A boy tossed the basketball at an angle of 29-degrees from the horizontal. The basketball is 1.7 m above the ground at the time of release and the basketball hoop is 7.0 m away and 4.1 m high. Neglecting the size of the ball in the calculation, determine the speed which the ball pass through the hoop.

A boy tossed the basketball at an angle of 29-degrees from the horizontal. The basketball is 1.7 m above the ground at the time of release and the basketball hoop is 7.0 m away and 4.1 m high. Neglecting the size of the ball in the calculation, determine the speed which the ball pass through the hoop.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter8: Time And Time-related Variables In Engineering

Section: Chapter Questions

Problem 39P

See similar textbooks

Similar questions

A 1.50-kg steel ball is dropped from a plane to an ocean. If the velocity of the ball just before reaching the water is 11 m/s and if the resistance in the water is 2.8v, what is the distance travelled by the object after 3.3 seconds? Answer in four decimal places. differential equation
PLEASE ANSWER QUESTION #1 ONLY, DISREGARD THE OTHER PROBLEMS GIVEN. SHOW COMPLETE SOLUTION. THANK YOU. An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. Determine the following: QUESTION #1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place QUESTION #2: the water level in the tank 15 min. later (sample answer: 20,287.65 ft round off to 2 decimal place QUESTION #3: the volume change in the tank (sample answer: 20,287.65 cu ft round off to 2 decimal place
An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. Determine the following: QUESTION 1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place
Imagine the water level in the tank described rises at a rate of 4 mm/s. Knowing the diameter of the tank is 240 mm, what is the average velocity of the water leaving the tank?
A metal sphere was released from a vertical height of 3.758 meters. When it hit the ground, it rebounds to its original height. Assume the ground exerted a force for 0.01 seconds, what amount of acceleration was caused by the impulse? include figure and FBD
Suppose that one such tank is cylinder shaped, 50ft high with a radius of 20ft. If we assume that water is pumped out of the tank via a pipe directly on top of the tank and that the tank is filled to a depth of 30ft, how much work (in ft-lbs) would be done by a pump to empty the tank? You may take the density of water to be 62.4 lbs/ft3
10. As shown in the figure, a projectile is fired at an angle of 81° from the inclined plane. It lands at a distance 87 meters measured along the inclined plane. Determine its initial velocity (m/s). Round off to two decimal places.
Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?
A basketball is thrown 35 degrees from the vertical. The distance of the player is 14 ft from the ring. Upon the release of the ball, it has a distance of 7 ft measured from the ground and 1 ft away from the player. Compute the velocity at release if the height of the ring is 10 ft. Please show complete diagrams and solution.
Instead of a 0.9 cm diameter water pipe, a 2.3 cm diameter pipe was installed. 8.6 liters of water per second was obtained from the previous water pipe. How fast does the water come out of the new line in liters per second? Other aspects related to water pipes are assumed to remain unchanged.
1. In calibrating a 10-mL pipet, a measured volume of water was transferred to a tared flask and weighed, yielding a mass of 9.9814 g. (a) Calculate, with and without correcting for buoyancy, the volume of water delivered by the pipet. Assume that the density of water is 0.99707 g/cm3 and that the density of the weights is 8.40 g/cm3. (b) What are the absolute and relative errors introduced by failing to account for the effect of buoyancy? Is this a significant source of determinate error for the calibration of a pipet? Explain. 2. Repeat the questions in problem 1 for the case when a mass of 0.2500 g is measured for a solid that has a density of 2.50 g/cm3. 3. Is the failure to correct for buoyancy a constant or proportional source of determinate error?
A rectangular tank 5m long, 2m wide and 2 m high is filled with water to a depth of 1.5m. It is mounted on a truck and accelerated along its length. If acceleration, a = 4m/s2, how much water will be spilled out? Do not write any unit in your answer, use 3 decimal places. Unit of Ans is m3