A block is pulled at constant speed along a rough level surface by a rope that makes an angle of 30° with respect to the horizontal. The applied force along the rope is p. The force of kinetic friction between the block and the surface is 20 N. 30 Which one of the following expressions gives the magnitude of the force P in SI units?

A block is pulled at constant speed along a rough level surface by a rope that makes an angle of 30° with respect to the horizontal. The applied force along the rope is p. The force of kinetic friction between the block and the surface is 20 N. 30 Which one of the following expressions gives the magnitude of the force P in SI units?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 40PQ: A sleigh is being pulled horizontally by a train of horses at a constant speed of 8.05 m/s. The...

See similar textbooks

Similar questions

A 3.00-kg object is moving in a plane, with its x and y coordinates given by x = 5t2 1 and y = 3t3 + 2, where x and y are in meters and t is in seconds. Find the magnitude of the net force acting on this object at t = 2.00 s.
A sleigh is being pulled horizontally by a train of horses at a constant speed of 8.05 m/s. The magnitude of the normal force exerted by the snow-covered ground on the sleigh is 6.37 103 N. a. If the coefficient of kinetic friction between the sleigh and the ground is 0.23, what is the magnitude of the kinetic friction force experienced by the sleigh? b. If the only other horizontal force exerted on the sleigh is due to the horses pulling the sleigh, what must be the magnitude of this force?
For the woman being pulled forward on the toboggan in Figure 4.33, is the magnitude of the normal force exerted by the ground on the toboggan (a) equal to the total weight of the woman plus the toboggan, (b) greater than the total weight, (c) less than the total weight, or (d) possibly greater than or less than the total weight, depending on the size of the weight relative to the tension in the rope?
the coefficient of static friction between block A and a horizontal floor is 0.320, and the coefficient of static friction between block B and the floor is 0.300. The mass of each block is 2.00kg,and they are connected together by a cord. If a horizontal force F pulling on block B is slowly increased ,in a direction parallel to the connectin cord,until the block start sliding ,what is the magnitude of F at the instant that they start to slide?
A horse pulls a box of mass M = 55 kg across a rough horizontal surface by applying a horizontal force of 874 N.If the coefficient of kinetic friction between the box and the surface is μk = 0.5, what is the acceleration of thebox?
A mountain climber practices his technique in a mountain climbing school by balancing while suspended by two ropes attached to the ceiling. As shown by the figure, the left rope makes an angle of 60 degrees with the horizontal ceiling and the right rope makes an angle of 30 degrees with the horizontal ceiling. If the right rope has tension T1=322 N, what is the weight of the mountain climber?
A 20 kg sled is being pulled along the ground by a 100 N force directed 30° above horizontal. Given the coefficient of kinetic friction between the sled and the snow is 0.100, what is the magnitude of the friction acting on the sled?
A boy has stacked two blocks on the floor so that a 5.00kgblock is on top of a1.60kg block. If the coefficient of static friction between the two blocks is 0.400 and the coefficient of static friction between the bottom block and the floor is 0.220,with what minimum force should the boy push horizontallyon the upper block to make both blocks start to slide together along the floor?
A mass m is being pushed by a horizontal force F of magnitude 209.0 N. The coefficient of kinetic friction between the two surfaces is 0.4. What is the magnitude of the acceleration of this mass as it gets to be pushed up the ramp?
Ed is pushing with a force of 352.9 N at an angle of θ = 56.1 degrees with respect to the vertical and Al is pushing with a force of 146.3 N at an angle of ϕ = 37.3 degrees with respect to the horizontal. If the couch has a mass of 89 kg and the coefficients of static and kinetic friction between the couch and the floor are μs = 0.53, and μk = 0.39, what is the magnitude of the force of friction exerted by the floor on the couch? I am not understanding how to solve this. I think I need to use Newtons second law but I just dont know. Can someone please show me how to do this?
The coefficient of static friction between a block and a horizontal floor is 0.47, while the coefficient of kinetic friction is 0.14. The mass of the block is 4.2 kg. If a horizontal force is slowly increased until it is barely enough to make the block start moving, what is the net force on the block the instant that it starts to slide?
A body weighing 2,225 N is being dragged along a rough horizontal plane by a force of P = 445 N. If the coefficient of friction is 1/12 and the line of the pull makes an angle of 18 deg above the horizontal, what are the velocities acquired from rest in the first 3.65m and in the first 5.5m?