted by the car roof.
An average man has abody surface area of 1.8m2 and a skin temperature of 33degrees celcius .The convection heat transfer coefficient for a clothed person walking in still air is expressed as {h,8.6V^0.53}FOR 0.5<v<2m/s,where V is the walking velocityin m/s.Assuming the average surface temperature of the clothed person to be 30degrees celcius, determine the rate of heat loss from an average man walking in still air at 10degrees celcius by convectionat a walking velocity of (a)0.5m/s (b)1.0m/s (c)1.5m/s (d)2.0m/s
Q6: A large vertical plate 6.1 m high and 1.22 m wide is maintained at s constant temperature of 57:C and exposed to atmospheric air at 4-C. Caleulate the heat lost by the plate. Answers: Q