A canal 6 m deep runs through a soil having C = 18 kN/m², o = 10°, e = 0.8 and G = 2.72. The angle of slope of canal bank is 45°. If %3D sudden drawdown takes place upto bed level of the canal, what will be factor of safety? For, O, = 10°, stability number = 0.108; = 4.89°, stability number = 0.137

A canal 6 m deep runs through a soil having C = 18 kN/m², o = 10°, e = 0.8 and G = 2.72. The angle of slope of canal bank is 45°. If %3D sudden drawdown takes place upto bed level of the canal, what will be factor of safety? For, O, = 10°, stability number = 0.108; = 4.89°, stability number = 0.137

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter9: In Situ Stresses

Section: Chapter Questions

Problem 9.10P

See similar textbooks

Similar questions

A trapezoidal channel with sidewalls of 60 degrees has a bottom width of 4 m at total depth of 5 m and has a constant bedslope of 0.005. A flow of 40 m3/s fills the channel to a depth of 3.5 m, the maximum for normal operation. Downstream a topographic constriction requires that the channel be rectangular with a maximum width of 4 m. Assuming no changes in materials and no energy losses, estimate the depth in the downstream rectangular section and recommend a total depth for the rectangular channel.
The velocity of a trapezoidal canal with a bottom width of 3.2 m and side slopes of 3H:2V is 2.2 m/s. Calculate the following if the flow depth is 2.18 m and the channel bed slope is 5m per 3 kilometers. a. Flow rate, Q b. Roughness coefficient, n c. Shearing stress at the boundary of the canal, τ
A smooth transition section connects two open channels of the same width, as shown in Figure P10.15. The water depth decreases so that the ratio of the downstream to upstream depths Y2/Y1 = 0.5. If the upstream Froude number F1 = 0.35, determine the downstream Froude number F2, and the ratio h/Y1.
A trapezoidal channel with 3.0 bottom width and 1:1 side slope carries a discharge of 10?3 ? at a slope of 12cm/km. A hydraulic jump is formed in the channel with an initial depth of 0.6 m. Calculate the momentum function, the critical depth, and the conjugate depth.
A canal of trapezoidal section has bed width of 8 m and bed slope of 1 in 4000. If the depth of flow is 2.4 m and side slopes of the channel are 1 horizontal to 3 vertical, determine the average flow velocity and the discharge carried by the channel. Also compute the average shear stress at the channel boundary. Take value of Chezy’s Constant = 50
An unsymmetrical trapezoidal channel with one side inclined from horizontal by 35 degree and the other inclined from vertical by 40degree is to be designed to carry a 2.0 cubic meters per second discharge. Determine the dimensions of the channel for most efficient section if roughness coefficient is 0.030 and average longitudinal slope is 0.05. Draw the cross section of the open channel considering the freeboard height. Use Chezy and Kutter’s C formula.
Determine the critical depth for best hydraulic cross-section of a trapezoidal channel that carries a flow of 6.5 m³/ s. Note: For Best Hydraulic Cross-Section; T = 2 z where T – top width and z-side length, and R = y/2.
If the water depth immediately upstream or downstream of a frictionless vertical moving cover in a rectangular channel is 0.3 m and the flow velocity is 6 m/s, what is the opposite depth in meters?
A concrete gravity dam with a trapezoidal section is holding water as shown in the figure. A distance of 15 meters from the toe, a drain is located. The drain has a pressure due to uplift of zero and increasing uniformly to full hydrostatic at the heel. Upstream face 1H:5V, while downstream face is inclined 1H:2V. Which of the ff nearly gives the maximum foundation pressure on the base of the dam in kilopascal ? Assume 23.54 kN/m3 for the unit weight of concrete. a. 3114 b. 1095 c. 4115 d. 964 e. 680
A trapezoidal channel has a bed width of 5 m, a side slope of 2.5:1 (H:V) and a flow depth of 3 m. The velocity = 1.2 m/s and the velocity head = 0.073 m i. Determine the flow area (m²) of this channel. ii. Determine the wetted perimeter (m) of this channel. iii. Determine the hydraulic radius (m) of this channel. iv. Determine the width (m) of flow across the surface of this channel. v. Determine the freeboard (mm) of this channel. vi. Determine the total channel depth (m). vii. Determine the discharge (m³/s) of this channel. viii. Determine the Froude number of the flow. ix. Comment on the state of flow.…
A trapezoidal channel has a bed width of 5 m, a side slope of 2.5:1 (H:V) and a flow depth of 3 m. The velocity = 1.2 m/s and the velocity head = 0.073 m i. Determine the flow area (m²) of this channel. ii. Determine the wetted perimeter (m) of this channel. iii. Determine the hydraulic radius (m) of this channel. iv. Determine the width (m) of flow across the surface of this channel. v. Determine the freeboard (mm) of this channel. vi. Determine the total channel depth (m). vii. Determine the discharge (m³/s) of this channel. viii. Determine the Froude number of the flow. ix. Comment on the state of flow.…
The bottom width of a trapezoidal canal is 2.5m and its sides are both inclined at 60 degree with the horizontal. Water flows at a depth of 3m. Calculate the discharge of the slope of the canal is 0.0008 with a coefficient of roughness n=0.03