A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30 hours each per week. If the cost of electricity is 14.25 p per unit, determine the weekly cost of electricity to the business.

A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30 hours each per week. If the cost of electricity is 14.25 p per unit, determine the weekly cost of electricity to the business.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter29: Service-entrance Calculations

Section: Chapter Questions

Problem 7R: What is the calculated load for an electric range rated at 16 kW? (Table 220.55) Show calculations.

See similar textbooks

Related questions

Q: A 60 MVA, 3 phase, 11 kV synchronous generator is protected by the Merz-Price protection using 1000/…

Q: 8 The EMF induced in the secondary winding of a 50 Hz single-phase transformer having 500 turns on…

A: Given: The EMF induced in the secondary winding, E2=13.2 kV Frequency, f = 50 Hz Number of turns on…

Q: Find the attached file.

Q: The resistance and reactance of the primary winding of a 440/110 V single phase transformer are 4.4…

Q: An unbalanced 2-0, 1000 V, 50 Hz induction motor has unequal winding impedances, Z₂=3+j2.7 and Z=…

A: It is given that: Za=3+j2.7 ΩZb=7+j3 Ω2-ϕ,1000V,50 Hz IM3-ϕ,11kV system

Q: A shunt generator has a full load current of 196 amp. at 220 V. The stray losses are 720 watts and…

Q: In GSM, there are 8 separate time slots that makeup what is known as a “TDMA frame’’. Each GSM time…

A: Time Division Multiple Access or simply written as TDMA has a property that only within specified…

Q: 9.0 V 40 Ω www www 50 Ω Find the current I in the circuit shown in (Figure 2). Express your answer…

A: Given circuit:

Q: A power amplifier has an input power of 1.67W and an output power of 200W. What is the power gain in…

A: Given, A power amplifier has, Input power Pin=1.67 W. Output power P0=200 W.

Q: 4 Find the F.T. of the following Signals using differentiation prop. Ans FCW) - 2A (cosaw - Cosbu -…

A: We have to calculate fourier transform of following signal using differentiation property : we…

Q: Find Req

A: It is given that:

Q: (4) Find the power and energy consumed by the device below: Vct) = (0 cos 2πt] ct>o) + Filt) = 20…

Q: A copper-constantan thermocouple is connected to a copper-constantan extension wires and the…

Q: 13. If the percentage reactance of the system upto the fault point is 20% and base kVA is 10,000,…

A: Given, Percentage reactance of the system up to fault point, % X=20 % Base kVA rating is 10,000 kVA.

Q: QUESTION 9 What is the function of the analog-to-digital (A/D) converter circuit used in analog…

A: There are two types of converter: 1. DAC(digital to analog converter): It is used to convert digital…

Q: Find the stator winding voltage of a three-phase star connected 5500 V synchronous motor having…

A: Given- Line voltage VL=5500 V. 3-phase star connection. Synchronous reactance per phase =20 Ω. To…

Q: 10. In a step-down transformer, the number of turns in the secondary coil is 20 and the number of…

A: The given transformer is a step-down transformer. Thus the output secondary voltage will be lower…

Q: 10. When there is 12 mA of current through a 1.2 k resistor, the voltage across the resistor is A.…

A: Given data, Current flowing is given, i=12 mA Resistance, R=1.2 kΩ

Q: 3- For the below block diagram the forward transfer function is while the feedback ratio is R(S) G3…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A 650 m, 2-wire d.c. distributor fed from one end is loaded uniformly at the rateof 1-6 A/metre. The…

A: We have an 2-wire distributor fed from one end is loaded uniformly at rate of (i) 1.6 A/meter.…

Q: What is the simplified algebraic expression for the logic gate sho Doz X C Y OX+Y OX.Y OX.Y ΟΧΘΥ…

Q: Please show 7 detailed Solution on this Part, and how it become That answer.

Q: The RMS value of the signal shown in the figure is: f(t) 10 -10 0 1 23 4 5 6 t(sec)

A: We need to find out RMS Value of given signal

Q: 8- A system with imajenary valued poles is a- stable b- unstable c- critical stable 9- The transfer…

A: Given that , Poles are imaginary, then the stability of the system will be...... As we know that the…

Q: Determine whether or not each of the following signals is periodic. If a signal is periodic,…

Q: A CRO screen has 10 divisions on the horizontal scale. If a voltage signal 5 sin (314t +45°) is…

Q: hybrid parameter his (a) (c) O + V₁ ww R₁ (aR3 + R₂) R₂ + R₂ (1-α) R₂ R₂ + R3 ww network as shown.…

Q: List the eight degenerate two-level forms and show that they reduce to a single operation. Explain…

A: Two-Level Logic:- A logic design that only employs two logic gates between input and output is…

Q: 1. A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk C. Vrms d. Period e.…

A: Given a 70V AC source waveform (Vrms = 70V) Asked for the following Vpk Vpk-pk Vrms Period…

Q: Determine whether or not each of the following signals is periodic. If a signal is periodic,…

A: A periodic signal has a fixed pattern and it repeats again and again for a certain period of time.…

Q: R₁ = 60 om W 1 R₂=80 R=40 M R₂=B53 ww M R₂=40 R₁=100 Rg=652 W R8=662 M ww R7=80 R₁0=20

Q: d. Calculate the rise time (T.). e) Based on the value of damping ratio (C) the system is a)…

A: For the given question I have to solve part 'd' and 'e' : Transfer function of the control system…

Q: An AC motor takes 10 A when connected across a 240 V, 60 Hz source. Determine: the power factor of…

