A cannenball is launched vertically upuards at go mls then it retumsto the ground ater somete fime with a=9.81 m?. Fired the maximumheight, the Hme it takes to retum towhich it retums to the goound-Answer- 127.42 m, 10.19 secons; -50 m/sProvide lompete sclutionscomplete unit and soution piease thenkthe ground, and the velocity atwitth derivartionOf Eormulas

Answered: Image /qna-images/answer/7d3a91be-aa4e-416f-89e9-d5b1ab5d8353.jpg

A cannonball is launched vertically upuards at g0 mls then it retums to the ground after someh fime with a:9.81 m/?. Fird the maximum height, the timme it takes to retum to the qraund, and the velocity at which it returms to the ground- Answer- 127.42 n, 10.19 seconds, - 50 m/s Provide lompete sautions witth derivertion OF pormula, Complete unit and soution please thenk you-

A cannonball is launched vertically upuards at g0 mls then it retums to the ground after someh fime with a:9.81 m/?. Fird the maximum height, the timme it takes to retum to the qraund, and the velocity at which it returms to the ground- Answer- 127.42 n, 10.19 seconds, - 50 m/s Provide lompete sautions witth derivertion OF pormula, Complete unit and soution please thenk you-

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Flood in irrigation areasto block and return the water to the river or wateras below to guide your bedThe flat cover system provided is preferred. Of coverits weight is 871 kg. Square section cover, coverhinged 1 m above center (a = 0.25 m)and b = 150 cm. Cover vertically 4 °has angle. According to the givenWhat is the maximum water head (h) for not openingshould be up. (ρ water = 1000 kg / m3)
A wheel tractor has a 200HP engine.If the weight of the wheel tractor is 30 tons and the weight on the drivingwheels is 50% of this weight, and it is operating at an altitute of 1000m above sea level, at an average temperature of 25 degree celcius, and at an average speed of 12km/hr. What is the maximum available rimpull if thecoefficient of traction is 0.25?. Take rimpull efficiency as 85%
A cylindrical tank is being filled with water flowing with constant velocity V1 through a tap (Tap 1) that has an opening of diameter D1. The tank is initially empty and contains a tap (Tap 2) placed H1 m above the bottom of the tank that drains waterat a velocity of ? = √2?h. Assuming flow through Tap 2 starts the moment Tank 1 2height reaches H1 m, write the differential equation governing the change of water level inside the tank with time (?h =? );??i) Before water level reaches H1.ii) After water level reaches H1 up until the tank is full.Do NOT attempt to solve the differential equations!Just drive the differential equations and write the boundaries of the definite integrals.
A wind turbine generator system having a diameter of 82.5 m produces 1.5 MW at a wind speed of 12 m/s. Determine the diameter of blade necessary to produce 10 MW of power assuming the efficiency is the same for both designs and p = 1.21 kg/m3 for air.
To avoid the bulky tower and impeller and generator inthe HAWT of the chapter-opener photo, we could insteadbuild a number of Darrieus turbines of height 4 m anddiameter 3 m. (a) How many of these would we need tomatch the HAWT’s 100 kW output for 15 m/s wind speedand maximum power? (b) How fast would they rotate?Assume the area swept out by a Darrieus turbine is twothirdsthe height times the diameter.
A reducing elbow is used to deflect water flowrate at a rate of 1920 g/s in a horizontal pipe downward by an angle theta = 43 from the flow of direction while accelerating it. The elbow discharges water into the atmosphere. The diameter of the elbow at the inlet is 6.5 cm and at the exit is 1.5cm. The elevation difference between the centers of the exit and the inlet is 22cm . The mass of the elbow and the water is 61.5 kg. Determine the anchoring force needed to hold the elbow in place
The pipe bend shown is in a horizontal plane. Oil with a specific gravity of 0.86 enters the reducing bend at section A with a velocity of 3.2 m/s and a pressure of 150 kPa. Determine(a) Thevelocity(m/s)atsectionB.(b) Thepressure(kPa)atpointB.(c) FP (x-direction),(d) FP (y-direction),(e) The magnitude and direction of FRX of the force required to hold the bend in place.(f) The magnitude and direction of FRY of the force required to hold the bend in place.Forces are to be expressed in Newtons.
Asnwer: P = 673.279 N
Indicate for which types of systems the theoretical results obtained by the kinetic theory for the distribution of speeds can be applied. explain it.
The hydroelectric facility that has been proposed will consist of a turbine with anefficiency of 89.2%. The facility will be located at a vertical depth of 14.8 m belowthe riverbed. The river flows with the following properties:o hydraulic diameter of 6.25 mo slope of 0.031o wetted perimeter of 12.2 mo a Chezy coefficient of 4.85 m0-5s1.Thedensity of the river water is 998.2 kg m3, and the acceleration due to gravity is9.81 m s2.Assuming that the turbine operates for 94.0% of the time and one year isapproximately 3.1536 x 107s, calculate:i. the mass flow rate of the river(5 marks)ii. the maximum energy that could be extracted annually from the river flow.
p60,#11 with illustration and explanation
A vertical cylindrical container contains 5840 gallons of gasoline and is 1.53 m in radius. Due to evaporation within the tank, the pressure on the top of the fluid is 2.5 times normal atmospheric pressure. The density of gasoline is 737 kg/m3. a. What is the pressure at the bottom of the tank? b. If a nozzle at the bottom of the tank is used to let fuel out, with what velocity would the gasoline exit the hole? c. If a nozzle at the bottom of the tank is used to let fuel out, what volume flow rate will result if the diameter of the hole is 1.2 cm? d. At what initial rate will the height of the fuel level in the tank drop as fuel is removed?