(a) Calculate the rate of heat transfer by radiation from a car radiator at 110°C into a 50.0ºC environment, if the radiator has an emissivity of 0.750 and a 1.20-m2 surface area. (b) Is this a significant fraction of the heat transfer by an automobile engine? To answer this, assume a horsepower of 200 hp (1.5 kW) and the efficiency of automobile engines as 25%.

(a) Calculate the rate of heat transfer by radiation from a car radiator at 110°C into a 50.0ºC environment, if the radiator has an emissivity of 0.750 and a 1.20-m2 surface area. (b) Is this a significant fraction of the heat transfer by an automobile engine? To answer this, assume a horsepower of 200 hp (1.5 kW) and the efficiency of automobile engines as 25%.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter1: Temperature And Heat

Section: Chapter Questions

Problem 119AP: For the human body, what is the rate of heat transfer by conduction through the body's tissue with...

See similar textbooks

Similar questions

For a temperature increase of 10 at constant volume, what is the heat absorbed by (a) 3.0 mol of a dilute monatomic gas; (b) 0.50 mol of a dilute diatomic gas; and (c) 15 mol of a dilute polyatomic gas?
An aluminum rod 0.500 m in length and with a cross-sectional area of 2.50 cm2 is inserted into a thermally insulated vessel containing liquid helium at 4.20 K. The rod is initially at 300 K. (a) If one-half of the rod is inserted into the helium, how many liters of helium boil off by the time the inserted half cools to 4.20 K? Assume the upper half does not yet cool. (b) If the circular surface of the upper end of the rod is maintained at 300 K, what is the approximate boil-off rate of liquid helium in liters per second after the lower half has reached 4.20 K? (Aluminum has thermal conductivity of 3 100 W/m K at 4.20 K; ignore its temperature variation. The density of liquid helium is 125 kg/m3.)
A thermodynamic system undergoes a process in which its internal energy decreases by 500 J. Over the same time interval, 220 J of work is done on the system. Find the energy transferred from it by heat.
Many decisions are made on the basis of the payback period: the time it will take through savings to equal the capital cost of an investment. Acceptable payback times depend upon the business or philosophy one has. For some industries, a payback period is as small as 2 yeas) Suppose you wish to install the extra insulation in the preceding problem. If energy cost $1.00 per million joules and the insulation was $4.00 per square meter, then calculate the simple payback time. Take the average T for the 120-day heating season to be 15.0 .
Consider the latent heat of fusion and the latent heat of vaporization for H2O, 3.33 105 J/kg and 2.256 106 J/kg, respectively. How much heat is needed to a. melt 2.00 kg of ice and b. vaporize 2.00 kg of water? Assume the temperatures of the ice and steam are at the melting point and vaporization point, respectively. (a). UsingEq21.9, Q = mLF = (2.00 kg) (3.33l05 J/kg) = 6.66105 J (b).UsingEq21.10. Q = mLV = (2.00kg) (2.256106 J/kg) = 14.51106 J
To help prevent frost damage, 4.00 kg of water at 0 is sprayed onto a fruit tree. (a) How much heat transfer occurs as the water freezes? (b) How much would the temperature of the 200-kg tree decrease if this amount of heat transferred from the tree? Take the specific heat to be 3.35k J/kg. , and assume that no phase change occurs in the tree.
An infrared heater for a sauna has a surface area of 0.050 m2 and an emissivity of 0.84. What temperature must it run at if the required power is 360 W? Neglect the temperature of the environment.
Check Your Understanding How does the rate of heat transfer by conduction change when all spatial dimensions are doubled?
A firewalker runs across a bed of hot coals without sustaining burns. Calculate the heat transferred by conduction into the sole of one foot of a firewalker given that the bottom of the foot is a 3.00-mm-thick callus with a conductivity at the low end of the range for wood and its density is 300 kg/m3. The area of contact is 25.0 cm2 the temperature of the coals is 700 , and the time in contact is 1.00 s. Ignore the evaporative cooling of sweat.
If you place 0 ice into 0 water in an insulated container, what will the net result be? Will there be less ice and more liquid water, or more ice and less liquid water, or will the amounts stay the same?
A 50-m-long section of a steam pipe whose outer diameteris 10 cm passes through an open space at 15°C. The averagetemperature of the outer surface of the pipe is measured to be150°C. If the combined heat transfer coefficient on the outer surfaceof the pipe is 20 W/m2·K, determine (a) the rate of heat lossfrom the steam pipe; (b) the annual cost of this energy lost if steamis generated in a natural gas furnace that has an efficiency of 75percent and the price of natural gas is $0.52/therm (1 therm =105,500 kJ); and (c) the thickness of fiberglass insulation(k = 0.035 W/m·K) needed in order to save 90 percent of the heatlost. Assume the pipe temperature to remain constant at 150°C.
Solar radiation is incident on a 5 m2 solar absorberplate surface at a rate of 800 W/m2. Ninety-three percent ofthe solar radiation is absorbed by the absorber plate, whilethe remaining 7 percent is reflected away. The solar absorberplate has a surface temperature of 40°C with an emissivityof 0.9 that experiences radiation exchange with the surroundingtemperature of -5°C. In addition, convective heat transferoccurs between the absorber plate surface and the ambientair of 20°C with a convection heat transfer coefficient of7 W/m2∙K. Determine the efficiency of the solar absorber,which is defined as the ratio of the usable heat collected bythe absorber to the incident solar radiation on the absorber.