A beam supported by three identical springs at points A,B,C (see figure). Given that flexural of rigidity of the beam, EI= 2.029X1011 N.mm2 ; spring constant,k = 1471.5N/mm, w=116N/mm All dimensions are in mm. 1. What is the reaction for at point A,B and C? 2. What is the deflection at point B? 3. Please draw shear-force and bending moment diagram.

Q: %3D Determine force P from the given figure so that xg = 5 m. XB 4 m В 6 m 600 N 1 m D -2 m-

A: Given: The value of xB is 5 m. Consider the figure,

Q: Using Slope-Deflection Method, determine the support reactions and moments at each joint of the…

A:

Q: A beam and a truss element are connected at joint 1 and loaded by 500 kN force. Use FEA to calculate…

A: The above problem can be solved by using the equilibrium equation by resolving the components in X…

Q: For the given beam E = 29,000 ksi and I = 300 in4 shown in figure 6. Determine the location of the…

A:

Q: Consider the loaded beam in the figure below: the closest number to vertical reaction force at A…

A: Let reaction at A is RA Moment at C is zero, thereforeRA×9-24×6-24×3×1.5 = 0RA×9 =252RA = 28 kN

Q: In the figure shown, El is contant. Determine the Moment at A in kNm. 100 kN 50 kN/m Sm D 3m 3m 4m O…

A:

Q: The figure, Fig.Q.4(b), shows a rigid-jointed plane frame subjected to the' load condition shown in…

A:

Q: Q1/ Determine the magnitude and direction angle(0) of force (F4) So that the particle shown in…

A:

Q: Q1: A reducing elbow is used to deflect water flow at a rate of 30 kg/s in a horizontal pipe upward…

A: From the figure, the inlet is taken as section (1) and outlet is taken as section (2). It is…

Q: A horizontal force P = 70 N is exerted on %3D block A as shown in the figure. Block A has a mass of…

A:

Q: Determine the moment of inertia of the closed area with respect to the x and y axis as shown in…

A: divide the figure into rectangle and two semi-circles.therefore,area of…

Q: 13. Determine the force F required for equilibrium in the figure shown. W b03 sq.m. A = 0.30 sq.m.…

A:

Q: FORCES, RESULTANT & ΜΟΜΕNT 90 F1 76 DEG 2. The forces shown in the figure are directed at the…

A:

Q: A continuous beam carries a distributed load and concentrated load as shown in the figure. Solve the…

A: Calculate the first three-moment equation (TME) factor for span CD. 6AaL=PaLL2-a2+7wL360…

Q: 408 kg 1220 mm RA B 90 kg / m 2440 mm Rc 1830 mm 181 kg D

A: Given values: Consider the overhanging beam given. Draw Loading, Shear force and Bending moment…

Q: Figure Q2(a) shows a cantilever beam that is subjected to a pure bending moment M = 3kN.m about the…

A:

Q: The end of a cantilever I beam supports forces from three cables. a) If P = 0, determine the…

A: Given :

Q: The resultant of the three forces shown in the figure is 707 N and acts on the direction u-axis.…

A: Draw the figure.

Q: The beam shown, determine the support reactions by using the deflection charts. Given: EI is…

A: Given:- EI = Constant

Q: Block A is located on the top of Block B. The weight of block A is 1000 N while the weight of Block…

A: (i) free body diagram of block A

Q: In the figure shown, El is contant. Determine the Moment at A in kNm. 100 kN 50 kN/m B Sm 3m 3m 4m O…

A: As per guidelines we can answer one question at a time, please upload separately for answer Find…

Q: Using Slope-Deflection Method, determine the support reactions and moments at each joint of the…

A:

Q: Analyze the beam in Figure P10.4 by slope- deflection and draw the shear and moment diagrams for the…

A: Question is based on fixed beam which is loaded by a point load and uniformly distributed load.…

Q: 2. Determine the displacement of point B of the beam shown in Figure 2. E = 200 GPa and I = 500(10°)…

A:

Q: PROBLEM 10.3 30 kN 5 kN A statically determinate pin-jointed frame is shown in Figure P10.3. The…

A:

Q: 2. Find the value of P and F so that the four forces shown in the figure produce an upward resultant…

A: Solution:- The given figure is shown below,

Q: Using the energy method, determine the vertical deflection of point D in the cantilever beam under…

A: To determine deflection at 'D', fictitious load of P is applied at D as shown in figure.

Q: Eor the continuous beam shown below, by the slope-deflection equations, determine the maximum…

A: Moment : A force's moment is an assessment of its propensity to cause a body to rotate around a…

Q: In the figure, the rigid AD bar is held vertically by two elastic rods articulated at the ends,…

A: Let horzontal reaction at B and C is Hb and Hc and Hc respectively, and verticalreaction at D is…

Q: To adjust the vertical position of a position of a column supporting a 2000 lb load, two 5°wedges…

A:

Q: 1. Determine the moment of inertia of the T-section shown in the figure with respect to its…

A: Finding centroid of T section : Take reference axis at the bottom of T section  Centroid y ⇀ =A1y1 +…

Q: Determine the magnitude of force, F (kN), if the resultant of the vectors shown in the figure is 67…

A:

Q: 3.) The screw eye in the figure below is subjected to two forces of the resultant force. F, and F₂…

A:

Q: 3.) Rigid bar BC is supported by aluminum rod (1) and bronze rod (2), as shown in the figure. If the…

A:

Q: Consider the beam in (Figure 1). Suppose that a = 10 in, b = 10 in., c = 1 in., and d = 5 in.…

A:

Q: .Determine horizontal displacement and rotation at D. The frame members have a 0.1m/0.1m (A=0.01 m?)…

A:

Q: Given the direction and values of reactions at hinge and roller of the beam shown in the figure.…

A:

Q: a = 5.5 m, b = 3.3 m, c = 20.3 kN/m, d = 27 kN. d kN d kN c kN/m "b" m a" m "b" m FIGURE 3

A:

Q: Figure 1 shows a statically indeterminate structure supporting a gradient distributed load.…

A: FBD:

Q: A simplified crane is shown in Figure 9 lifting a 400-kg load. The crane is supported by a pin joint…

A: Given data:

Q: If D KN and E kg, calculate the resultant of the two applied forces in pounds and its direction fron…

A:

Q: From the given frame shown. Calculate the vertical reaction at A? if q =14.31 , and L=8.94. Answer…

A:

Q: Three concurrent forces in equilibrium is as shown in the figure. , 50 ΚΝ > 60 ΚΝ B 94.50 KN Find…

A: Given:- three concurrent forces are acting as shown

Q: For the forces in the figure shown, determine the following: a. magnitude of the horizontal…

A:

Q: 1. The 300 kN sphere is supported by a pull P and a 200 kN weight passing over a frictionless…

A:

Q: 12kN/m 24kN/m

A: From the given beam it is required to calculate deflection at mid point of a beam.

Q: 50 rom T 1000 mm 300 mm 3. Determine the centroidal moment of inertia about the X axis.

A:

Q: -10 m 150 N 150 N -6 m -6 m 10 m 1. DETERMINE THE MOMENTS OF THE TWO FORCES ABOUT X, Y, AND Z AXES…

A:

Q: Calculate the value of F and the value of theta θ so that the resultant of the forces is 1200 lb…

A:

Q: Q. 2 Determine the vertical displacement of Joint A shown in Q. 2, if members AB and BC experience a…

A: