A barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder. The resistance of which is 0.0078 ohm per 1,000 ft the bus bar voltage is maintained constant at 600V. determine the load current

A barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder. The resistance of which is 0.0078 ohm per 1,000 ft the bus bar voltage is maintained constant at 600V. determine the load current

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter13: Heating Control Devices

Section: Chapter Questions

Problem 1RQ

See similar textbooks

Related questions

Q: 2.4 For the circuit shown, a) Ifi, - 0.5 A and G = 50 mS, find v, and the power delivered by the…

A: A) From the given diagram Vg is given as

Q: Q2. A meeting hall in an organization is to be provided with a lighting installation. The hall is 30…

A: As per the guidelines, we need to solve only first three sub parts

Q: A 2-wire d.c. distributor, 500 m long is fed at one of its ends. The cross-sectional area of each…

A: Transmission line diagram -

Q: A d.c. Distributor AB, 2-wire, 800 m long is fed from both ends at 240 V. Loads of 30 A, 40 A, 50 A…

A: In this question we need to find a minimum consumer voltage.

Q: A 100 Wp solar PV module is installed at a location with irradiation of 4.5 kWh/day. If the impact…

A: Given data, Capacity of solar module C = 100 Wp Irradiation I = 4.5 kWh/day

Q: q) 150 kv single core cable has a radius of cable of 5cm. The insulation martial has two layers. The…

A: This is q very good question based on power system topic of transmission. Here we have to find the…

Q: AO 332 142 432 20Ω

Q: A uniform 2-wire d.c. distributor 650 meters long is loaded with 0.28 ampere/ meter and is fed at…

Q: A meeting hall in an organization is to be provided with a lighting installation. The hall is 30 m…

Q: P1.27. Figure P1.27 shows an ammeter (AM) and voltmeter (VM) connected to measure the current and…

A: Referring to the question, the current flowing in the voltmeter is very small hence neglect the…

Q: Q2/ The resistivity of a coil of copper wire (1.8 km Length and 0.014 m diameter) at 18°C is 1.7 *…

A: A simple problem on netwrok subject , and topic is resistance variance with temperature. Look below…

Q: A Victoria plaza sub-station supplies 60kW to a load over 250 ft, 100mm2 , two conductors copper…

Q: The diameter of 000-gauge copper wire is 10.405 mm. Find the resistance of a 2.5-km length of such…

A: Resistance of a wire - Resistance and wire length have a proportionate connection. A thin wire's…

Q: A copper wire (ρ = 10.37 CM/ft) whose diameter is 0.162 inches has a resistance of 0.4 Ω. If the…

A: resistivity of conductor(ρ)=10.37cm/ftdiameter D1=0.162 inchesresistance R1=0.4 Ωdiameter D2=0.032…

Q: A copper conductor wire with a total length of 100ft is used in a 15 amp common household circuit…

Q: arning Portal Courses Reports e-Services Academic Departments ETC CIMS - 1.When lighted, a 100-watt…

Q: A 2-wire d.c. distributor A B is fed at both ends at the same voltage of 230 V. The length of the…

A: Let’s draw the single line diagram by locating distance and current Let r be a resistance…

Q: A room air conditioner has a coefficient of performance of 2.9 on a hot day and uses 850 W of…

A: Solution: Given data Coefficient of performance is, Power consumed, (a) The work done is, The…

Q: n the case of an OTEC plant, ammonia is used as an absorbent. Select one: True False 25: Which one…

A: It's true that AMMONIA is used as heat absorbent in ocean thermal energy plant.

Q: Figure www 2002 60 Ω 30 (2 40 Ω 1 of 1 oa Find the equivalent resistance between terminals a and b…

A: Given circuit:

Q: B. Copper wire of length (/) connected in parallel with aluminum wire of length (21) and (10mm)…

A: Given: For copper wire, Length, L1 = l Resistivity, ρ1=0.0159 μΩ-m Diameter, d1 =? For Aluminum…

Q: The specification a solar Photovoltaic power system is given in the pelow Table B1. Table B1:…

Q: uestion 5 A natural gas plant with a 50MW operates at an average loading of 75% year round. How…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A maximum current of 60 A flows in a copper conductor with cross-sectional area, A̟ = 13.5 mm2 and a…

Q: g.1. The Let-Go current threshold for people has defined the operating point for a Class A GFCI…

A: g.1.). The Let-Go current threshold for people has defined the operating point for a Class A GFCI…

Q: 2. A 2-wire d.c. distributor 250 meters long is uniformly loaded with 2.5A/meter. Resistance of…

A: Given, A 2 wire d.c. distributor with, Length, L = 250 m Uniformly loaded with current, i = 2.5 A/m…

Q: A power plant produces 1000MW to supply a city 40km away. Current flows from the power plant on a…

A: The solution to part a is as follows, but the solution to part b can not be achieved as the…

Q: A2 TW conducttor is installed in a location where the ambient mperature is expected to be 102"F. The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: calculator in four decimal places and show your final answers in FOUR DECIMAL places. 1. The…

Q: Question is in the image

A: Let’s draw the single line diagram by locating distance and current Let r be a resistance per unit…

Q: Q1) A 2-conductor cable 1 km long is required to Supply a constant current of 200A throughout the…

A: Given Two conductor cable Length of the conductor l=1 kmConstant Current I=200 ATotal hours t=4000…

Q: A 2-wire d.c. distributor, 500 m long is fed at one of its ends. The cross-sectional area of each…

A: Draw the transmission line diagram for the above case.

