A block of mass M = 10 kg is sitting on a surface inclined at angle θ = 45°. Given that the coefficient of static friction is μs = 0.5 between block and surface, what is the minimum force F necessary to prevent slipping? What is the maximum force F that can be exerted without causing the block to slip?

A block of mass M = 10 kg is sitting on a surface inclined at angle θ = 45°. Given that the coefficient of static friction is μs = 0.5 between block and surface, what is the minimum force F necessary to prevent slipping? What is the maximum force F that can be exerted without causing the block to slip?

Name: A block of mass M = 10 kg is sitting on a surface inclined at angle θ
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: A block of mass M = 10 kg is sitting on a surface inclined at angle θ = 45°. Given that the coefficient of static friction is μs = 0.5 between block and surface, what is the minimum force F necessary to prevent slipping? What is the maximum force F t

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter4: The Laws Of Motion

Section: Chapter Questions

Problem 23P: A bag of cement weighing 325 N hangs in equilibrium from three wires as suggested in Figure P4.23....

See similar textbooks

Similar questions

The two blocks (m= 16 kg and M = 88 kg) are not attached to each other.The coefficient of static friction between the blocks is ms =0.38, but the surface beneath the larger block is frictionless. What is the minimum magnitude of the horizontal force required to keep the smaller block from slipping down the larger block?
The static friction coefficient between the block and the inclined surface is 0.2. What is the minimum force that should be applied to the block perpendicular the surface in order to prevent the block from sliding down?
A picture frame hung against a wall is suspended by two wires attached to its upper corners. If the two wires make the same angle with the vertical, what must this angle be if the tension in each wire is equal to 0.75 of the weight of the frame?
Three cables are used to tie the balloon shown in Figure. Determine the magnitude of the vertical force (P) exerted by the balloon at A, knowing that the tension in cable AD is 1.041 N y1 = 4.3 m y2 = 2 m x1 = 4.3 m x2 = 3.3 m z = 5.6 m .
A bag of cement weighing 400 N hangs in equilibrium from three wires. Two of the wires make angles ?1 = 56.0° and ?2 = 36.0° with the horizontal. Assuming the system is in equilibrium, find the tensions T1 and T2
A uniform plank of length 2.00 m and mass 29.5 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 685–N person is d = 0.500 m from the left end. magnitude of T1 = magnitude of T2 = magnitude of T3 =
Two blocks with masses m1 = 24.8 kg and m2 = 79.8 kg, shown in the figure, are free to move. The coefficient of static friction between the blocks is 0.60 but the surface beneath m2 is frictionless. What is the minimum force F required to hold m1 against m2?
The two blocks (m =16 kg, M =88 kg) in Fig. are not attached to each other. The coefficient of static friction between the blocks is µs =0.38, but the surface beneath the larger block is frictionless. What is the minimum magnitude of the horizontal force required to keep the smaller block from slipping down the larger block?
Suppose the tension in both of the cables is measured to be 50 N and that the angle that each cable makes with the horizontal is known to be 30 degrees. What is the weight of the sign? * a. 150 N b. 50 N c. 30 N d. 25 N
A block of weight W=100 is on a rough plane inclined at an angle of 30 degrees with the horizontal. The magnitude of the normal force N1 and the friction F1 when the block is in equilibrium. If the plane was frictionless, find the magnitude of the horizontal force F1, required to keep the block in equilibrium.
Two blocks A and B are connected by a horizontal bar whose mass is negligible. The mass of block A is 100-kg and the mass of block B is 50-kg. What force P will just prevent the blocks from slipping down the plane?The coefficient of friction between block A and the inclined surface is o.20, while that of block B and the inclined surface is 0.30.
A telephone pole is supported by a guy wire which exerts a pull of 300 N on the top of the pole. If the angle between the wire the pole is 60 degrees, what is the vertical component of the pull on the pole?