A bedroom is to be conditioned that the total heat load is 20 kW and the sensibleheat ratio is 0.4. The room is to be maintained at 22°C DB and 55% relativehumidity. The outside air condition is at 32°C DB and 23°C WB. The conditioned airfrom the reheater enters the room at 17°C. Determine the following:a. The percentage of recirculated air if the mass flow rate of water vapor in themixture is 1 kg/minb. The refrigeration loadTRc. The heat required in the reheaterkW

A bedroom is to be conditioned that the total heat load is 20 kW and the sensible heat ratio is 0.4. The room is to be maintained at 22°C DB and 55% relative humidity. The outside air condition is at 32°C DB and 23°C WB. The conditioned ain from the reheater enters the room at 17°C. Determine the following: a. The percentage of recirculated air if the mass flow rate of water vapor in the mixture is 1 kg/min

A bedroom is to be conditioned that the total heat load is 20 kW and the sensible heat ratio is 0.4. The room is to be maintained at 22°C DB and 55% relative humidity. The outside air condition is at 32°C DB and 23°C WB. The conditioned ain from the reheater enters the room at 17°C. Determine the following: a. The percentage of recirculated air if the mass flow rate of water vapor in the mixture is 1 kg/min

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 0.3-m3 rigid tank initially contains refrigerant- 134a at 14°C. At this state, 55 percent of the mass is in the vapor phase, and the rest is in the liquid phase. The tank is connected by a valve to a supply line where refrigerant at 1.4 MPa and 100°C flows steadily. Now the valve is opened slightly, and the refrigerant is allowed to enter the tank. When the pressure in the tank reaches 1 MPa, the entire refrigerant in the tank exists in the vapor phase only. At this point the valve is closed. Determine (a) the final temperature in the tank, (b) the mass of refrigerant that has entered the tank, and (c) the heat transfer between the system and the surroundings.
3.9 m3/s of saturated water vapor enters a compressor at 250 kPa and leaves it with a pressure equal to 1400 kPa. Assume the process to be isentropic. Determine the work rate necessary to the nearest kW.
Thermal dynamics Steam enters a turbine at 20kg/s, 900 degrees C and 8MPa. 20% of the steam is left at pressure of 400kPa, and the remaining is left at the exhaust pressure of 50 kPa. If the isentropic efficiency of the turbine is 80%, determine the actual power generated by this turbine, and the temperature at both the intermediate port and exhaust port.
Thermodynamics Question: Refrigerant – 134a is to be cooled by water in a condenser. The refrigerant enters the insulated condenser with a mass flow rate of 6 kg/min at 1 MPa, 70 oC and leaves at 35 oC. The cooling water (compressed liquid) enters at 300 kPa and 15 oC and leaves at 25 oC. Neglecting any pressure drops, kinetic and potential energy changes in the pipes, determine (a) the mass flow rate of the cooling water required and (b) the heat transfer rate from the refrigerant to water.
An isobaric boiler vaporizes saturated liquid water at 200kPa until it is saturated vapor. If the mass flowrate of the water is increased but the same heat transfer rate is maintained, what should be the new state of the boiler outlet? a. Subcooled liquid b. Superheated vapor c. Mixture of liquid and vapor d. Saturated vapor
Moist air at DBT = 300C and WBT = 250C enters a cooling coil and exit from it at saturation state with DBT = 150C. If the air is supplied to the coil at 2 m3/s a) determine all the properties of the air at inlet and outlet. b) The sensible heat that has been removed by the cooling coil. c) The amount of moisture that has been removed from the air by the cooling coil
In a certain geothermal area, studies show that 1,500,500 kg/hr of pressurized ground water is available at 2500 psia and 6200F. The water will be throttled to 250 psia to produce ert steam and this mixture will be passed through a water separator to remove the water droplets so that saturated steam at 250 psia is available at the entrance of steam turbine for the proposed power plant. Other data are as follows: Discharge pressure of turbine 25 in. Hg. Vaccum Turbine Engine efficiency 75% Mechanical Loss1.5% of shaft power Generator efficiency 97% Assume atmospheric pressure to be 30 in. Hg. Determine the maximum amount of power in kW that the plant can generate.
Refrigerant R134a enters an expansion valve at 800 kPa as a saturated liquid and exits at 100 kPa. The temperature of the refrigerant at the outlet of the valve and the vapor fraction will be? (a) 31.3°C and 0.0 (b) -26.4°C and 0.28 (c) -26.4 °C and 0.36 (d) 31.3°C and 0.28
A saturated liquid–vapor mixture of water, called wet steam, in a steam line at 1600 kPa is throttled to 50 kPa and 100°C. What is the quality in the steam line? Use data from the steam tables.
Refrigerant 134-a enters a compressor as saturated vapor at -20°C and leaves at 1.2 MPa and 80°C. The mass flow rate of the refrigerant is 1.5 kg/s. If the heat loss from the compressor per unit mass of refrigerant is 20 kJ/kg, what is the power input to the compressor?
15- R134a enters a compressor with a heat loss of 200 W as saturated steam at -24 ºC and after compressing to 0.8 MPa, it exits the compressor at 60 ºC. The mass flow of R134a is 1.2 kg/s. Calculate the volumetric flow of the refrigerant at the compressor inlet. A-0,129 m3/sB-0,293 m3/sC-0,163 m3/sD-0,209 m3/sE- 0,347 m3/s (Note: This Turkish I'm using translate) orginal; R134a ısı kaybı 200 W olan bir kompresöre doymuş buhar olarak -24 ºC sıcaklıkta girmekte ve 0.8 MPa basınca sıkıştırıldıktan sonra kompresörden 60 ºC sıcaklıkta çıkmaktadır. R134a’nın kütlesel debisi 1.2 kg/s’dir.Soğutucu akışkanın kompresör girişindeki hacimsel debisini hesaplayınız.
Is aircon-ditioner an example of thermodynamic system inside the house? Is it an open system, closed system or isolated system? Explain why.