A bullet is moving at a speed of 620 m/s when it embeds into a lump of soil. The bullet penetrates for a distance of 0.0382 m. Assuming that the acceleration is uniform, determine the acceleration of the bullet while moving into the soil. (express your answer in 2 decimal places without comma and units) * .

A bullet is moving at a speed of 620 m/s when it embeds into a lump of soil. The bullet penetrates for a distance of 0.0382 m. Assuming that the acceleration is uniform, determine the acceleration of the bullet while moving into the soil. (express your answer in 2 decimal places without comma and units) * .

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter7: Length And Length-related Variables In Engineering

Section: Chapter Questions

Problem 50P

See similar textbooks

Similar questions

A liquid discharged from a container through a circular orifice having a diameter of 10 mm that is located 5 m. from the liquid surface to the center of the orifice. Evaluate the theoretical discharge through the orifice in liters per second if the container is moving upward at an acceleration half that of gravity.A.0.80liters/secC.0.90liters/secB.0.85liters/secD.0.95 liters/sec
PLEASE ANSWER QUESTION #1 ONLY, DISREGARD THE OTHER PROBLEMS GIVEN. SHOW COMPLETE SOLUTION. THANK YOU. An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. Determine the following: QUESTION #1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place QUESTION #2: the water level in the tank 15 min. later (sample answer: 20,287.65 ft round off to 2 decimal place QUESTION #3: the volume change in the tank (sample answer: 20,287.65 cu ft round off to 2 decimal place
An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. Determine the following: QUESTION 1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place
A boat has an initial speed of 12 ft/s . It then increases its speed along a circular path of radius ρ = 80 ft at the rate of v˙=(1.7s)ft/s2, where s is in feet. Determine the time needed for the boat to travel s = 80 ft .Express your answer to three significant figures and include the appropriate units. THE ANSWER IS NOT (1 second)
A particle moves along a straight line in such a manner that its displacement, at any instant, from a fixed point on its path is given by the equation:S = 1/10 (t3 + 6t2 – 4t)What displacement, velocity and acceleration will the particle attain after 10 sec.
An inverted conical container has a diameter of 39 inches and a depth of 22 inches. If water is flowing out of the vertex of the container at a rate of 39π in3/sec, how fast in in/sec is the depth of the water dropping when the height is 9 in? Express your answer in 3 decimal places.
A ball with mass m kg is thrown upward with initial velocity 23 m/s from the roof of a building 25 m high. Neglect air resistance. Use g=9.8 m/s2. Round your answers to one decimal place. (a) Find the maximum height above the ground that the ball reaches. (b) Assuming that the ball misses the building on the way down, find the time that it hits the ground.
10. As shown in the figure, a projectile is fired at an angle of 81° from the inclined plane. It lands at a distance 87 meters measured along the inclined plane. Determine its initial velocity (m/s). Round off to two decimal places.
A boat has an initial speed of 12 ft/s . It then increases its speed along a circular path of radius ρ = 80 ft at the rate of v˙=(1.7s)ft/s2, where s is in feet. Determine the time needed for the boat to travel s = 80 ft .Express your answer to three significant figures and include the appropriate units.
Determine the drag force (in kN) exerted on a high-rise building if the frontal dimension has a height of 80 m and a width of 25 m. The wind speed is 45 mi/hr. Let drag coefficient, CD = 1.4 and ρair = 1.2 kg/m3. Round off your answers to three (3) decimal places.
Speed measurement is made with a pitot tube by connecting a mercury manometer to a vertical pipeline through which water is transmitted. If the deviation in the manometer column is 15 cm, calculate the speed of the water in the pipe.?mercury = 13560 ???3, ?water = 1000 ???3 (figure in picture) #fluidmechanics
In an experiment to determine the viscosity of some oil, a ball is dropped into the oil. The position of the ball is given by the formula y(t) = A + Bt +C e−Dt, where y is given in m, and t is the time in s. At t = 0, y(0) = 0.05 m, the y component of the velocity is zero and the y component of the acceleration is ay(0)= 0.02 m/s2. As t approaches infinity, the y component of the velocity approaches vy(∞) = 0.55 m/s. Hint: You will likely want to answer the questions in a different order than presented. I am trying to figure this qeustion out, I need to find out what each of the variables in the fromula are. So far I have only found out what B is because I just toook the limit of the velocity function as t approaches zero, which gave me 0.55m/s. I am just stuck on how I would go about solving for the other variables in the question.