Q: Q8 a) b) Find and sketch o(t) = f(t)* f(t) for the pairs of functions shown as follow: B : (1) 1₁…

Q: Example 2: For the following circuit: 1. Find the total resistance 2. Find the current i 3. Find the…

A: Circuit is given as:

Q: Q1) Determine the corona characteristics of a 3-phase line 160 km long, conductor diameter 1.036 cm,…

Q: A 12 pole, 50 Hz, 3 phase induction motor has rotor resistance of 0.12 ohm and standstill reactance…

A: We have an 3-phase induction motor having, Poles (P) = 12 frequency (f) = 50 Hz Rotor resistance…

Q: A piezoelectric crystal has a thickness of 2.5 mm and a voltage sensitivity of 0.05 Vm/N. The…

A: Given a piezoelectric crystal has, Thickness, t = 2.5 mm. Voltage sensitivity, s=0.05 VmN. External…

Q: μA, and Vp = 10 V. a.4) At what anode voltage (VA) will each PUT in Figure 2-11 begin to conduct?…

Q: ASSESSMENT Matching Type. Match items from column A with column B by writing the letters on the…

A: The entire topic is based on Amplitude modulation of Analog Communication. Amplitude modulation is…

Q: Use the defining integral to find the Fourier transform of f(t) = A[u(t) - u(t-2)]. Use the defining…

Q: 9.0 V I 40 Ω ww 50 Ω

Q: What is the current through the resistor in the following circuit, if AV=20 V and R= 100 S2? A. 20…

A: Given circuit, where, Voltage, ∆V=20 V Resistance, R=100 Ω

Q: What semiconductor materials would be more suitable for a single junction pv device for ground or…

A: GIVEN: Graph between normalized absorbance and wavelength FIND: Based on data, suggest a…

Q: List the three basic elements of rack/slot-based addressing. O Type, rack, (word and) bit O Rack,…

A: The three basic elements of rack/slot-based addressing are Type, slot and word bit.

Q: The following data are obtained for 7.5 hp, 28A, 4-pole, 208V, 60Hz, Y-connected stator squirrel…

A: By using rotor bars to interact with the EMF of the stator, squirrel cage motors optimise…

Q: A capacitor has two dielectrics 2 mm and 3 mm thick. The relative permittivities of these…

A: A capacitor have two dielectric with 2 and 3 mm thick. so, x1 = 2 mm = 2 * 10-3 m x2 = 3 mm = 3 *…

Q: The graph of a network has 12 nodes and 7 independent loops. The number of branches of the graph is…

A: Given the graph of the network has, Total number of nodes, N=12. Total number of independent loops,…

Q: Determine the existence of Euler and/or Hamilton circuits/paths. If your answer is "yes", please…

A: The existence of Euler and/or Hamilton paths or circuits for the given two figures is given below…

Q: a) A 50 Hz, 4-pole turbogenerator rated 500 MVA, 22 kV has an inertia constant of 7.5 MJ/MVA. Find:…

A: Given- 4-Pole turbogenerator. P=4. G=500 MVA, 22 kV. Inertia constant H=7.5 MJ/MVA. To Find- (i)…

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

Please answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30 hours each per week. If the cost of electricity is 14.25 p per unit, determine the weekly cost of electricity to the business.
I have answer of this question kindly explain so that i can understand Kindly do it as soon as possible A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30 hours each per week. If the cost of electricity is 14.25 p per unit, determine the weekly cost of electricity to the business.
Kindly give explanation i already have answer A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30 hours each per week. If the cost of electricity is 14.25 p per unit, determine the weekly cost of electricity to the business.
I have answr of this question kindly explain so that i can understand A business uses two 3 kW fires for an average of 20 hours each per week, and six 150W lights for 30 hours each per week. If the cost of electricity is 14.25 p per unit, determine the weekly cost of electricity to the business.
The cost of running a 5000W oven is $141 per year and at the rate of 11.3 cents/kwh, Calculate the total electrical energy consumed by the oven every year Calculate the time for which the oven is operated every day.
An electrical supply uses the following wattages: 4,212 watts, 4,226 watts, 4,296 watts, 3,427 watts, 914 watts, 1,428 watts, and 4,293 watts. What is the average wattage used? Round the answer to the nearer hundredth.
Suppose that the electricity consumption in your home last month was 354 kWh. In your contract with the electricity company, you agreed to pay 11.3 cents per kWh. If you also have to pay a regular fixed charge of $15.63, determine the total amount due on your electricity bill.
A power plant has 2-100MW units running for 7250 hours in a year and 1-50MW running for 2500 hours in a year. The station output energy is 1,200x103 MWHR. Calculate the plant utilization factor.
A house has 5 fans of 70 W each that operate for 16 hours a day and one washing machine of 2000 W that operates for 1 hour per day in the month of june. What is the energy consumption of the house in the month of june ?
Calculate the number of kilowatt-hours (kW-hrs) generated in three weeks by a 1900-Watt propane generator that is used for 2 hours each day. Group of answer choices 7.98 kW-hrs 79.8 kW-hrs 798 kW-hrs 0.798 kW-hrs
4.1. Using the “Watt” method, calculate and assess the illumination in a 40 m2 classroom, illuminated by 6 incandescent lamps (each lamp is 200 Wt).
Please assume a price for electric energy of $0.15/kWh. If washer A costs $750 and uses 200 kWh of energy per year to operate, and washer B costs $300 and uses 800 kWh of electricity per year to operate, which of the two washers costs less to own and operate over a period of ten years?