Q: A two-wire d.c. distributor AB, 600 metres long is loaded as distance from A (metres) : 150m, 300m,…

A: The circuit diagram for a two-wire d.c. distributor system is shown below:

Q: 121 3.6K2 62 KA 470KA B-80 VCE Ba120 9.1K 0.18KA

A: a) Given β = 120, VCC = 16 V, VBE = 0.7 V, RB = 470 KΩ, Calculating IB (base current) Calculating…

Q: Q3) A 2-wire D.C distributor AB, 1000 meters long is fed at A at 400 V and loads of 50 A, 100 A and…

A: This problem can be done by drawing a single line diagram of given distribution system and by…

Q: A 2-wire d.c. distributor 300 metres long is uniformly loaded with 4A/metre. Resistance of single…

A: We have a DC 2-wire distributor which is, Length of distributor (l) = 300 meter Current (i) = 4 A /…

Q: Q2/ A transmission line has a span of 250 m between supports, the supports being at the same level.…

A: SAG: The difference in level between points of supports and the lowest point on the conductor is…

Q: Advanced Grounding Applications 13. Which article of the National Electrical Code provides the…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: Part-2 QI/ Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 2A,…

Q: (c) Figure Q5(c) shows a without and with guard circuit of a Megger insulation resistance…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: 5. An electric kettle contains 2L of water which it heats from 20-C to boiling point in 5 minutes.…

A: Specific heat of water is 4184 j/kg. And density of water is 1 g/cm3 So mass of 2 liter water = 2kg.…

Q: barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder.…

Q: A power plant produces 1000MW to supply a city 40km away. Current flows from the power plant on a…

A: The solution for part a can be achieved as follows. But here part b can not be calculated as the…

Q: Assess the performance of different component of ocean thermal energy conversion (OTEC) at the basis…

A: To explain OTEC

Q: H. W.: The cost of a 2-core feeder cable, including installation is (90 a + 20) per meter and the…

A: According to the question we have to calculate the most economical cross-sectional area.

Q: Q2) A 2-wire d.c. street mains AB, 600 m long is fed from both ends, the loads of 20 A, 40 A, 50 A…

A: For the datas given we have to draw the circuit T1,T2,T3,T4 are resistance of section…

Q: Electrical Engineering - High voltage system EENG451 Please solve the question quickly

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Answer = 108 A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A barangay power station supplies 60kW to a load over 2,500ft, 100 mm², two conductors copper feeder. The resistance of which is 0.0078 ohm per 1,000 ft the bus bar voltage is maintained constant at 600V. Determine the load current.
A Barangay power station supplies 60KW to a load over 2500 ft, 100mm squared, two conductor copper feeders, the resistance of which is 0.078 ohm per 1000ft. The bus bar voltage is maintained constant at 600V. Determine the maximum power which can be transmitted.
Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a distance of 16 miles. A power link is to be established between them. The power link delivers a maximum power of 584 megawatts at full capacity with an operating voltage of 580 kilovolts. Note that 1 mile is 1.6 kilometers. Solve for the resistivity (in ohm-micrometers) of the cable asusming a conductor diameter of 1.55 centimeters.
a) If the cost of electricity consumption in Oman is OR 0.020/unit (where, 1 unit = 1 kWH), Calculate the monthly electricity bill for a load usage of 11 lamps (5 watts each), 11 fans (89 watts each) and 1 TV (341 watts) for 8hrs a day. (b) Calculate the efficiency of a solar PV module whose length is 159 cm and width is 105 cm and produces a 256 W maximum power when exposed to 920 W/m2 solar irradiance?
Design a 25V solar PV panel system that can power a home that requires two 30-Watt lamps and four 15-Watt fans for 6 hours daily if the factors for the solar panel generation and the total energy losses respectively are2.92 and 1.3. Take the rating of the available solar PV cell as 5V, 5W
Determine the size of PV modules, inverter, battery and solar charge controller of a PVsystems given the following load used for 8 hours per day:One 12 Watt LED bulbOne 60 Watt fanThree 200 Watt desktop computersUse reference: https://www.leonics.com/support/article2_12j/articles2_12j_en.php
a copper bus bar carrying 1200A has a voltage drop of 1.2mV along 24cm of its length. What is the resistance per meter of the bar?
Compute the cost per hour at 7.50 pesos per kwh of electrifying the house. If the appliances inside the house are an electric fan with resistance of 25 ohms, television which requires 5 ampere of current to start, water dispenser with resistance of 3 ohms, all connected to 220V and on for 8 hrs.
Please provide Handwritten answer Q: Briefly discuss the side effects of 33kV distribution line on the society.
A Victoria plaza sub-station supplies 60kW to a load over 250 ft, 100mm2 , two conductors copper feeder, the resistance of which is 0.078 ohm per 100 ft. The bus bar voltage is maintained constant at 600V.Determine the load current
An office in Oman has the following electrical appliances usage: (i) Twenty numbers of 15 Watt LED lamps are used for half of the day. (ii) Fifteen numbers 40 Watt computer used 10 hours per day. The system will be powered by a 12 V DC, 120 WP PV module. Calculate the number of PV panels for the given requirements with the assumption of 40 percent total energy loss.
A wind energy system has been designed for 20 years of operation. The designed system has a wind turbine of power 600 kW which costs is $450,000. Estimate the Levelized cost of electricity generated by this wind energy system. (Capacity factor: 28.54%)